1951 Dodge B Pick-up Truck Flat Head Six Five Window Pilot House Restoration on 2040-cars

Auto blog

Turn up the volume: Flat out in the Dodge Charger Scat Pack

The 2019 Dodge Charger R/T Scat Pack is a rare breed in the car market. It's a reasonably affordable large sedan with a huge honking V8 and rear wheel drive. You know, the perfect car for this Fourth of July. Or any day ending in Y, really. The R/T Scat Pack is the second most powerful version of the sedan with a 6.4-liter naturally aspirated V8 making 485 horsepower and 475 pound-feet of torque. Only the 707-horsepower Hellcat is a more powerful Charger. But power is only part of the story. The other part is the noise. The V8 has a gritty, dirty rumble to it. We recorded it cruising up on-ramps, down shifting, and got a few standing revs out of it. Check out the video to hear for yourself.

470,000 Jeep Liberty, Chrysler 200, and Dodge Avenger models recalled for restraint defect

Fiat Chrysler Automobiles said on Friday it is recalling 470,000 vehicles worldwide to replace a component that may inhibit deployment of the vehicles' active head restraints in the event of a crash. Around 414,000 of those vehicles were sold in the United States. Apparently, "a component common to the modules of certain vehicles may degrade after extensive vehicle use." The recall covers 2012 Jeep Liberty sport utility vehicles and 2012-13 Chrysler 200 and Dodge Avenger midsize cars. FCA says a warning light may alert owners to the problem. The Italian-American automaker said it is unaware of any injuries or accidents related to the recall. The U.S. National Highway Traffic Safety Administration opened an investigation into the issue in June. (Reporting by David Shepardson; Editing by Steve Orlofsky) Related Video:

Junkyard Gem: 1987 Dodge Ram 50 with V8 swap

Chrysler did very well selling Mitsubishi Forte pickups with Plymouth and Dodge badging in the United States, even after Mitsubishi began moving the same trucks out of their own American dealerships in 1982. The 1987 Ram 50 2WD short bed weighed in at just over 2,500 pounds, so it was reasonably perky with its 2.0-liter G63B four-banger making 90 horsepower… but there's no replacement for displacement! At some point along the line, a Chrysler small-block V8 engine found its way into the engine compartment of this truck, now residing in a car graveyard in Sparks, Nevada. This was the cheapest new Dodge-branded pickup Americans could buy as a 1987 model, though it had to compete with its near-identical Mitsubishi Mighty Max twin for sales. The 1980s were great times for little pickups in the United States, but a desire for bigger cabs and more creature comforts doomed them by the dawn of the following decade. The most interesting thing about this engine swap is that it didn't involve a Chevrolet or Ford small-block V8. Both the Chevy small-block and Ford Windsor V8s are a few inches narrower than the Chrysler LA-series V8, which makes them easier to stuff into a small vehicle. It appears that engine length was the critical dimension in this case, since the Mopar seems to have had enough side-to-side clearance to avoid any slicing of Mitsubishi steel to make it fit. My guess is that whoever did the swap happened to have the engine handy and that's why it's here. Keeping it all Dodge might have been a factor in the decision as well, though the truck's Mitsubishi ancestry makes that unlikely. It was over 100°F out when I found this truck, so I wasn't motivated to check block casting numbers to determine exactly which LA engine we're dealing with here. The easiest LAs to get cheap for the last four or so decades have been the 318 (5.1-liter) and the 360 (5.8-liter), so one of those two is the most likely candidate here. Power levels for these engines got pretty dismal during the Malaise Era, but anyone with the wrenching skills to do this swap would have applied some basic power-enhancing wizardry before the engine went in. We can see there's an Edelbrock Performer intake manifold, and you might as well stab in a better camshaft if you're upgrading the intake. How much power? With a four-barrel carburetor on a dual-plane intake plus a meaner cam, 300 to 350 horsepower is easily achieved with one of these engines, even with stock exhaust manifolds.