Srt8 Coupe 6.1l on 2040-cars
North Olmsted, Ohio, United States
Vehicle Title:Clear
For Sale By:Dealer
Engine:6.1L 6059CC 370Cu. In. V8 GAS OHV Naturally Aspirated
Body Type:Coupe
Fuel Type:GAS
Make: Dodge
Warranty: Unspecified
Model: Challenger
Trim: SRT8 Coupe 2-Door
Number of Doors: 2
Drive Type: RWD
Mileage: 7,051
Number of Cylinders: 8
Sub Model: SRT8
Exterior Color: Silver
Dodge Challenger for Sale
2011 dodge challenger r/t
1973 dodge challenger rallye in great condition! stored inside for last 13 years(US $16,750.00)
1974 dodge challenger rallye hardtop 2-door 360 cid 4 spd #'s matching !!!!!(US $23,500.00)
3.6l v6 auto push start mp3 anti-theft alloy wheels power seat cruise control
3.6l v6 auto push start mp3 anti-theft alloy wheels power seat cruise control
2010 dodge challenger srt 8 fuscia(US $29,900.00)
Auto Services in Ohio
West Chester Autobody Inc ★★★★★
West Chester Autobody ★★★★★
USA Tire & Auto Service Center ★★★★★
Trans-Master Transmissions ★★★★★
Tom & Jerry Auto Service ★★★★★
Tint Works, LLC ★★★★★
Auto blog
Junkyard Gem: 1987 Dodge Ram 50 with V8 swap
Sun, Aug 11 2024Chrysler did very well selling Mitsubishi Forte pickups with Plymouth and Dodge badging in the United States, even after Mitsubishi began moving the same trucks out of their own American dealerships in 1982. The 1987 Ram 50 2WD short bed weighed in at just over 2,500 pounds, so it was reasonably perky with its 2.0-liter G63B four-banger making 90 horsepower… but there's no replacement for displacement! At some point along the line, a Chrysler small-block V8 engine found its way into the engine compartment of this truck, now residing in a car graveyard in Sparks, Nevada. This was the cheapest new Dodge-branded pickup Americans could buy as a 1987 model, though it had to compete with its near-identical Mitsubishi Mighty Max twin for sales. The 1980s were great times for little pickups in the United States, but a desire for bigger cabs and more creature comforts doomed them by the dawn of the following decade. The most interesting thing about this engine swap is that it didn't involve a Chevrolet or Ford small-block V8. Both the Chevy small-block and Ford Windsor V8s are a few inches narrower than the Chrysler LA-series V8, which makes them easier to stuff into a small vehicle. It appears that engine length was the critical dimension in this case, since the Mopar seems to have had enough side-to-side clearance to avoid any slicing of Mitsubishi steel to make it fit. My guess is that whoever did the swap happened to have the engine handy and that's why it's here. Keeping it all Dodge might have been a factor in the decision as well, though the truck's Mitsubishi ancestry makes that unlikely. It was over 100°F out when I found this truck, so I wasn't motivated to check block casting numbers to determine exactly which LA engine we're dealing with here. The easiest LAs to get cheap for the last four or so decades have been the 318 (5.1-liter) and the 360 (5.8-liter), so one of those two is the most likely candidate here. Power levels for these engines got pretty dismal during the Malaise Era, but anyone with the wrenching skills to do this swap would have applied some basic power-enhancing wizardry before the engine went in. We can see there's an Edelbrock Performer intake manifold, and you might as well stab in a better camshaft if you're upgrading the intake. How much power? With a four-barrel carburetor on a dual-plane intake plus a meaner cam, 300 to 350 horsepower is easily achieved with one of these engines, even with stock exhaust manifolds.
2013-14 Dodge Viper recalled over faulty door handles
Fri, Apr 10 2015The 2013-14 Dodge Viper is getting a voluntary recall affecting 1,762 cars worldwide to replace their door-handle assemblies. Of the affected vehicles, FCA US reports there are 1,451 in the US, 160 in Canada, 17 in Mexico and 59 of them outside of NAFTA. After receiving three reports of doors either not closing or opening while driving a low speeds, FCA US engineers found a new sealant from a supplier didn't provide sufficient moisture protection to the electronic switches for the door latches. If the parts get wet, this can potentially cause a short circuit. The automaker is quite clear that are no reports of accidents of injuries from this problem. As always, the recall repairs will be done at no cost to owners, and FCA US will be getting in touch with customers soon about the problem. Related Video: Statement: Door-handle Assemblies April 9, 2015 , Auburn Hills, Mich. - FCA US LLC is voluntarily recalling an estimated 1,762 cars globally to replace their door-handle assemblies. FCA US launched an investigation after the Company received three warranty claims linked to doors that failed to close or opened inadvertently while vehicles were moving at low speed. The Company is unaware of any related injuries or accidents. Engineers determined a sealant, newly adopted by a supplier, provided inconsistent moisture protection to the electronic switches that control the door latches. Switches exposed to moisture may short-circuit. Affected are approximately 1,451 model-year 2013-14 Dodge Viper SRT cars in the U.S.; 160 in Canada; 17 in Mexico and 59 outside the NAFTA region. Affected customers will be notified and advised when they may schedule service, which will be performed at no cost. Customers with questions may call the FCA US Customer Information Center at 1-800-853-1403.
Real-life Bravado Banshee from Grand Theft Auto up for sale
Sun, 01 Jun 2014Remember the Bravado Banshee that West Coast Customs built last year to promote Grand Theft Auto V? Given away by GameStop, the woman who won it says she's better off with money to send her two kids to college than with a race car, so now you can steal buy it on eBay.
Based on a 2006 Dodge Viper SRT-10, every exterior panel was redesigned to match the Banshee, and the red embroidered badging inside won't let you forget it. There's still that V10 up front that can make some kind of racket, and a SEMA-worthy stereo filling the entire trunk to make a different kind of racket. Oh, it's also got hood struts that have crapped out, so you'll notice the hood is held up with a wooden rod.
The auction ends on June 5, and you can make an offer or hit the Buy It Now button and hand over $170,000. Might be time to change the outfit and run a few jobs for some quick cash.