2003 Dodge Dakota Base Extended Cab Pickup 2-door 4.7l on 2040-cars

Auto blog

Chrysler expecting up to 200,000 9-speed transmissions for 3 models this year

Striving for improved fuel economy, we already knew that Chrysler will begin using a nine-speed automatic transmission in some of its new products this year, but what we haven't known is that volume at which this gearbox will be used. According to Bloomberg, Chrysler CEO Sergio Marchionne has been quoted as saying that the automaker expects to sell close to 200,000 units equipped with this new transmission in 2013. Those gear-rich trannies will be spread out across three models, consisting of the redesigned Chrysler 200, the still-unnamed Jeep Liberty replacement and the Dodge Dart.
This transmission should play a pivotal role in making Chrysler vehicles more competitive in their respective segments. Just for comparison, one of the Dart's key competitors, the Toyota Corolla, still uses a four-speed automatic, and a previous report indicates that the next-generation 200 could get up to 38 miles per gallon on the highway, which is better than most non-hybrid midsize sedans on the market. Marchionne says that the new Jeep model is expected during the second quarter of this year, but there is no word as to when the new 200 or nine-speed Dart will debut, but clearly Dodge would like to have the transmission in its compact yesterday. As for that volume figure, it definitely doesn't seem out of reach since the Dart, Liberty and 200 combined for a total of more than 225,000 units in 2012.
How many more gears can we expect in future cars? Probably not many more, since the CEO of transmission-builder ZF, Stefan Sommer, previously stated that nine speeds was the "natural limit" for transmissions.

Dodge Challenger spied exercising supercharged Hellcat Hemi V8

One of the prime complaints against the Dodge Challenger is that, even in SRT8 guise, its 470 horsepower is responsible for hauling over 4,200 pounds of vehicle. For comparison, the 420 hp in the Ford Mustang GT only has to deal with 3,618 lbs. Things only get worse from there, as the higher-performance variants of both the Mustang and the Chevrolet Camaro are far more powerful than an SRT8 without adding on much heft.
So what is Chrysler to do? The correct answer is add a whole lot more grunt to its hefty two-door and even the odds. That's where the all-new Hellcat engine comes into play. We reported on this engine in May, and suggested that the Hellcat, a supercharged powerplant based on a 6.4-liter V8, would easily generate 500 to 570 hp and could likely arrive boasting more than 600 ponies.
Chrysler's ace in its sleeve has now been spied testing, with a number of Hellcat-equipped Challengers running the potent new engine both in more urbanized areas and under the sun of Death Valley. The hoods on these testers have been raised to accommodate the engine, and that camouflage over the fascias of these prototypes is there to hide a larger air intake. We also note what appears to be a new split grille under wraps. As for power output, our spies are now suggesting a Viper-equalling 640 hp from the Hellcat-equipped cars.

Dodge Durango Shaker concept: A 392 V8 in front of six Viper seats

When done right, a parts-bin special can be a beautiful thing. This Dodge Durango Shaker concept for the 2016 SEMA show is one such vehicle, and it's easily our favorite Mopar debuting in Vegas. The key, of course, is pulling from the right bins. Take a tour and you'll see Charger, Challenger, and Viper pieces grafted onto this slick crossover. The featured special part is the big, 6.4-liter 392 Hemi V8 that's been dropped under the hood; it's sourced from the SRT Challenger and Charger where it makes 485 horsepower and 475 pound-feet of torque. With that in place, the fabricators cut a big hole in that hood for the Challenger's awesome optional shaker scoop. It wasn't an easy installation; it required a custom spacer for the intake to make sure everything lined up with the hole properly. View 17 Photos Apparently there were some Viper seats lying around, so six of them were stuck into this Durango. Makes sense. It does lose a bit of people-carrying capability as a result, since only two seats fit in each row, and the seats don't fold for extra cargo room. A Dodge spokesperson attested to the fact that all three rows are usable, if not totally comfortable. But then stock third-row seats aren't always that comfortable anyway. Seriously, though, Viper seats. We don't care how comfortable or usable the result is. Although you might not give it a second thought, even the fuel filler needed some special attention. This piece was also lifted from a Dodge Challenger, and it was taken along with the surrounding sheet metal. Because of the different orientation of the filler cover on the Challenger, the builders decided the easiest way to get it to fit was to chop the fuel filler section out and weld it onto the Durango. The designers also put a little blue Stig on the cover. And those are just the cool parts that were hard to install. This Durango features plenty of other slick details, like the custom bumpers, fender flares, and side skirts. Everything is painted B5 Blue with matte black and carbon accents all around. Up front, the bumper hides a pair of fog lights stolen from a Challenger Hellcat – and yes, they're the ones with intakes in the middle. The grille is also a custom piece, losing the standard crosshair design for better airflow. The fender flares cover up some seriously wide, 305-section tires at all four corners, which are hauled down by Hellcat brakes. The rear bumper bumper contains a stylish center-exit exhaust with dual tips.