1967 Dodge Coronet 440 7.2l on 2040-cars

Auto blog

What is the fastest car in the world in 2024?

It wasn't that long ago that the notion of reaching 200 miles per hour in a car, on a road, seemed basically impossible. As you likely know by now, that time has passed. And once that threshold was crossed, the automotive world immediately began eying the next triple-digit benchmark: 300 miles per hour. It may have taken a little while, but the 300-mph line has been crossed, and some cars have moved well past that seemingly insane speed number. While some of these speeds have been achieved in simulations (including the fastest car listed below), there's little doubt that a driver with nerves of steel and a heavy right foot could indeed push several automobiles up to 300 miles per hour and beyond. Interestingly, it’s not just one car or automaker in the 300-mph club, as a handful of models have earned a place (sometimes claimed but not yet demonstrated) on the leaderboard. The fastest car in the world is: Koenigsegg Jesko Absolut (330 MPH) That title goes to the Koenigsegg Jesko Absolut, which recorded a staggering 330 mph top speed earlier in 2023. The carÂ’s twin-turbocharged 5.0-liter V8 lays down 1,600 horsepower and 1,106 pound-feet of torque, which plays a significant role in delivering that speed, but KoenigseggÂ’s engineers have given the car a lot more than mind-blowing power. The Jesko Absolut has a super-slippery 0.278 drag coefficient and a nine-speed transmission that shifts so quickly itÂ’s almost imperceptible. Koenigsegg calls it a Light Speed Transmission (LST), saying its shifts happen at almost light speed. While that might be a slight exaggeration, the gearbox is impressive, bringing several wet multi-disc clutches and a super lightweight construction. As Koenigsegg says, "the Jesko Absolut is destined to achieve higher, more extraordinary speeds than any Koenigsegg or any other fully homologated car before it." How expensive is the Koenigsegg Jesko Absolut? If you were reading that and wondering how much the fastest car in the world costs, the price tag is just another dizzying number on the Jesko Absolut's spec sheet. All 125 Absolut cars offered sold out at a price of almost $3 million. Of course, being able to afford the Koenigsegg is just the first step in realizing its full potential. There are very few places on the map that can support a 300-plus-mph speed run, and the locations that do are not conveniently located.

Mopar unveils Dodge Challenger Drag Pak [w/video]

Dodge is going drag racing, and it's doing it with an all-new version of the Challenger for NHRA's Sportsman class. FCA's Mopar parts and performance arm announced the new Challenger Drag Pak Friday, showing off a version with a 354-cubic-inch (that's a 5.8-liter, by the way), supercharged V8 and a 426-ci (7.0-liter), naturally aspirated V8 – both Hemis, of course – that can get the big coupes through the quarter-mile in "the eight-second range." While the two engines deliver similar performance, at their base, they're quite a bit different. The supercharged model uses a cast-iron block, while the 426 has aluminum for both the block and head. That said, both models get customized engine calibrations, and are mated to unique, race-spec automatic transmissions. But drag racing is about far more than just outright power. Mopar significantly updated the four-link rear suspension, adding a four-inch rear axle from Strange Engineering, along with an aluminum, nine-inch third member, while the rear-axle housing has been strengthened in general. Both the rear shocks and front struts can be adjusted for rebound and compression, too. Lightweight 15-inch wheels, meanwhile, are shod in super-sticky Hoosier drag radials, with nine inches of tread in back and 4.5 inches in front. The new Challenger Drag Pak should run the quarter-mile in "the eight-second range." In the cabin, there's an NHRA-spec roll cage, a Racepak gauge cluster, and a handsome pair of Sparco racing seats. Outside, supercharged models get blue decals, while naturally aspirated varieties get black stickers, although there's more to the new Challenger dragster's exterior than just its decals. Mopar tweaked the big-scoop hood, promising it's easier to get up to check on the engine, and the designers also added trailer tie-down straps in both the front and rear. While the dragster was the big news today, Mopar officials also announced the two enhanced Scat Pack kits for both the Dodge Charger and Challenger R/T. The 5.7-liter Hemi models gain an extra 56 horsepower and 30 pound-feet of torque in the Scat Pack 2 thanks to a new cam, valve springs, pushrods, and gaskets. The Scat Pack 3, meanwhile, adds 75 hp and 44 lb-ft, on top of the gains from the lower packages. That should be perfect for drivers who wish to snort in the face of their SRT 392-driving friends. The third stage adds a ported cylinder heads, as well as high-flow manifolds and catalysts.

How to tune a car right: Part 3, tuning Mopar with OST Dyno

Not long ago, I wrote a story about a pony car tuned with a supercharger. The blower install had been done properly. Then the car's owner bolted on a set of great looking wheels wrapped in good looking but inexpensive rubber. On my first test drive, I couldn't get any of that supercharged sweetness to the ground. It was the perfect ride for parking in a Burger King parking lot on a Friday night. I tooled around on a Sunday drive, shaking my head that someone had spent five figures to get more power the right way, with a clean install, then wiped out the gains so thoroughly that the stock engine would likely have overwhelmed the tires. This got me thinking about the ways people ruin their quest for horsepower, either on the front end by not insisting on a clean install and paying the money for it, or on the back end with supplemental purchases like cheap tires or cheap gas. So I called three tuners, one focused on GM, one on Mopar, one on Ford, to find out what people should know about how to get the best power for their goals, and how to make sure they are able to use all that power. The first interview in this three-part series was with Blake Leonard at Top Speed Cincy in Cincinnati, Ohio, the second with Brandon Alsept at BA Motorsports in Milford, Ohio. This third and last interview is with Micah Doban at OST Dyno in Slippery Rock, Pennsylvania, a family business with more than 40 years of Mopar expertise specializing in Gen III Hemis, but tuning everything from land-speed cars and drag racers to Jeeps The interview has been edited for clarity and concision. Do people who come to OST generally know what they want? Probably 80% of the people who come in simply want more power with no particular ET goal [ET is a kind of bracket handicapped drag racing – ed.]. WhatÂ’s the best way to start a Mopar tune? The first thing is what people often skip, and that's to find a tuner or a shop. People will throw parts on their cars that the Internet said to, then go to a tuner who does things a different way, and [the tuner is] like ‘No we don't like to use these injectors, we don't like these parts.Â’ You have to find someone familiar with the parts that are on your car or that you're planning to put on your car. So having a goal and then finding a tuner who can help you with that goal is proper way to start. Exactly. And a lot of tuners have their own formula – and when I say tuner I mean someone that also does work to the cars.