2002 Dodge Durango Slt Plus Sport Utility 4-door 4.7l on 2040-cars

Auto blog

500+ hp Stellantis 'Hurricane' I6 previews a world without Hemis

After years of rumored development, Stellantis has revealed its new six-cylinder engine family. The 3.0-liter, twin-turbocharged "Hurricane" I6 will offer V8 power, forced induction torque and six-cylinder efficiency in a package designed to fit into any of the company's North American rear-wheel-drive platforms.  What is "V8 power," exactly? Well, in standard output guise, the new I6 cranks out more than 400 horsepower (the specific figure will vary by application) and 450 pound-feet of torque, while the high-output variant is good for more than 500 horses and 475 lb-ft. The final figures will be dependent on the application. We'll save you a little legwork: In current Ram, Jeep and Dodge products, the 5.7-liter Hemi tops out at about 395 hp and 410 lb-ft, give or take, and the 6.4-liter around 485 hp and 475 lb-ft.    This is a clean-sheet design that is only related to the company's turbocharged four-cylinder by some common measurements. The I6 is exclusively direct-injection (no hybrid/port-injection here) and the two I6 variants share 96 common parts, including the block and oil pan design. The differences are found in their internals, intake plumbing, valvetrain components and the turbochargers themselves. Stellantis is not yet ready to share specs or supplier info for the turbos but says announcements will come from its partners soon.  The standard-output I6 has a compression ratio of 10.4:1 and revs to 5,800 rpm. It will run on regular fuel, albeit with reduced performance; 91 octane is recommended for maximum output. The high-output variant has a compression ratio of 9.4:1 and will rev to 6,100 rpm. That one will require premium. The new I6's advantages go beyond basic power output. Every Hemi family engine currently in production is based on an iron block design, so they're heavy. The aluminum-block I6 shaves weight off the total engine package, even if some of that gets added back thanks to the turbos and their associated plumbing. The standard-output I6 weighs 430 pounds, Stellantis engineers told us; the high-output adds just another 11. Fully dressed 5.7-liter V8s are in the 550-560-pound ballpark, and 6.4-liters close in on 600 pounds.  You may be wondering, "Why a clean-sheet gasoline engine now, when the industry is moving toward battery-electrics?" A valid inquiry, and one Stellantis was prepared to address. While the company will be pivoting to electrification over the next decade, it won't be instantaneous.

2015 Dodge Viper GTC Beauty-Roll

For those of you paying attention, we've really ramped up the old Autoblog video game these days. Our new series Car Club USA joins Translogic and The List, and there are more Daily Drivers and Short Cuts than ever. But sometimes, all you care about is the car. The Autoblog Beauty-Roll video series has one goal: bring you glossy video images of cars, and nothing but. We're collecting moving pictures of all the cars we test, inside and out. Each episode comes with a hit of engine sound – start-up and with a few revs – to round out the package. Set your resolution to max, kick it into full-screen, turn up the sound, and enjoy today's subject, the 2015 Dodge Viper GTC. Oh, and if you'd like more Beauty-Roll, click here to see the back catalog.

FCA adds 88k Dodge Challengers to Takata inflator recall

The Takata airbag inflator recall from FCA US is growing 88,346 vehicles larger in the US after the company's discovery of the faulty parts in the 2008-2010 Dodge Challenger. The affected examples have production dates between September 19, 2007, and October 29, 2010, and the coupes need the replacement components on the driver's side. According to chronology posted by the National Highway Traffic Safety Administration (as a PDF), the automaker was auditing the models covered under the campaign in July and "identified a population of vehicles that was inadvertently excluded." Initially, FCA believed these cars were using an unrecalled Takata inflator. The audit revealed that the affected cars indeed used a recalled version. As with the rest of the faulty parts, exposure to moisture can cause them to ignite too quickly during an airbag deployment and spray shrapnel at occupants. The problem has been linked to at least eight deaths worldwide and a vehicle fire in Japan. The Challenger wasn't previously part of FCA's 3.3-million unit national campaign or the subsequent expansion. According to FCA US the parts to complete the repairs in these Challengers aren't currently available. However, owners will be notified of the issue by mail starting August 14. They will receive a second notice when the parts become available. Related Video: RECALL Subject : Driver Side Frontal Air Bag Inflator May Rupture Report Receipt Date: JUL 10, 2015 NHTSA Campaign Number: 15V444000 Component(s): AIR BAGS Potential Number of Units Affected: 88,346 All Products Associated with this Recall Vehicle Make Model Model Year(s) DODGE CHALLENGER 2008-2010 Details Manufacturer: Chrysler (FCA US LLC) SUMMARY: Chrysler (FCA US LLC) is recalling certain model year 2008-2010 Dodge Challenger vehicles manufactured September 19, 2007, to October 29, 2010. The affected vehicles are equipped with a dual-stage driver frontal air bag that may be susceptible to moisture intrusion which, over time, could cause the inflator to rupture. CONSEQUENCE: In the event of a crash necessitating deployment of the driver's frontal air bag, the inflator could rupture with metal fragments striking the driver or other occupants resulting in serious injury or death. REMEDY: Chrysler will notify owners, and dealers will replace the driver's frontal air bag inflator, free of charge. Parts to remedy the vehicles are not currently available. Interim notices will be mailed to owners beginning August 14, 2015.