2012 R/t Used 5.7l V8 16v Automatic Rwd Sedan on 2040-cars

Auto blog

500+ hp Stellantis 'Hurricane' I6 previews a world without Hemis

After years of rumored development, Stellantis has revealed its new six-cylinder engine family. The 3.0-liter, twin-turbocharged "Hurricane" I6 will offer V8 power, forced induction torque and six-cylinder efficiency in a package designed to fit into any of the company's North American rear-wheel-drive platforms.  What is "V8 power," exactly? Well, in standard output guise, the new I6 cranks out more than 400 horsepower (the specific figure will vary by application) and 450 pound-feet of torque, while the high-output variant is good for more than 500 horses and 475 lb-ft. The final figures will be dependent on the application. We'll save you a little legwork: In current Ram, Jeep and Dodge products, the 5.7-liter Hemi tops out at about 395 hp and 410 lb-ft, give or take, and the 6.4-liter around 485 hp and 475 lb-ft.    This is a clean-sheet design that is only related to the company's turbocharged four-cylinder by some common measurements. The I6 is exclusively direct-injection (no hybrid/port-injection here) and the two I6 variants share 96 common parts, including the block and oil pan design. The differences are found in their internals, intake plumbing, valvetrain components and the turbochargers themselves. Stellantis is not yet ready to share specs or supplier info for the turbos but says announcements will come from its partners soon.  The standard-output I6 has a compression ratio of 10.4:1 and revs to 5,800 rpm. It will run on regular fuel, albeit with reduced performance; 91 octane is recommended for maximum output. The high-output variant has a compression ratio of 9.4:1 and will rev to 6,100 rpm. That one will require premium. The new I6's advantages go beyond basic power output. Every Hemi family engine currently in production is based on an iron block design, so they're heavy. The aluminum-block I6 shaves weight off the total engine package, even if some of that gets added back thanks to the turbos and their associated plumbing. The standard-output I6 weighs 430 pounds, Stellantis engineers told us; the high-output adds just another 11. Fully dressed 5.7-liter V8s are in the 550-560-pound ballpark, and 6.4-liters close in on 600 pounds.  You may be wondering, "Why a clean-sheet gasoline engine now, when the industry is moving toward battery-electrics?" A valid inquiry, and one Stellantis was prepared to address. While the company will be pivoting to electrification over the next decade, it won't be instantaneous.

2020 Colorado Winter Driver's Notes | Behind the Wheel S02 // E12

2020 Mercedes-AMG GLC 63 I’ve had bad luck with SUVs this winter. Especially performance ones. First, I got a 2019 Range Rover Sport SVR delivered on summers right as two feet of snow fell, rendering it undriveable. Then, coronavirus cancelled Easter Jeep Safari as well as my trip out to Moab in the 2020 Jeep Wrangler Rubicon Diesel. Thankfully, when this 469 horsepower luxury mall crawler was dropped off, the sun shone down and the snow (mostly) held off.  The first thing that I noticed was there were a few blank buttons throughout the cabin, something that you may see in an entry model vehicle, but IÂ’m not accustomed to seeing in an AMG. Not a great look for a vehicle with an $80,000 price tag. Thankfully that was where the disappointment ended. As soon as you press the start button, the engine fires up and the exhaust note is incredible. Hopping on the highway ramp near my house, I floored it, and the biturbo V8 had me pressed back into the driver's seat, and this wasnÂ’t even the S version that our staff drove last year. Inside and out, the GLC 63 was everything youÂ’d expect from Mercedes. The interior was immaculate, and while the infotainment wheel and touch pad may take some getting used to for someone who isnÂ’t familiar, by now I have it down so that I can use it without looking. And while the V8 left me smiling ear to ear, I was most impressed by the amount of useable interior space there is. I happened to be moving at the time of this review and while all of my large furniture was shoved into the back of a moving van, I was able to fit almost everything else in the back of the GLC. 2019 and 2020 Fiat 500X Trekking ItÂ’s hard to say goodbye to an AMG and then turn around and be excited when a Fiat 500X pulls in your driveway (I know, I know, automotive journalist problems). That being said, when the red Fiat pulled up, I found myself admiring it. I am very familiar with the 500X. Back in 2016 Autoblog had one for a year as our long term test vehicle. I drove that car everywhere, multiple trips up north in Michigan, and even tracked it at Gingerman Raceway for a few laps before the brakes started smoking.  The 2019 model I had in my driveway and the 2020 model I drove in the snow up in the mountains feel very similar to that car. The interior is stylish and surprisingly roomy. The greenhouse is airy.

China own a Detroit automaker? Would the U.S. let that happen?

The news that several Chinese automakers want to buy Fiat Chrysler Automobiles, and that one has even made an offer, elicits some mixed feelings. On one hand, as some have pointed out, it could be a win-win both for China and for FCA's American workers, ensuring the company's survival and opening new markets. On the other hand, this is China, whose trade relationship with the U.S. is the source of considerable scrutiny from the Trump administration — and whose not-a-friend, not-an-enemy status is particularly difficult to gauge right now during heightened tensions with its client state North Korea. So would such a deal pass regulatory muster? One reason that springs to mind for blocking any sale has to do with national security. Chrysler's role as a military supplier dates back to Dodge trucks used by Gen. Blackjack Pershing to chase Pancho Villa in Mexico, and shortly thereafter by American forces in World War I. The Detroit Three automakers were, of course, mainstays of the Arsenal of Democracy of World War II. Even before U.S. entry into the war in December 1941, America's industrial machinery went into overdrive, and Chrysler was one of the biggest cogs. It engineered and built the M3, Sherman and Pershing tanks and trucks for Gen. George Patton's Redball Express. It helped develop a radar-guided antiaircraft gun that knocked German bombers and V1 rockets out of the sky — on one day, shooting down 97 of 101 V1s headed for London. On D-Day, the radar system helped thwart Luftwaffe counterattacks on the beaches of Normandy, and it later helped Allied forces break out at the Battle of the Bulge. Chrysler redesigned the Wright Cyclone engines used by the Boeing B-29 Superfortress, the plane that firebombed Tokyo and dropped the atomic bombs that ended the war. Chrysler even played a secret role refining uranium in Oak Ridge, Tenn., that was used in the Hiroshima bomb and in the ensuing Cold War arms race. It worked on military missiles and was NASA's prime contractor for the Saturn V rocket that put men on the moon. More recently, Chrysler produced the M1 Abrams tank. And of course Chrysler is the keeper of the flame for Jeep, a 75-plus-years military legacy handed down from Bantam and Willys to Kaiser to AMC to Chrysler. The point of this history lesson is to note that in times of war or national emergency, America's industrial might has been called to serve, and may well be called on again.