1972 Dodge Dart on 2040-cars

Auto blog

2015 Dodge Challenger SRT Hellcat [w/videos]

Darrell Waltrip once said, "If the lion didn't bite the tamer every once in a while, it wouldn't be exciting." The sentiment behind that aphorism is causing my adrenal gland to wake up as Dodge and SRT drivers and engineers - somber-faced to a man - give me the track talk that will precede my driving the 2015 Dodge Challenger SRT on the circuit at Portland International Raceway. PIR might not be Daytona, and the 707-horsepower Challenger Hellcat might seem tame to a legend like ol' Jaws, but there's a not-small part of me that's thinking about how hard Dodge's fire-breathing kitty might bite.
Just a few hours previous, I'd gotten behind the wheel of the Hellcat for the first time, letting its hyperbole-spitting, supercharged V8 Hemi pull me yieldingly through Portland's morning commuter traffic. Lulled into a cocky certainty by the Challenger's good manners at low speed, I drove the throttle just a hair too deep, too fast when I ran on to the highway ramp. For just an instant the rear tires were utterly drenched in torque, and the back end of the big Dodge loosened up like a drift car on a wet track. Throttle steer lives at the fleeting whim of your right foot in this car.
It was no big thing to lay off the gas and pull the Hellcat back in line as I entered the highway, but the incident did get me to thinking: What will this car do to me on a road course?

Chrysler recalling 700k minivans and Dodge Journey for ignition switch woes

General Motors isn't the only automaker with ignition switch problems. Chrysler is fighting it too and is now announcing a recall of 695,957 examples worldwide of the Chrysler Town & Country and Dodge Grand Caravan minivans from the 2008-2010 model years, plus the 2009-2010 Dodge Journey.
According to a statement from Chrysler, the models have a bad wireless ignition node detent ring in the ignition switch, making it possible for drivers to appear to have the key in the "Run" position but for the spring not to fully engage. It can then slip back to the "Accessory" position and shut the car off. If this happens, the vehicle loses power steering, brake boost and the airbags.
There is some disparity about the number of vehicles affected under this recall. In its statement, Chrysler claims that it covers 525,206 vehicles in the US, 102,892 in Canada, 25,591 in Mexico and 42,268 elsewhere. However, the recall announcement posted by The National Highway Traffic Safety Administration lists an estimated 438,109 vehicles in the US. Chrysler spokesperson Nick Cappa told Autoblog via email that the reasoning for the different figures "will become clear at a later date."

Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut

Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.