Leather Sunroof Bluetooth Sat Radio Aux Htd Seats 3.5l V6 Carfax on 2040-cars

Auto blog

Common Dodge Ram 1500 vs. Chevrolet Silverado breakdowns

These two trucks are famous for their ability to get the job done. Still, even the toughest vehicle can have mechanical problems at some time. What if we match the Dodge Ram 1500 and Chevrolet Silverado head to head? Let's find out more about common repairs for each model. Also, learn some tricks to pay for car repairs. Clunky Steering Both Dodge and the Chevy owners sometimes notice bumping and clunking when steering. This might be more noticeable when driving over bumps. The cause is usually different in each truck though. In the Dodge Ram, clunky steering is more likely due to a defective lower ball joint. Replacement costs around $300 - $400, parts and labor. Clunky Chevy Silverado steering is probably a steering rack failure. This problem appears more often in trucks with over 90,000 miles. Silverado steering rack repair will run you up to $1,000 or more. Starting Woes For the Chevy Silverado with over 130,000 miles, you might notice trouble starting. This problem may appear occasionally at first, but it typically gets worse. Excluding a weak battery, the culprit is usually the starter. Replacement will cost you around $330 - $500. Of the total cost, $90 is for labor only. Now the Dodge Ram might make a ticking sound when starting, especially on models with over 94,500 miles. The noise often disappears after the engine warms up. These symptoms may indicate a broken exhaust manifold. Repair costs range from $800 - $900. Burning Oil & Gas Gauge On The Blink Sometimes, the Dodge Ram burns oil much faster than normal. In models with over 125,000 miles, this often points towards a leaky intake manifold gasket. A knocking sound may also appear with acceleration along with possible engine misfire. The cost to repair is around $200 - $300. The Chevy Silverado has its own surprises, especially when you've filled the gas tank but the gauge still reads low. Or the needle fluctuates widely from low to full while driving. In trucks with over 120,000 miles, it's likely due to a faulty fuel sensor. You might need a full fuel pump replacement, which can cost you up to $820, parts and labor. Water Inside And Poor Heat The Ram 1500 rear window has been known to leak. You might notice the back seat and floor wet after a rainstorm. This is more common in trucks with over 65,000 miles. Resealing the Ram 1500 rear window costs around $150 - $250.

NHTSA investigating power modules on Chrysler Group SUVs and minivans

The Center for Auto Safety is officially petitioning the National Highway Traffic Safety Administration to begin scrutinizing alleged problems with the totally integrated power module (TIPM) on about 24 Chrysler Group SUVs and minivans. The advocacy group claims that the part's failure can cause affected vehicles to stall or not start at all. NHTSA is still looking into the accusations and deciding whether a full investigation is actually warranted.
The CAS petition claims at least 70 TIPM failures, but according to NHTSA, six of the complaints are for models that don't have the modules. In 34 of the reported cases, the vehicles refused to start, and in 17 of them the engine stalled. There were also two allegations of smoke and one of a fire. However, none of these affected airbag deployment or resulted in a crash.
This petition isn't the first TIPM-related problem for Chrysler Group. A recent report in the New York Times alleged that it found 240 complaints potentially related to the issue on NHTSA's website alone. In September, the automaker also recalled 230,760 examples worldwide (188,723 in the US) of the 2011 Jeep Grand Cherokee and Dodge Durango replace the fuel pump relay circuit inside of the TIPM-7 with one external to the unit. The original part could allegedly cause the models to stall without warning. Even earlier, the company also recalled about 80,000 examples of the Jeep Wrangler and Dodge Nitro in 2007 to have the module reprogrammed.

Chrysler expecting up to 200,000 9-speed transmissions for 3 models this year

Striving for improved fuel economy, we already knew that Chrysler will begin using a nine-speed automatic transmission in some of its new products this year, but what we haven't known is that volume at which this gearbox will be used. According to Bloomberg, Chrysler CEO Sergio Marchionne has been quoted as saying that the automaker expects to sell close to 200,000 units equipped with this new transmission in 2013. Those gear-rich trannies will be spread out across three models, consisting of the redesigned Chrysler 200, the still-unnamed Jeep Liberty replacement and the Dodge Dart.
This transmission should play a pivotal role in making Chrysler vehicles more competitive in their respective segments. Just for comparison, one of the Dart's key competitors, the Toyota Corolla, still uses a four-speed automatic, and a previous report indicates that the next-generation 200 could get up to 38 miles per gallon on the highway, which is better than most non-hybrid midsize sedans on the market. Marchionne says that the new Jeep model is expected during the second quarter of this year, but there is no word as to when the new 200 or nine-speed Dart will debut, but clearly Dodge would like to have the transmission in its compact yesterday. As for that volume figure, it definitely doesn't seem out of reach since the Dart, Liberty and 200 combined for a total of more than 225,000 units in 2012.
How many more gears can we expect in future cars? Probably not many more, since the CEO of transmission-builder ZF, Stefan Sommer, previously stated that nine speeds was the "natural limit" for transmissions.