1984 Dodge Power Ram Prospector 360v8 Swb, 4x4, Automatic, Restored on 2040-cars

Auto blog

Chrysler says its 8-speed transmissions will save 700 million gallons

Chrysler Group's TorqueFlite eight-speed transmission could be earning some serious green bragging rights if the company's projections are correct. The recently widely proliferated automatic gearbox, which is now in more than a million vehicles around the world, is poised to save drivers an estimated 700+ million gallons of fuel over the vehicles' lifetimes (an expected cost savings of $2.5 billion). In addition, Chrysler expects a reduction in CO2 emissions by more than six million metric tons. According to Chrysler, and depending on the vehicle, the TorqueFlite can improve fuel economy. The TorqueFlite autobox features particularly close ratios from fifth to eighth gear (see the press release below for the specific numbers), and uses low-viscosity fluid that doesn't need to be replaced. Transmission software adapts to the driving situation to optimize efficiency based on driver behavior, temperature, grade, stability control, and longitudinal and lateral acceleration. The TorqueFlite is capable of handling a variety of duties. As evidenced by the wide range of vehicles Chrysler Group has seen fit to equip with the eight-speed transmission, the TorqueFlite is capable of handling a variety of duties. Since its 2012 introduction, the TorqueFlite has gone from performing cog-swapping duties in Dodge Charger and Chrysler 300 models equipped with the 3.6-liter Pentastar V6 to changing gears in vehicles such as the Pentastar- and Hemi-powered Dodge Durango, Jeep Grand Cherokee and even the Ram 1500 EcoDiesel. For the 2015 model year, the eight-speed is finding its way into even more vehicles with the addition of a third version. In addition to the American-made TorqueFlite 845RE and 8HP70, the new 8HP90 will be manufactured in Saarbrucken, Germany. The 8HP90 is designed for higher torque loads, making it ideal for high-performance vehicles like the 2015 Dodge Challenger SRT Hellcat. The already-in-use 8HP70 will expand its duties to be used in 2015 Hemi models such as the Dodge Charger, Challenger, and Challenger SRT8. You can see the list of those benchmarks in Chrysler's press release below.

Dodge Charger Hellcat makes 1,032 hp with Hennessey help

Sometimes you just want four doors. Earlier this week we brought you Hennessey's riff on the Dodge Challenger Hellcat. Now comes the Charger. Much like its two-door sibling, the Charger gets boosted to as much as 1,032 hp and 987 lb-ft of torque (at the crank) thanks to the addition of a twin-turbocharging setup that works with the factory supercharger. The turbo headers and downpipes are stainless steel, and there is a high-flow air-to-water intercooler and dual-turbo waste gates. Hennessey also beefs up the fuel injectors, fuel pump, and the rest of the fuel system. The engine management system and chassis are recalibrated to accommodate all of this. You also get numbered plaques signed by John Hennessey, the boss of the Texas tuning outfit, and the technician who does your build. Hennessey's additions result in zero-to-60 mph sprints in 2.7 seconds, and the big sedan can run the quarter mile in 9.9 seconds at 142 mph. Like the Challenger, the Charger has the same disclaimer: the lofty horsepower figure comes from an engine dyno, and it will be a 15-to 20-percent lower at the rear wheels. Related Video: Image Credit: Hennessey Performance Dodge Performance Sedan Hennessey dodge charger hellcat

Cold start comparison: 2020 Alfa Romeo Giulia Quadrifoglio vs. 2013 Dodge Challenger SRT8

The 2020 Alfa Romeo Giulia Quadrifoglio is a five-seat, compact luxury sport sedan packing 505 horsepower thanks to a 2.9-liter twin-turbocharged V6. My personal 2013 Dodge Challenger SRT8 392 is ... well ... not. It's a full-sized muscle coupe whose iron-block 6.4-liter V8 makes 470 hp in the very traditional way: it's freakin' huge, like everything else about the car.  On paper, these two have nothing in common beyond the fact that they were built by the same multi-national manufacturing entity.  But if paper were the be-all and end-all of automotive rankings, everybody would buy the same car. And we don't, especially as enthusiasts. Whether it's looks or tuning or vague "intangibles" or something as simple as the way a car sounds, we often put a priority on the things that trigger our emotions rather than setting out to simply buy whatever the "best" car is at that particular moment.  So, what do these two have in common? They both sound really, really good. Like looks, sounds are subjective. While a rubric most assuredly exists in the world of marketing (attraction is as much a science as any other human response), we have no way of objectively scoring the beauty of either of these cars, and the same applies to the qualities of the sound waves being emitted through their tail pipes.  But we can measure how loud they are. In fact, there's even an app for that. Dozens, as it turns out. So, I picked one at random that recorded peak loudness levels, and set off to conduct an entirely pointless and only vaguely scientific experiment with the two cars that happened to be in my garage at the same time.  For the test, I opened up a window and cracked the garage door (so as not to inflict carbon monoxide poisoning upon myself in the name of discovery), and then placed my phone on a tripod behind the center of each car's trunk lid. I fired each one up and let the app do the rest. I then placed my GoPro on top of the trunk for each test so that I could review the video afterward for any anomalies.  I started with the Challenger. The 6.4-liter Hemi under the hood of this big coupe is essentially the same lump found under the hood of quite a few Ram pickups, and it has the accessories to prove it. Its starter is loud and distinctive. Almost as loud, it turns out, as the exhaust itself. As its loud pew-pew faded behind the V8's barking cold start, we recorded a peak of 83.7 decibels. In the app's judgment, that's roughly the equivalent of a busy street.