2009 Se Used 2.4l I4 16v Automatic Fwd Suv on 2040-cars

Auto blog

Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut

Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.

Mopar rolls out new Scat Packages for Dodge Challenger, Charger and Dart

Dodge buyers looking for that extra performance edge, take note: Mopar is bringing back the Scat Pack. Announced at the SEMA Show in Las Vegas today, the new Scat Packages will be available in three stages for the Challenger, Charger and Dart starting next spring.
Upgrades for the Charger and Challenger equipped with the 5.7-liter Hemi V8 engine include a
new cold-air intake and cat-back exhaust, as well as a remapped ECU. Upgrade to the Scat Package 2 and you get a new camshaft, and the Scat Package 3 tosses in ported and polished heads and hi-flow headers. Upgrades for the Dart GT with the smaller 2.4-liter, four-cylinder Tigershark engine with six-speed manual transmission start with a cold-air intake, short-throw shifter and upgraded brakes. The second stage kicks in a remapped ECU and cat-back exhaust, while the Scat Package 3 for the Dart gives you even bigger brakes, an adjustable suspension and sway bars front and rear.

Dodge Challenger spied exercising supercharged Hellcat Hemi V8

One of the prime complaints against the Dodge Challenger is that, even in SRT8 guise, its 470 horsepower is responsible for hauling over 4,200 pounds of vehicle. For comparison, the 420 hp in the Ford Mustang GT only has to deal with 3,618 lbs. Things only get worse from there, as the higher-performance variants of both the Mustang and the Chevrolet Camaro are far more powerful than an SRT8 without adding on much heft.
So what is Chrysler to do? The correct answer is add a whole lot more grunt to its hefty two-door and even the odds. That's where the all-new Hellcat engine comes into play. We reported on this engine in May, and suggested that the Hellcat, a supercharged powerplant based on a 6.4-liter V8, would easily generate 500 to 570 hp and could likely arrive boasting more than 600 ponies.
Chrysler's ace in its sleeve has now been spied testing, with a number of Hellcat-equipped Challengers running the potent new engine both in more urbanized areas and under the sun of Death Valley. The hoods on these testers have been raised to accommodate the engine, and that camouflage over the fascias of these prototypes is there to hide a larger air intake. We also note what appears to be a new split grille under wraps. As for power output, our spies are now suggesting a Viper-equalling 640 hp from the Hellcat-equipped cars.