2012 Dodge Grand Caravan Sxt Mini Passenger Van 4-door 3.6l on 2040-cars

Auto blog

500+ hp Stellantis 'Hurricane' I6 previews a world without Hemis

After years of rumored development, Stellantis has revealed its new six-cylinder engine family. The 3.0-liter, twin-turbocharged "Hurricane" I6 will offer V8 power, forced induction torque and six-cylinder efficiency in a package designed to fit into any of the company's North American rear-wheel-drive platforms.  What is "V8 power," exactly? Well, in standard output guise, the new I6 cranks out more than 400 horsepower (the specific figure will vary by application) and 450 pound-feet of torque, while the high-output variant is good for more than 500 horses and 475 lb-ft. The final figures will be dependent on the application. We'll save you a little legwork: In current Ram, Jeep and Dodge products, the 5.7-liter Hemi tops out at about 395 hp and 410 lb-ft, give or take, and the 6.4-liter around 485 hp and 475 lb-ft.    This is a clean-sheet design that is only related to the company's turbocharged four-cylinder by some common measurements. The I6 is exclusively direct-injection (no hybrid/port-injection here) and the two I6 variants share 96 common parts, including the block and oil pan design. The differences are found in their internals, intake plumbing, valvetrain components and the turbochargers themselves. Stellantis is not yet ready to share specs or supplier info for the turbos but says announcements will come from its partners soon.  The standard-output I6 has a compression ratio of 10.4:1 and revs to 5,800 rpm. It will run on regular fuel, albeit with reduced performance; 91 octane is recommended for maximum output. The high-output variant has a compression ratio of 9.4:1 and will rev to 6,100 rpm. That one will require premium. The new I6's advantages go beyond basic power output. Every Hemi family engine currently in production is based on an iron block design, so they're heavy. The aluminum-block I6 shaves weight off the total engine package, even if some of that gets added back thanks to the turbos and their associated plumbing. The standard-output I6 weighs 430 pounds, Stellantis engineers told us; the high-output adds just another 11. Fully dressed 5.7-liter V8s are in the 550-560-pound ballpark, and 6.4-liters close in on 600 pounds.  You may be wondering, "Why a clean-sheet gasoline engine now, when the industry is moving toward battery-electrics?" A valid inquiry, and one Stellantis was prepared to address. While the company will be pivoting to electrification over the next decade, it won't be instantaneous.

Jay Leno drives the Demon-powered SpeedKore carbon fiber Dodge Charger

Jay Leno drives all sorts of wild vehicles on his TV and YouTube series "Jay Leno's Garage," from concept cars to classics. Although many of the vehicles are museum quality, they don't all come through in straight by-the-book factory form, as Leno often likes to highlight the creative and insane builds from premium speciality aftermarket shops. One of his favorites is SpeedKore, which recently dropped by with its carbon-fiber-bodied 1970 Dodge Charger Evolution. After cementing itself as one of the best builds of the year at SEMA 2018, the high-performance Charger paid Leno a visit to show off its immaculately assembled blend of classic and modern Dodge. It's not the first time SpeedKore has stopped by, as they've previously shot videos together of the 1967 Chevrolet Camaro, the 2016 Ford Mustang Shelby GT350R, and the 1970 Dodge Charger Tantrum. The Charger featured here wears its Evolution name because it is an updated take on the Tantrum build (which had 1,650 horsepower, by the way), but the two are quite different. The Charger Evolution uses numerous parts from Dodge's recent superstars, the Challenger SRT Hellcat and the Challenger SRT Demon. In fact, it's one of the only ways in the world to drive a Demon engine with a manual transmission. Under the hood is the 6.2L Supercharged Hemi V8 from a Demon pre-production car, and SpeedKore has tuned it up to 966 horsepower. It pairs with a Tremec M6 6060 six-speed transmission from the Hellcat. At full bore, the whine of the supercharger paired with the grumble from the custom stainless steel SpeedKore exhaust headers makes for a thrilling, if not unharmonized, battle cry. Whereas some restomods have cut corners, shoddy build quality, or imperfect fittings, Leno notes that SpeedKore's work is top-notch, despite the entire exterior body and many pieces of the interior being fully replaced with glossy clear-coated exposed carbon fiber. According to SpeedKore Vice President Dave Salvaggio, the Charger weighs about 3,400 pounds. Check out the full video above or read full details from our time with the car at SEMA. And as a bonus, Autoblog photographer Drew Phillips recently got to spend a day shooting the Charger. His gallery of photos appears below. Speedkore 1970 Dodge Charger View 53 Photos

Dodge Viper might not live past 2017

The Dodge Viper might be running out of venom because the muscle-bound sports car could be on the road to being cancelled in just a few years. According to Allpar, the proposed deal between the United Auto Workers and FCA US would close the Connor Avenue Assembly plant, which produces the Viper, in 2017. The proposed union contract doesn't give a reason for closing the factory, but the decision is understandable if frustrating. The plant was idled twice last year to reduce production of the Viper to match flagging demand. A $15,000 price cut for the coupe eventually allowed for a sales surge, but that appetite hasn't continued in 2015. From January through September of this year, the company has only moved 503 of the sports cars, down eight percent. To further spur demand, Dodge has employed a few other tactics like the 1 of 1 program for buyers to personalize their Vipers, and the introduction of the brutally track-focused ACR. In a world where high-end sports cars are continuing to get friendlier for both their drivers and the environment, the Viper remains a holdout with a big, naturally aspirated V10. Even with the addition of some electronic aids on the latest Vipers, the snake still demands respect from those behind the wheel. Respect is fine, but sales are what matter to FCA – and the harsh reality is that a lack thereof might force the Viper into retirement, whether we like it or not.