Find or Sell Used Cars, Trucks, and SUVs in USA

2008 Dodge Dakota Laramie Crew Cab Pickup 4-door 4.7l on 2040-cars

US $14,000.00
Year:2008 Mileage:80226 Color: Red /
 Gray
Location:

Los Angeles, California, United States

Los Angeles, California, United States
Advertising:
Transmission:Automatic
Body Type:Pickup Truck
Engine:V8 Flex Fuel 4.7L
Vehicle Title:Clear
Fuel Type:Gasoline
For Sale By:Private Seller
VIN: 1D7HE48N98S567826 Power Options: Air Conditioning, Cruise Control, Power Locks, Power Windows, Power Seats
Number of Cylinders: 8
Year: 2008
Make: Dodge
Model: Dakota
Cab Type (For Trucks Only): Crew Cab
Trim: Quad Cab SLT
Warranty: Vehicle does NOT have an existing warranty
Drive Type: RWD
Safety Features: Anti-Lock Brakes, Driver Airbag, Passenger Airbag
Mileage: 80,226
Exterior Color: Red
Interior Color: Gray
Disability Equipped: No
Condition: UsedA vehicle is considered used if it has been registered and issued a title. Used vehicles have had at least one previous owner. The condition of the exterior, interior and engine can vary depending on the vehicle's history. See the seller's listing for full details and description of any imperfections.Seller Notes:"The vehicle is in good to great condition. I will note that there is a minor crack on the lower half of the windshield and a small dent on the hood, along with maybe some other small cosmetic damage. The right rear tire sensor is not installed, so there is a tire pressure light on at all times and the left fog light is inoperable (possibly a blown light). Also, the vehicle has been in two reported accidents but is running more than fine (I drove it from New York City to Los Angeles recently and I had no mechanical, hydraulic or electrical problems along the way). I will say because of the trip the vehicle does require an oil change, but aside from that no other general maintenance should be required. The vehicle does include an in dash Clarion Navigation Unit."

I am the second owner of this vehicle. I purchased it in Jacksonville, NC back in 2009 at roughly 41,000 miles. I am trying to sell this vehicle within the state of CA (southern California), and can drive to prospective buyers.

Auto Services in California

Windshield Repair Pro ★★★★★

Auto Repair & Service, Windshield Repair
Address: Lodi
Phone: (209) 505-5999

Willow Springs Co. ★★★★★

Automobile Parts & Supplies, Automobile Parts, Supplies & Accessories-Wholesale & Manufacturers
Address: 4040 Manly Rd, Willow-Springs
Phone: (661) 328-0881

Williams Glass ★★★★★

Automobile Parts & Supplies, Glass-Auto, Plate, Window, Etc, Automobile Accessories
Address: 655 Bridge St, Grimes
Phone: (530) 953-2687

Wild Rose Motors Ltd. ★★★★★

Used Car Dealers
Address: 3901 E La Palma Ave # A, Atwood
Phone: (714) 260-4867

Wheatland Smog & Repair ★★★★★

Auto Repair & Service, Automotive Tune Up Service, Automobile Inspection Stations & Services
Address: 407 Main St, Linda
Phone: (530) 633-0271

West Valley Smog ★★★★★

Automobile Parts & Supplies, Automobile Inspection Stations & Services, Emissions Inspection Stations
Address: 1880 Sinaloa Rd, Somis
Phone: (805) 581-0550

Auto blog

Challenger A/T Unlimited Concept could be your next Hellcat-powered ORV

Fri, 29 Aug 2014

This past June I spent an excellent day hanging out with Joey Ruiter, driving and discussing his Reboot Buggy project. Before heading home, I let him know that he was more than welcome to keep me abreast of whichever new automotive project he'd get into. You can never have too many car designers and one-off fabricators in your Rolodex, right?
Ruiter recently made good with the follow-up, emailing me with details on this Dodge Challenger A/T Untamed Concept that pushes a lot of hot buttons for the muscle car and off-roading enthusiasts.
This all-terrain Mopar is a lot more than a Challenger body dropped on a truck chassis, too. A materialized version of the A/T would included a completely new, long-travel suspension, skid plates, body armor and rock sliders, and obviously flared fenders to help accommodate a hellacious set of off-road-ready tires. The dramatically revised underpinnings would be topped with a slick graphics package and a killer lower light bar, all making the A/T look quite cohesive in its own, radical way. And the result would be a car no longer limited to mere road-driving.

Junkyard Gem: 1987 Dodge Ram 50 with V8 swap

Sun, Aug 11 2024

Chrysler did very well selling Mitsubishi Forte pickups with Plymouth and Dodge badging in the United States, even after Mitsubishi began moving the same trucks out of their own American dealerships in 1982. The 1987 Ram 50 2WD short bed weighed in at just over 2,500 pounds, so it was reasonably perky with its 2.0-liter G63B four-banger making 90 horsepower… but there's no replacement for displacement! At some point along the line, a Chrysler small-block V8 engine found its way into the engine compartment of this truck, now residing in a car graveyard in Sparks, Nevada. This was the cheapest new Dodge-branded pickup Americans could buy as a 1987 model, though it had to compete with its near-identical Mitsubishi Mighty Max twin for sales. The 1980s were great times for little pickups in the United States, but a desire for bigger cabs and more creature comforts doomed them by the dawn of the following decade. The most interesting thing about this engine swap is that it didn't involve a Chevrolet or Ford small-block V8. Both the Chevy small-block and Ford Windsor V8s are a few inches narrower than the Chrysler LA-series V8, which makes them easier to stuff into a small vehicle. It appears that engine length was the critical dimension in this case, since the Mopar seems to have had enough side-to-side clearance to avoid any slicing of Mitsubishi steel to make it fit. My guess is that whoever did the swap happened to have the engine handy and that's why it's here. Keeping it all Dodge might have been a factor in the decision as well, though the truck's Mitsubishi ancestry makes that unlikely. It was over 100°F out when I found this truck, so I wasn't motivated to check block casting numbers to determine exactly which LA engine we're dealing with here. The easiest LAs to get cheap for the last four or so decades have been the 318 (5.1-liter) and the 360 (5.8-liter), so one of those two is the most likely candidate here. Power levels for these engines got pretty dismal during the Malaise Era, but anyone with the wrenching skills to do this swap would have applied some basic power-enhancing wizardry before the engine went in. We can see there's an Edelbrock Performer intake manifold, and you might as well stab in a better camshaft if you're upgrading the intake. How much power? With a four-barrel carburetor on a dual-plane intake plus a meaner cam, 300 to 350 horsepower is easily achieved with one of these engines, even with stock exhaust manifolds.

FCA seeks partner to keep building Dodge Dart, Chrysler 200

Wed, Mar 9 2016

Mere weeks after FCA announced it was shutting down production of the Dodge Dart and Chrysler 200, new hope emerges to give the sedans a stay of execution. Speaking at the Geneva Motor Show last week, Sergio Marchionne said that the company was looking for a partner "who is better at it than we are and who has got capacity available" in order to continue building the models on its behalf. "There are discussions going on now," said Marchionne, according to Motor Trend. "I think we will find a solution. We continue to talk. It's both a technical solution and an economic one. We need to find a solution that works economically." Contracting vehicles to be manufactured offsite is more common practice among European automakers than it is with American ones. Chrysler's former patron Mercedes, for example, has the G-Class built for it by Magna Steyr in Austria, the A-Class by Valmet in Finland, and the R-Class by AM General in Indiana (even though it's no longer sold in the US). This arrangement would, on the surface at least, appear more similar to the deal that Toyota struck with Mazda to build the Scion iA, drawing on the contractor's expertise and capacity to build the small sedan on the client company's behalf. Only rather than basing a new model on one of the partner's existing ones, this deal would ostensibly continue building FCA models on FCA platforms using FCA components. We'll have to wait to find out with whom FCA strikes up the manufacturing deal, but we wouldn't be surprised to see Marchionne turn to a partner he already knows. The company is, after all, at the center of an intricate web of joint ventures and manufacturing contracts. The Fiat 124 Spider, for example, is built by Mazda. The Fiat Sedici that preceded the 500X was built by Suzuki. Models like the Dodge Stealth and Eagle Talon were built in Illinois at the Diamond-Star Motors joint venture before Mitsubishi took it over altogether. And Dodge continued selling the Mercedes-made Sprinter long after DaimlerChrysler split. The Ram ProMaster, though built by FCA in Mexico for the North American market, stems from a partnership in France with PSA Peugeot Citroen. And the ProMaster City is built in a joint-venture plant in Turkey, from which it's also sold by GM as an Opel in Europe and a Vauxhall in the UK. With all those deals coming and going, after all, what would one more add to the complexity?