1999 Doodge Durango 4wheel Drive on 2040-cars

Auto blog

25,000 Jeep Grand Cherokee, Dodge Durango SUVs recalled over brake feel

Chrysler has announced that it is recalling over 25,000 Jeep Grand Cherokee and Dodge Durango SUVs from several markets over concerns about brake feel under hard braking. The affected models are from the 2012 and 2013 model years, although the actual dates of production aren't available. 18,700 are in the US, while 825 are in Canada, 530 are in Mexico and a further 5,200 outside of North America.
According to a statement, Chrysler was informed of the issue by a component supplier for the Ready Alert Braking system, which primes the brakes in anticipation of an emergency stop. A component in the system was restricting the flow of brake fluid too much.
As Chrysler is quick to point out, the way the brakes functioned was in compliance with regulations and there are no reported cases of drivers losing braking power. Instead, the issue rests with what Chrysler calls a pedal feel that "was not consistent with customer expectations." So it would seem Chrysler is being proactive and fixing a problem not because there's a legal issue at work, but simply because it doesn't feel the way the manufacturer wants it to. Well done.

Fiat Chrysler Automobiles recalls nearly 750k vehicles in two campaigns

Fiat Chrysler Automobiles is recalling a total of 747,817 vehicles in the US in two separate campaigns recently added to the National Highway Traffic Safety Administration database.
The first one covers about 434,581 units of the Chrysler 300, Dodge Charger, Challenger, Durango, and Jeep Grand Cherokee from the 2011-2014 model years with electric hydraulic power steering, the 3.6-liter V6 engine and a 160 amp alternator, according to FCA. In the affected vehicles, it's possible for the alternator to fail without warning and possibly cause the car to stall. According to the documentation submitted to NHTSA, the automaker began investigating the problem in August 2014 and has found possible evidence of one crash caused by the failures but no known injuries.
Customers will begin receiving notification about the recall next month, and obviously the repairs will be done at no cost to them.

Chrysler says its 8-speed transmissions will save 700 million gallons

Chrysler Group's TorqueFlite eight-speed transmission could be earning some serious green bragging rights if the company's projections are correct. The recently widely proliferated automatic gearbox, which is now in more than a million vehicles around the world, is poised to save drivers an estimated 700+ million gallons of fuel over the vehicles' lifetimes (an expected cost savings of $2.5 billion). In addition, Chrysler expects a reduction in CO2 emissions by more than six million metric tons. According to Chrysler, and depending on the vehicle, the TorqueFlite can improve fuel economy. The TorqueFlite autobox features particularly close ratios from fifth to eighth gear (see the press release below for the specific numbers), and uses low-viscosity fluid that doesn't need to be replaced. Transmission software adapts to the driving situation to optimize efficiency based on driver behavior, temperature, grade, stability control, and longitudinal and lateral acceleration. The TorqueFlite is capable of handling a variety of duties. As evidenced by the wide range of vehicles Chrysler Group has seen fit to equip with the eight-speed transmission, the TorqueFlite is capable of handling a variety of duties. Since its 2012 introduction, the TorqueFlite has gone from performing cog-swapping duties in Dodge Charger and Chrysler 300 models equipped with the 3.6-liter Pentastar V6 to changing gears in vehicles such as the Pentastar- and Hemi-powered Dodge Durango, Jeep Grand Cherokee and even the Ram 1500 EcoDiesel. For the 2015 model year, the eight-speed is finding its way into even more vehicles with the addition of a third version. In addition to the American-made TorqueFlite 845RE and 8HP70, the new 8HP90 will be manufactured in Saarbrucken, Germany. The 8HP90 is designed for higher torque loads, making it ideal for high-performance vehicles like the 2015 Dodge Challenger SRT Hellcat. The already-in-use 8HP70 will expand its duties to be used in 2015 Hemi models such as the Dodge Charger, Challenger, and Challenger SRT8. You can see the list of those benchmarks in Chrysler's press release below.