Fully Functional Police on 2040-cars

Auto blog

Chrysler recalling over 200k vehicles across its brands

With more than 200,000 units across six separate recalls and almost all of its brands, it appears that Chrysler has officially jumped headfirst into the recall pool this month. The National Highway Traffic Safety Administration has issued three official recalls for the automaker, and The Detroit News is reporting that the automaker itself has announced three more.
The biggest of the recalls applies to about 120,000 Dodge Charger, Dodge Challenger and Chrysler 300 models for 2011 and 2012 due to faulty wiring harnesses for the seat-mounted side airbags, which could lead to these airbags not deploying in the event of a crash. A little more than 60,000 two-wheel-drive versions of the 2007-2008 Dodge Nitro and 2008 Jeep Liberty SUVs are being recalled due to a heat shield that could cause the driveshaft to break, which if that isn't bad on its own, could then hit underneath where the airbag sensor is mounted, causing the airbags to deploy. Wrapping up NHTSA's recall notices, about 20,000 Jeep Patriot and Jeep Compass models for 2012 are also being recalled due to a problem with the fuel tank transfer tube that could lead to the vehicle stalling. The LX car recall campaign is going into effect this month, while the other two will start next month - all three notices are posted below.
In addition to the official NHTSA recalls, The Detroit News is also reporting that Chrysler is recalling more than 16,000 Ram trucks and a small number of Dodge Dart sedans. Around 6,500 2013 Ram 1500 trucks will be recalled due to an improper adjustment of the parking brake cable from the factory, while 7,000 Cummins-powered 2013 Ram Heavy Duty trucks are being recalled due to an engine cover that does not have as much heat resistance as it is supposed to. Finally, a total of 46 Dodge Dart sedans are being recalled due to a problem with the brake calipers and/or parking brake.

What's the deal with Chrysler demanding colleges crush their Vipers? [w/video]

Students and teachers at a Washington community college are up in arms following an order from Chrysler that it must destroy the pre-production Dodge Viper that was donated to the school's automotive technology program ten years ago.
The Viper in question is said to be the fourth off the production line, based on its VIN, and has had its emissions controls disabled, allowing its ten-cylinder engine to produce 600 horsepower, according to a report from Yahoo! Autos. As one of the first Vipers ever produced, the school's AT instructors claim it could be worth $250,000 in a museum, while a local news report purports that Jay Leno once tried to purchase the car, but the sale was prevented by Chrysler.
As pointed out by our friends at Autobytel, though, there are a lot of things in this story that don't quite add up. Immediately noticeable from the news report embedded below - which shows the car at South Puget Sound Community College - is that the car in question is not a 1992 model. When the Viper went on sale in 1992, it was only available as an RT/10 with a (flimsy) soft top, like the red car shown above. But the car featured in the report from KING5 News (inset image) is clearly a hardtop Viper GTS, which didn't enter production until 1996. And even if, as reported by a local newspaper, the hardtop featured is a prototype, it doesn't explain the lack of another iconic feature of the first Vipers - their distinctive side pipes. This kind of pokes holes in the school's argument that this is the fourth Viper to ever roll down the line. At best, this appears to be a pre-production Viper GTS.

Inner Demon revealed: 840 hp and other jaw-dropping details

After months of teasers, rumors, cryptic messages, and veiled hints, the 2018 Dodge Challenger SRT Demon is finally here, and it's as wonderfully insane as we hoped it would be. Finally we know the facts and figures that Dodge has been hinting at for so long. 840 horsepower. 770 lb-ft of torque. 2.3 seconds to 60 mph. A quarter-mile run of 9.65 @ 140 mph. While pricing hasn't been announced, Dodge is trying to keep it under $100,000. That horsepower figure makes this the most powerful production V8 ever. With those 0-60 and quarter-mile times, it's also NHRA certified as the quickest production car ever. Someone with the means needs to line a Demon up against a Tesla Model S P100D. All that power and all of the Demon's trick launching software and hardware will throw a driver back against their seat with 1.8 Gs. Drivers will be seeing a bit of sky, as the Demon is the first production car to pull a wheelie from a dead stop. Yes, this is all totally and 100 percent street legal. View 48 Photos In order to make all this power, the red-painted supercharged 6.2-liter Hemi V8 has been significantly improved over the Hellcat. It's equipped with a larger 2.7-liter supercharger that turns the boost up to 14.5 psi, redlines at 6,500, and has what Dodge is calling SRT Power Chiller, a system that uses the air conditioning to cool the air coming in through the new Air Grabber hood scoop. In order to keep your engine running time and time again, there is an after-run cooler than cools the supercharger after the car is shut off. The pistons and connecting rods have been strengthened to deal with the higher load. In order to feed enough juice into the engine, the Demon uses dual fuel pumps. We assume that a decent EPA rating wasn't on the top of the engineer's list. Oh, and the Demon can run on 100-octane with the press of a button. With the traditional SRT black and red keys, the Demon actually has three horsepower ratings: 500 with the black key, 808 with the red key, and the full 840 with the red key and 100-octane fuel. Don't worry, even if you have the black key, the Demon will drop the 1/4 mile in 11.59 seconds, still quicker than almost anything around. Most of the rest you already know from the seemingly endless teasers. The Demon wears lightweight wheels with sticky 315/40R18 Nitto drag radials at all four corners.