Restored Mopar Muscle Car With Rebuilt Hemi And Transmission Solid And Clean on 2040-cars

Auto blog

Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut

Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.

2020 Dodge Challenger Drag Pak will debut at SEMA

Mopar fans have countless reasons to get hyped about the 2019 SEMA show. Speedkore is bringing a twin-turbocharged, all-wheel-drive Dodge Charger Hellcat Widebody, Mopar is bringing a done-up 1968 Dodge D200 "Lowliner," Ram is bringing a diesel 1500 overlander, and Jeep is bringing a custom off-road Wrangler. But the launch of the new 2020 Dodge Challenger Drag Pak might garner the most attention from the brand's most serious customers. Prior to the show, Mopar teased a photo and a short video clip, both showing a new Dodge Challenger from the overhead view. The white Challenger showed a wide blue stripe down the center of the car with two pinstripes along each side. "Powered by SRT" runs across the top of the windshield, and Mopar logos grace both sides of the car just beneath the side windows. Red decals run back from the rear quarter panels and connect across the rear of the car. It also has hood pins on the SRT Hellcat hood and a parachute attached the rear. There's a parachute because this is the factory turnkey drag-race-focused Dodge Challenger racecar. Mopar released no other information on what type of hardware the Drag Pak will be using, or what's under the hood, but the video gives a great preview of the exhaust note in full tire-smoke mode. As some Drag Paks in the past have dropped roughly 1,000 pounds from their production starter vehicles, the 2020 model will surely utilize plenty of weight-savings methods such as the removal of all interior comfort features that don't apply on the racetrack. Mopar has also previously altered the position of the engine and changed the wheelbase to the benefit of better weight distribution. Mopar is set to livestream the unveiling starting at 7:26 p.m. ET (that's 4:26 on the West Coast, which not coincidentally coincides the the displacement of the vintage 426 Hemi engine) on Nov. 5, 2019. Until then, check out the 2009, 2010, 2011, or 2016 Drag Paks.

Before Jay Leno, this 1970 Dodge Charger was a SEMA star

When Jay Leno drives an awesome car, enthusiasts take note, and this week the internet blew up over the 1970 Dodge Charger resto-mod that starred in a recent Garage episode. But you might not remember: this strapping Charger, called "Tantrum," was one of the highlights of the SEMA Show in Las Vegas last fall. Here's another look at a true Mopar monster. The power: Yep, Tantrum has 1,650 horsepower. That's more than two Hellcats worth of power under the hood. It's a twin-turbo 9.0-liter Mercury Racing engine with a quad-cam four-valve setup. Basically, it's a V8 boat motor developed for cars. Mercury Marine is the crew that developed the V8 for the 1990s Chevy Corvette ZR-1. That all-aluminum LT-5 under the hood cranked out 405 hp – an astronomical figure for the time – and helped make the ZR-1 an icon. Take a listen to Tantrum's 9.0-liter Mercury mill below. This content is hosted by a third party. To view it, please update your privacy preferences. Manage Settings. Who's behind all of this? SpeedKore, a Wisconsin-based performance shop that does one-off pro touring builds. It specializes in remaking Detroit muscle with modern features like carbon fiber, bespoke interiors, and powerful engines. SpeedKore is pretty good at it. Before it threw a Tantrum, it did the "Cudinator" used in some of the Fast and the Furious movies. You might not know: Tantrum won the Best Domestic category of the GT Awards at SEMA – chosen by your author. The sinister looks were the hook, and the crazy engine solidified its performance cred. Related Video: Image Credit: SpeedKore Design/Style Dodge Coupe Performance Videos Jay Lenos Garage 1970 dodge charger resto mod