2008 Dodge Grand Caravan Sxt - Loaded!! on 2040-cars

Auto blog

Demon's NHRA competition ban: Good talking point, bad feature

One of the biggest headlines for the Dodge Challenger Demon is that, in stock form, it's so fast that the NHRA won't allow it to compete in the organization's events. It's the ultimate humble brag, "I can't drag race my car because it's so fast it was banned by the sanctioning body." Certainly Tim Kuniskis, head of FCA brands in North America, was excited. He told the press that he hugged the guy that brought him the letter banning the Demon from competition. Unfortunately, the reality is that not being NHRA-legal is kind of silly, and frustrating for owners who would want to actually race. Before we go too much farther, we should explain exactly why the Demon is illegal for NHRA competition. The car is capable of a sub-10-second quarter-mile time both on racing fuel and 91-octane pump gas. Cars that fast are required by the NHRA to have a full, certified roll cage, and the Demon doesn't. Now there are certainly ways to get around this. The most obvious would be for a Demon owner to have a company install a roll cage. Using less grippy tires than the barely street-legal Nitto cheater slicks would probably help bring that time down, too. There's also the option of putting the car into Eco mode, and, yes, the Demon has one. In Eco mode, the Demon makes just 500 horsepower, and trips the lights at the quarter-mile in 11.59 seconds, which will avoid the roll-cage requirement. However, none of these options are ideal. For one thing, if you bought an 840-horsepower car, you're not going to want to limit it when you get to a closed course such as a drag strip. Similarly, you're not going to want to ditch your super-sticky tires at the strip, especially when they're standard equipment. Finally, having to go aftermarket for a roll cage is an inconvenience at minimum, and it seems like a strange oversight considering the rest of the car. This is a car from the factory that comes with drag radials, no passenger seats, a racing fuel tune, air conditioned intercooler, and even skinny front wheels for drag racing. Its purpose is clear, but for some reason, Dodge stopped short of giving it a roll cage that would allow it to compete. Perhaps adding a roll cage would've made it difficult to pass safety regulations, and we would be more disappointed if the car wasn't allowed on the street. Even so, it seems like an odd stopping point.

Common Dodge Ram 1500 vs. Chevrolet Silverado breakdowns

These two trucks are famous for their ability to get the job done. Still, even the toughest vehicle can have mechanical problems at some time. What if we match the Dodge Ram 1500 and Chevrolet Silverado head to head? Let's find out more about common repairs for each model. Also, learn some tricks to pay for car repairs. Clunky Steering Both Dodge and the Chevy owners sometimes notice bumping and clunking when steering. This might be more noticeable when driving over bumps. The cause is usually different in each truck though. In the Dodge Ram, clunky steering is more likely due to a defective lower ball joint. Replacement costs around $300 - $400, parts and labor. Clunky Chevy Silverado steering is probably a steering rack failure. This problem appears more often in trucks with over 90,000 miles. Silverado steering rack repair will run you up to $1,000 or more. Starting Woes For the Chevy Silverado with over 130,000 miles, you might notice trouble starting. This problem may appear occasionally at first, but it typically gets worse. Excluding a weak battery, the culprit is usually the starter. Replacement will cost you around $330 - $500. Of the total cost, $90 is for labor only. Now the Dodge Ram might make a ticking sound when starting, especially on models with over 94,500 miles. The noise often disappears after the engine warms up. These symptoms may indicate a broken exhaust manifold. Repair costs range from $800 - $900. Burning Oil & Gas Gauge On The Blink Sometimes, the Dodge Ram burns oil much faster than normal. In models with over 125,000 miles, this often points towards a leaky intake manifold gasket. A knocking sound may also appear with acceleration along with possible engine misfire. The cost to repair is around $200 - $300. The Chevy Silverado has its own surprises, especially when you've filled the gas tank but the gauge still reads low. Or the needle fluctuates widely from low to full while driving. In trucks with over 120,000 miles, it's likely due to a faulty fuel sensor. You might need a full fuel pump replacement, which can cost you up to $820, parts and labor. Water Inside And Poor Heat The Ram 1500 rear window has been known to leak. You might notice the back seat and floor wet after a rainstorm. This is more common in trucks with over 65,000 miles. Resealing the Ram 1500 rear window costs around $150 - $250.

FCA inline-six rumored to be real, headed for Jeep Wagoneer

In September, Allpar reported that that clues being dropped at Fiat- Chrysler headquarters, in the carmaker's factories, and on engineer resumes pointed to the development of an inline six-cylinder engine. The site has just proclaimed the rumor is reality, writing that the straight-six, "turbocharged to meet or beat 5.7 Hemi power ratings, with a smoother torque curve, is on the way." The motor's first outing is expected to be either the next-generation Jeep Grand Cherokee, debuting perhaps next year, or the Jeep Wagoneer, debuting in 2020 or 2021. "Tornado" is the purported codename for the power plant said to be just under three liters in displacement, expanding the family begun with the Global Medium Engine 2.0-liter turbo codenamed Hurricane. Engine bay constraints and a long use horizon mean engineers won't simply add two more cylinders to the GME, however. Allpar says the brief is to keep the Tornado GME-T6 — the alphanumeric for "turbocharged six" — no more than three inches longer than the Tigershark 2.4-liter four-cylinder. That means "major design changes" that could include a space-saving head, more closely spaced cylinders, and no cylinder liners. An FCA division called Comau could be called on for its "SmartSpray" plasma lining technology. Allpar muses that the standard version of the engine for Chrysler, Dodge, Jeep, and Ram could get a single twin-scroll turbocharger. Performance trims for Alfa Romeo and Maserati could get different heads and maybe twin turbos, an SRT version might also get both those tweaks. History shows that the Italian versions would make changes to the block, as well. Even so, the Tornado would be less expensive than any Ferrari-supplied V6. A straight-six would put FCA in company with current adopters BMW and Mercedes-Benz, future users like Jaguar, and perhaps Aston Martin. The engine would span the widest range of use cases in the U.S. carmaker's portfolio, though. Potential applications include being a base engine for Ram trucks, serving double duty as a base engine and 5.7-liter Hemi replacement for the Dodge Charger and Challenger, working in the high-end Jeeps, and as a properly hot trim — with Ferrari-designed heads — in the luxury Italian sports cars. The Alfa Romeo Giulia begs for just such motivation to fill the gap between the 280-hp, $42,695 Ti Sport RWD and the 505-hp, $73,700 Giulia Quadrifoglio RWD. And a twin-turbo inline-six in a Maserati Alfieri would stack up nicely with the Germans.