2003 Dodge Dakota Quad Cab Silver Rwd, 3.9 Liter, 4 Door, Full Power, Nice!! on 2040-cars

Auto blog

NHTSA is investigating FCA shifters for roll-away accidents again, this time the rotary units

It seems FCA's shifter troubles aren't over yet. Now, just a few months after issuing a recall to resolve user-related issues with its monostable shifters, the company is again under investigation by NHTSA. The issue is related to the potential for cars to roll away when the rotary-style shifter is not properly placed in park. Two FCA models are the subject of this investigation: the 2013–2016 Ram 1500 and the 2014–2016 Dodge Durango. NHTSA estimates about 1,000,000 vehicles would be affected if a recall is issued. The investigation was started following 43 complaints of vehicles rolling away while supposedly being in "park." Among the complaints were reports of 25 crashes and 9 injuries. NHTSA does point out that in every incident, the parking brake was not engaged. A representative from FCA also gave us an official statement regarding the investigation: "FCA US is cooperating fully with NHTSA's investigation, the scope of which is limited. Other vehicles equipped with rotary shifters are not included. In accordance with prudent practice, the Company joins NHTSA in urging all drivers to use their vehicles' parking brakes." View 35 Photos As mentioned above, other Chrysler products with rotary shifters, such as the Pacifica minivan and 200 sedan, are not involved in this investigation. One of the key differences, as the representative told us, is that these vehicles have electronic parking brakes that automatically engage if the driver does not select park and then opens the door with the seatbelt unbuckled. The Ram 1500 and Durango feature mechanical, manually operated parking brakes and therefore cannot activate the brake automatically. Because this is currently an investigation, an exact cause for the incidents has yet to be determined, and none of the vehicles have been recalled. It's possible there could be a mechanical defect. However, the issue could be a confusing interface causing user error, as was the case with FCA's monostable shifters, where drivers think they've put the car in park but actually haven't. Something that indicates it could be a case of confused users is that NHTSA also opened an investigation into 2012–2014 Jaguar XF and Land Rover Range Rover Evoques for similar issues. Both vehicles use a rotary shifter and have had roll-away complaints levied as well. Even if it is a case of user error, FCA and Jaguar Land Rover may still have to recall their vehicles.

Stellantis wants to trim 3,500 hourly U.S. jobs, UAW says

WASHINGTON — Chrysler-parent Stellantis NV wants to cut approximately 3,500 hourly U.S. jobs and is offering voluntary exit packages, according to a United Auto Workers union letter made public Tuesday. The automaker is looking to reduce its hourly workforce offering incentive packages that include $50,000 payments for workers hired before 2007, UAW Local 1264 said in a letter dated Monday posted on its Facebook page. Stellantis spokeswoman Jodi Tinson declined to comment. A person briefed on the matter said the figure might be lower than the figure cited in the UAW letter. In late February, Stellantis indefinitely halted operations at an assembly plant in Illinois, citing rising costs of electric vehicle production. The action impacted about 1,350 workers at the Belvidere, Illinois, plant that built the Jeep Cherokee SUV and resulted in indefinite layoffs. The automaker has warned it may not resume operations as it considers other options. The UAW letter said openings created by workers leaving would be filled by workers on indefinite layoff. Stellantis said in February that about 40,000 U.S. hourly workers were eligible for profit sharing. Last week, UAW President Shawn Fain said Stellantis' decision to idle the Illinois plant was "a flat-out violation" of the union's contract with the UAW and is unacceptable. The UAW will enter talks with the Detroit Three before labor contracts expire in mid-September. Earlier this month, General Motors said about 5,000 salaried workers accepted buyouts to leave the automaker. GM CEO Mary Barra said February job cuts of a few hundred jobs and the 5,000 buyouts "provided approximately $1 billion towards" a $2 billion cost cutting target. Ford Motor Co recently announced significant job cuts in Spain, Germany and other parts of Europe and in August said it would cut a total of 3,000 salaried and contract jobs, mostly in North America and India. Hirings/Firings/Layoffs UAW/Unions Chrysler Dodge Fiat Jeep Maserati RAM Stellantis

Fiat Chrysler halts European production as coronavirus hits demand

MILAN — Fiat Chrysler Automobiles (FCA) is halting production for two weeks at most of its European plants to help protect staff against the coronavirus pandemic and adjust to a slump in demand, the Italian-American carmaker said on Monday. Italy has been the European country worst hit by the crisis and the first to enforce a nationwide lockdown, which has now been replicated by Spain and, to a lesser extent, by France as the virus sweeps through the continent. With all non essential services closed, including car dealers, and people forced home except for strict working needs, many forecast a heavy fall in car sales in March. FCA — which according to analyst estimates produces around 25% of its vehicles in Europe — said the suspensions through March 27 would allow it "to effectively respond to the interruption in market demand by ensuring the optimization of supply." Ferrari, meanwhile, said it closed its two plants until March 27. Ferrari said it had so far ensured production continuity, and it already implemented all the health measures decided by the Italian government at the two sites, in hometown Maranello and in Modena. But it was "now experiencing the first serious supply chain issues, which no longer allow for continued production." Marco Opipari, an analyst at Fidentiis, said a few weeks of closures was not a big problem in an over-supplied European auto industry and lost production could be recovered later on. "The real problem is on the demand side, people are not buying cars now, and sales volumes are expected to be very bad in March, with a real impact on automakers' earnings," he said. FCA said in a statement that production for its FCA Italy and luxury Maserati units would stop for two weeks, extending a temporary closure period already planned for some Italian facilities. Affected plants are Melfi, Pomigliano, Cassino, Mirafiori, Grugliasco and Modena in Italy, Kragujevac in Serbia and Tychy in Poland. The FIOM union said FCA's decision was "necessary". The carmaker said the freeze would help it to resume activity promptly once market conditions allow it. "The group is working with its supply base and business partners to be ready to enable our manufacturing operations to deliver previously planned total levels of production despite the suspension when market demand returns," it said.