1996 Dodge Dakota Ex-cab Slt Pickup V8/ 4x4 / Runs Great/ No Reserve! Dont Miss on 2040-cars

Auto blog

2020 Dodge Challenger Drag Pak will debut at SEMA

Mopar fans have countless reasons to get hyped about the 2019 SEMA show. Speedkore is bringing a twin-turbocharged, all-wheel-drive Dodge Charger Hellcat Widebody, Mopar is bringing a done-up 1968 Dodge D200 "Lowliner," Ram is bringing a diesel 1500 overlander, and Jeep is bringing a custom off-road Wrangler. But the launch of the new 2020 Dodge Challenger Drag Pak might garner the most attention from the brand's most serious customers. Prior to the show, Mopar teased a photo and a short video clip, both showing a new Dodge Challenger from the overhead view. The white Challenger showed a wide blue stripe down the center of the car with two pinstripes along each side. "Powered by SRT" runs across the top of the windshield, and Mopar logos grace both sides of the car just beneath the side windows. Red decals run back from the rear quarter panels and connect across the rear of the car. It also has hood pins on the SRT Hellcat hood and a parachute attached the rear. There's a parachute because this is the factory turnkey drag-race-focused Dodge Challenger racecar. Mopar released no other information on what type of hardware the Drag Pak will be using, or what's under the hood, but the video gives a great preview of the exhaust note in full tire-smoke mode. As some Drag Paks in the past have dropped roughly 1,000 pounds from their production starter vehicles, the 2020 model will surely utilize plenty of weight-savings methods such as the removal of all interior comfort features that don't apply on the racetrack. Mopar has also previously altered the position of the engine and changed the wheelbase to the benefit of better weight distribution. Mopar is set to livestream the unveiling starting at 7:26 p.m. ET (that's 4:26 on the West Coast, which not coincidentally coincides the the displacement of the vintage 426 Hemi engine) on Nov. 5, 2019. Until then, check out the 2009, 2010, 2011, or 2016 Drag Paks.

Dodge revives Challenger T/A and Charger Daytona trims for 2017

Dodge is reviving the Challenger's T/A trim and the Charger's Daytona line for 2017. Introduced on iconic Woodward Avenue just days before the annual Woodward Dream Cruise kicks off, the new variants promise more performance hardware and sportier aesthetics. We'll start with the two-door. The Challenger T/A, available with either the R/T trim's 5.7-liter V8 or the fire-breathing 6.4-liter Hemi V8, is inspired by the Challenger T/As of old. That means a less restrictive, 2.75-inch active exhaust system and a conical Mopar air filter. But there's no clear bump in output – Dodge still lists the base 5.7-liter at 375 horsepower and the 6.4-liter model at 485 hp. But hey, they're going to look cooler. Unlike the Challenger Hellcat, which should have it as standard, Dodge is including a Satin Black hood on every Challenger T/A. In fact, Satin Black is a recurring theme on this Challenger's front fascia, roof, rear decklid, and T/A bodyside stripes. And yes, the 20-inch Mopar wheels are black, too – they're also an inch wider than normal. Dodge is offering the T/A in three different trims. The base T/A has everything we described above, while the T/A Plus adds some comfort features like heated and vented Nappa leather seats, an 8.4-inch UConnect system with Apple CarPlay/Android Auto, a six-speaker stereo, and a shortcut button for the Dodge Performance Pages. The T/A 392, meanwhile, adds the 6.4-liter V8, even wider wheels, and Brembo six-pot calipers. If you prefer smoking tires with four doors, there's the new Charger Daytona. No, there's not an enormous wing on the back. But Dodge added the same kind of engine/exhaust upgrades found on the T/A while upping the top speed from 135 to 150 miles per hour. Satin Black features prominently again, with hood and rear fender graphics. The roof is also black. Unlike the Challenger, Dodge is only offering two different versions of the Daytona – the 5.7-liter base model and the 6.4-liter version, called the Daytona 392. Prices for the Challenger T/A start at $38,485, including a $1,095-destination charge, while the T/A Plus adds $2,750. Adding the 392 means shelling out $45,090. For the Daytona, you'll need a check for $40,985 for the 5.7-liter or $46,090 for the 6.4-liter. Orders for the Charger Daytona open in September, while the T/A is a month later. Related Video:

Work at a Chrysler dealership, get free college education

The cost of a college education in the US can put a student tens (hundreds, in some cases) of thousands of dollars into debt. FCA US wants to give its dealership employees a leg up, though, and the automaker is now offering a completely free education to them through a partnership with Strayer University. The workers can take any of the college's classes online or on campus through program called Degrees@Work. Currently, the offer is only available to employees Chrysler, Jeep, Dodge, Ram and Fiat dealers in the automaker's Southeast region, which includes Florida, Georgia, South Carolina, North Carolina, Alabama and Tennessee. However, a national expansion will happen before the end of the year, Strayer spokesperson Cristina Henley tells Autoblog. The program will cover all of the students' expenses, including their books, according to Henley. FCA US sees this partnership as a way to improve the talent of its workforce, retain employees longer and possibly attract people wanting to take advantage of this free education. "Many of our dealers have expressed concern over the availability of talent to fill open positions due to business growth and turnover in their stores, especially in metro markets," Al Gardner, the company's Head of Dealer Network Development, said in the Degrees@Work announcement. Strayer has about 40 programs available, including in business administration, accounting, marketing, and more, and the university offers associate's, bachelor's, and master's degrees. It will also give FCA US employees credit for their work experience to get them a diploma even more quickly. FCA US Dealers to Offer Employees No-Cost, No-Debt College Education FCA US teams with Strayer University to develop first-of-its-kind dealer program Degrees@Work program open to all employees of participating dealerships Employees can earn no-cost, no-debt degree through Strayer University All Chrysler, Jeep®, Dodge, Ram and FIAT dealerships may participate First phase of program rollout begins with dealers in the FCA US Southeast Business Center National rollout expected later this year May 4, 2015 , Auburn Hills, Mich. - Employees of Chrysler, Jeep®, Dodge, Ram and FIAT dealerships will have the unique opportunity to earn a no-cost, no-debt college degree through Strayer University's Degrees@Work program, developed in collaboration with FCA US LLC. FCA US is the only company in the automotive industry to offer the program.