1963 Dodge Polara on 2040-cars

Auto blog

Chrysler extends fuel tank warranties on LX cars, NHTSA ends probe

The National Highway Traffic Safety Administration has ended its investigation of 153,817, 5.7-liter and 6.1-liter Hemi V8-powered 2006 Chrysler 300, Dodge Charger and Dodge Magnum models after reports of stalling. Chrysler has responded by granting a lifetime warranty on the fuel tanks for these vehicles.
NHTSA received 299 reports of engines stalling while the models were stopped or driving at low speeds, and began an investigation. The government agency found that the control valve shutoff float in the V8s' 19-gallon fuel tank could malfunction if the fuel had too high of an ethanol content. In many cases, the valve would break in the open position, allowing the tank to be overfilled, which would then cause the cars to stall. However, there were no accidents reported, and the vehicles could be restarted immediately.
There will not be a recall on these vehicles because, "the condition represents a low risk to motor vehicle safety and is adequately addressed by Chrysler's extended warranty," NHTSA said to The Detroit News.

Mopar unveils Dodge Challenger Drag Pak [w/video]

Dodge is going drag racing, and it's doing it with an all-new version of the Challenger for NHRA's Sportsman class. FCA's Mopar parts and performance arm announced the new Challenger Drag Pak Friday, showing off a version with a 354-cubic-inch (that's a 5.8-liter, by the way), supercharged V8 and a 426-ci (7.0-liter), naturally aspirated V8 – both Hemis, of course – that can get the big coupes through the quarter-mile in "the eight-second range." While the two engines deliver similar performance, at their base, they're quite a bit different. The supercharged model uses a cast-iron block, while the 426 has aluminum for both the block and head. That said, both models get customized engine calibrations, and are mated to unique, race-spec automatic transmissions. But drag racing is about far more than just outright power. Mopar significantly updated the four-link rear suspension, adding a four-inch rear axle from Strange Engineering, along with an aluminum, nine-inch third member, while the rear-axle housing has been strengthened in general. Both the rear shocks and front struts can be adjusted for rebound and compression, too. Lightweight 15-inch wheels, meanwhile, are shod in super-sticky Hoosier drag radials, with nine inches of tread in back and 4.5 inches in front. The new Challenger Drag Pak should run the quarter-mile in "the eight-second range." In the cabin, there's an NHRA-spec roll cage, a Racepak gauge cluster, and a handsome pair of Sparco racing seats. Outside, supercharged models get blue decals, while naturally aspirated varieties get black stickers, although there's more to the new Challenger dragster's exterior than just its decals. Mopar tweaked the big-scoop hood, promising it's easier to get up to check on the engine, and the designers also added trailer tie-down straps in both the front and rear. While the dragster was the big news today, Mopar officials also announced the two enhanced Scat Pack kits for both the Dodge Charger and Challenger R/T. The 5.7-liter Hemi models gain an extra 56 horsepower and 30 pound-feet of torque in the Scat Pack 2 thanks to a new cam, valve springs, pushrods, and gaskets. The Scat Pack 3, meanwhile, adds 75 hp and 44 lb-ft, on top of the gains from the lower packages. That should be perfect for drivers who wish to snort in the face of their SRT 392-driving friends. The third stage adds a ported cylinder heads, as well as high-flow manifolds and catalysts.

2019 Dodge Challenger R/T Scat Pack 1320 gets race-focused upgrades

The Dodge Challenger SRT Demon is one hell of a machine. It's a single-minded 840-horsepower jackhammer, meant solely to burn rubber and win drag races. It's packed with all sorts of goodies like a transbrake, line lock, and a torque reserve mode. Still, it was an extremely limited-production model. It's also sold out. What do you do if you want some fun on the drag strip and you can't find our don't need the power of a Demon? Buy the new 2019 Dodge Challenger R/T Scat Pack 1320. You can really think of the Scat Pack 1320 as a Demon without the wide bodywork and the supercharged 6.2-liter V8. Instead, you'll find Dodge's tried-and-true 6.4-liter naturally-aspirated V8 under the hood making 485 horsepower and 475 pound-feet of torque. The TorqueFlite 8HP70 eight-speed automatic is the only available transmission. It's required equipment to use the TransBrake and Torque Reserve system. All-four wheels are wrapped in Nexen SUR4G Drag Spec 275/40R20 street-legal drag radial tires. The 1320 names comes from the length of a quarter-mile drag strip — 1,320 feet. The Scat Pack 1320 can run the quarter-mile in 11.7 seconds at 115 mph and hits 60 mph in just 3.8 seconds. Of course, that's in its lightest configuration. Like the Demon, the Scat Pack 1320 only comes with a driver's seat. The passenger and rear seats are each $1 options. The goal was to give grassroots racers a bare-bones performance car at a relatively reasonable price. You don't need passengers if you're only racing. You also shave 114 pounds from the car's curb weight. Other upgrades include an SRT-tuned suspension, a 3.09 rear axle ratio, 41-spline rear half-shafts, 20 x 9.5-inch aluminum-forged wheels with knurled bead seats (to keep the tires from slipping on the rim) and upgraded Brembo brakes with four-piston calipers. The Challenger R/T Scat Pack 1320 joins a number of other upgraded 2019 Dodge models. That includes the Challenger SRT Hellcat Redeye and the upgraded 2019 Charger SRT Hellcat. The Scat Pack 1320 adds $3,995 to the Challenger R/T Scat Pack's base MSRP. That's not the whole story. Since the automatic is mandatory, you need to tack on another $1,595. Add in destination, and the Scat Pack 1320 will set you back at least $45,980. Cars will hit dealer lots early next year. Related Video: This content is hosted by a third party. To view it, please update your privacy preferences. Manage Settings.