2005 Dodge Ram Srt10 on 2040-cars

Auto blog

Watch these Dodge Demons explode on a Texas drag strip

The Dodge Challenger SRT Demon is extremely quick. It can hit 60 mph from a dead stop in less time than it takes to read this sentence thanks to its supercharged 6.2-liter V8. That engine makes up to 840 horsepower and 770 pound-feet of torque, depending on what octane is running through the fuel lines. That's a ton of power going solely to the rear wheels. So much so that Dodge developed a number of features and a new set of tires specifically for the car. In our time with the Demon, the car took abuse run after run on a drag strip without skipping a beat, but it seems some actual owners aren't quite so lucky. Just take a look at what happened to a few of these cars. You can see the whole car shake and jitter right as the whole rear explodes in front of the tree. It seems the initial shock from the launch — the most taxing bit of any drag run — is what kills the differentials. Catastrophic failure is rarely pretty, but it is neat to see the whole thing occur in slow motion. Three more cars — four stock and one modified in total — suffered similar fates. Not a great look for Dodge or SRT. According to The Drive, a private drag event in Texas drew a number of Demon owners all trying to beat NHRA NHRA Top Fuel racer Leah Pritchett's time in her personal Dodge Demon — 42 stock Demons attended along with five modified cars. While no one managed to match her 9.65-second quarter-mile run, a few owners did dip below 10 seconds. Now, there are a few of caveats we must address. First, with any modified car, you run the risk of breaking something, even with a car that's set up from stock specifically for drag strips. Even a set of tires like the Mickey Thompsons shown in the video above can have an effect on driveline components. Horsepower may be king, but it's torque that's the rear killer. All that torque sends a shock through the car. Adding even more with aftermarket parts increases the risk of something failing. The modified car was apparently pushing out about 1,000 horsepower. That said, four of the five vehicles were stock, so any extra power or torque should theoretically be a non-factor. The drag strip's surface was maintained by a company called Mass Traction. FCA used Mass Traction during the Demon's development, so that too should be a non-factor in the part's failure. It's unclear what exactly caused the failures, though The Drive reports that FCA officials are investigating the matter. Related Video: This content is hosted by a third party.

Jay Leno drives the Demon-powered SpeedKore carbon fiber Dodge Charger

Jay Leno drives all sorts of wild vehicles on his TV and YouTube series "Jay Leno's Garage," from concept cars to classics. Although many of the vehicles are museum quality, they don't all come through in straight by-the-book factory form, as Leno often likes to highlight the creative and insane builds from premium speciality aftermarket shops. One of his favorites is SpeedKore, which recently dropped by with its carbon-fiber-bodied 1970 Dodge Charger Evolution. After cementing itself as one of the best builds of the year at SEMA 2018, the high-performance Charger paid Leno a visit to show off its immaculately assembled blend of classic and modern Dodge. It's not the first time SpeedKore has stopped by, as they've previously shot videos together of the 1967 Chevrolet Camaro, the 2016 Ford Mustang Shelby GT350R, and the 1970 Dodge Charger Tantrum. The Charger featured here wears its Evolution name because it is an updated take on the Tantrum build (which had 1,650 horsepower, by the way), but the two are quite different. The Charger Evolution uses numerous parts from Dodge's recent superstars, the Challenger SRT Hellcat and the Challenger SRT Demon. In fact, it's one of the only ways in the world to drive a Demon engine with a manual transmission. Under the hood is the 6.2L Supercharged Hemi V8 from a Demon pre-production car, and SpeedKore has tuned it up to 966 horsepower. It pairs with a Tremec M6 6060 six-speed transmission from the Hellcat. At full bore, the whine of the supercharger paired with the grumble from the custom stainless steel SpeedKore exhaust headers makes for a thrilling, if not unharmonized, battle cry. Whereas some restomods have cut corners, shoddy build quality, or imperfect fittings, Leno notes that SpeedKore's work is top-notch, despite the entire exterior body and many pieces of the interior being fully replaced with glossy clear-coated exposed carbon fiber. According to SpeedKore Vice President Dave Salvaggio, the Charger weighs about 3,400 pounds. Check out the full video above or read full details from our time with the car at SEMA. And as a bonus, Autoblog photographer Drew Phillips recently got to spend a day shooting the Charger. His gallery of photos appears below. Speedkore 1970 Dodge Charger View 53 Photos

Stellantis and Foxconn's new joint venture will focus on connectivity

MILAN — Carmaker Stellantis and TaiwanÂ’s Foxconn announced plans to develop a jointly operated automotive supplier focusing on technology to make vehicles more connected, including artificial intelligence-based applications and 5G communications. Stellantis CEO Carlos Tavares said the services that will be developed through the tie-up “will mark the next great evolution of our industry,” alongside fully electrified and hybrid powertrains. The deal brings together Stellantis, the worldÂ’s 4th-largest automaker formed this year by the merger of Fiat Chrysler Automobiles and PSA Peugeot, and Foxconn, a major supplier of iPhones. The companies said the venture would focus on such services as infotainment, the integration of telecommunications and computer systems, artificial intelligence-based applications, 5G communications, e-commerce channels and smart cockpit integration. The companies announced a non-binding memorandum of understanding to form a 50-50 joint venture called Mobile Drive, which will be based in the Netherlands and function as an automotive supplier also to other carmakers. The new venture will combine advanced consumer electronics, Human-Machine Interfaces (HMI) to create new services “that will exceed customer expectations,” the companies said in a release. “Customers today and, in the future, demand and expect ever-increasing software-driven and creative solutions to connect the drivers and passengers with the vehicle inside and out,Â’Â’ Foxconn Chairman Young Liu. Alfa Romeo Chrysler Dodge Ferrari Fiat Jeep RAM Citroen Opel Peugeot 5g Connectivity Stellantis Foxconn