07, Dodge, Ram, Rbp, Fuel Hostage, 20x12, Rough Country, Rcx, Lifted, Lift Kit on 2040-cars

Auto blog

Chop the top of your new Dodge Viper for $35,000

We have good news, and we have bad news. First, the good: It's now possible to get a brand-new Dodge Viper roadster, which is nice, considering we're in the dead of summer and many of us like wind-in-the-hair motoring. Now, the bad: This is not a factory option from the automaker, instead coming courtesy of an aftermarket company called Prefix Performance, and that means it's going to cost you some serious coin.
Called Medusa, this drop-top Viper was created without the knowledge or consent of Dodge, but that's probably fine because Prefix works with the automaker already for the final preparation of the American supercar, including paint. According to the company, the current, fifth-gen Viper was built with a convertible version in mind, so no chassis strengthening is required. From the looks of the somewhat grainy photos available, the conversion appears of very high quality.
Want one? Well, that means you're going to need to procure a Viper - Prefix has 10 units ready for transformation as it stands - and that's going to cost at the very least $102,485. Then, you'll need to write a check for an additional $35,000 for Prefix to surgically remove the car's roof. Thing is, for that kind of cash, a prospective owner could buy, among other very nice options, a Viper hardtop and a loaded Miata, or a Corvette Stingray convertible and several pockets full of change. Or, perhaps a new Viper hardtop and a used, first-gen Viper convertible?

Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut

Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.

Dodge Charger Hellcat hitting 60 in 2.9 seconds on drag radials?

The Dodge boys and their cousins from SRT have shoehorned the same 707-horsepower, 6.2-liter supercharged V8 into both the Dodge Challenger and Charger. The former being a two-door, it's lighter than the latter four-door sedan. So it would stand to reason that the Dodge Challenger SRT Hellcat would be the quicker of the two, right?
Only that's not necessarily proving to be the case. On stock rubber, yes, the coupe beats the sedan: Dodge quotes a 0-60 time of 3.7 seconds for the Charger SRT Hellcat and 3.5 for the Challenger. Same gap across the quarter-mile: 11 seconds flat for the Charger versus 10.8 seconds for the Challenger. But according to recent reports, the story changes when you put both on drag radials.
While visiting Chrysler HQ in Auburn Hills, MI, TorqueNews.com caught wind of performance figures for the Charger Hellcat on drag tires: 0-60 in a mind-blowing 2.9 seconds and a quarter-mile in just 10.7. The latter figure just barely pips the Hellcat-powered Challenger's NHRA-certified figure of 10.8, making the Charger not only the fastest sedan on the market, but also the fastest muscle car. What isn't immediately clear, however, is whether the drag radials in question have any tread on them and are street-legal, or if they're pure slicks confined to a closed strip.