2011 Dodge Challenger Srt8 392 Hemi Inaugural Edition *520 Miles* on 2040-cars

Auto blog

Dodge Demon makes so much torque, it needs stronger driveline parts

Torque is a lovely thing, a sweet and wonderful force that twists and pulls and can help propel a two-ton metal box forward at comical speeds. Torque is also fickle and will bend and break those same metal parts without a second thought, which is why the new Dodge Demon is compensating for its increased torque with some new re-engineered and reinforced parts. And there's software intended to combat wheel hop, which one of the most dramatic ways torque can break stuff. Week 8's video, "Race-hardened Parts," gives a hint towards what all these new parts can do. While we still don't know how much torque the Demon will throw out, we do know it's enough to warrant an upgraded prop shaft, half shafts, and a differential housing. The Challenger Hellcat, which is the basis for the Demon, makes 650 pound-feet of torque already. The new parts will go a long way toward making sure the work from the Demon's engine is properly translated into motion by those Nitto drag radials. The new prop shaft uses high-strength steel, heat-treated stub-shafts, and increases the tube thickness by 20 percent for a 15 percent increase in torque capacity. Additionally, Dodge says the upgraded differential housing allows for a 30 percent increase in torque capacity by using heat-treated A383 aluminum alloy and a higher strength shot-peened gear set. The 41-spline half shafts that deliver 20 percent increased torque capacity through the use of high-strength low alloy steel and 8-ball joints. In addition to the hardware, the Launch Assist software has been tuned to help alleviate wheel hop. Dodge says the Demon is the first factory production car that uses wheel speed sensors to detect hop and momentarily cut torque to compensate. This means a driver can keep their foot planted on the floor while the computer sorts out the traction. Previously, the best solution was to back off the throttle to manually cut the load. Finally, the Dodge Demon will offer a four-point harness mounting bar as an optional accessory. The part will be supplied by Speedlogix and fits in place of the deleted rear seat. Customers can install the bar without having to hack apart their cars to find a proper mounting point. Look for more teasers and info on ifyouknowyouknow.com in the lead-up to the Demon's debut at the 2017 New York Auto Show. Related Video: Image Credit: FCA Dodge Performance dodge demon dodge hellcat

Chrysler Recalling Nearly 907,000 Cars, SUVs

Nearly 907,000 Chrysler, Dodge and Jeep SUVs and cars are being recalled for alternators that can fail and heated power mirror wiring that can short and cause minor fires. The recalls, posted Thursday by U.S. safety regulators, push the total number of recalls so far this year 544, totaling a record of more than 52 million vehicles. The largest of Thursday's recalls covers nearly 470,000 Jeep Grand Cherokees, Chrysler 300s, and Dodge Chargers, Challengers and Durangos from the 2011 through 2014 model years. The alternators can fail, causing the 3.6-liter V6 engines to stall unexpectedly. The problem also can cause the electrical system to fail, as well as knock out power-assisted steering, antilock brakes and electronic stability control. It can even cause fire or smoke, according to documents Chrysler filed with the U.S. National Highway Traffic Safety Administration. NHTSA opened an investigation into the problem in July, and Chrysler began its own probe in August. The company analyzed warranty complaints and alternators that had failed. The alternator generates electricity to recharge the battery and run other devices. Chrysler investigators traced the problem to heat fatigue in an alternator diode. Chrysler said it received 322 complaints about the problem, while 55 people complained to NHTSA. The company said it knows of one crash related to the problem, but no injuries or fires. The company will replace the alternators with upgraded versions for free. Owners will be notified in November. The company says customers who see warning lights or suspect a problem should contact their dealers. The recall affects cars and SUVs sold mainly in the U.S. and Canada, but some were sold in Mexico and overseas markets. The second recall covers almost 437,000 Jeep Wranglers from 2011 through 2013. Water can find its way into the heated power mirror wiring harness and cause corrosion. That can cause a short and could cause a minor fire and smoke, as well as cause loss of function of the mirror. The problem was discovered in February after three Wranglers in Canada were damaged. Chrysler says it has 26 complaints about the problem, but it knows of no fires, crashes or injuries. Dealers will move the wiring and install a protective shield to keep water out at no cost to owners, starting in December. Most of the Wranglers are in the U.S., Canada and Mexico, but more than 78,000 were sold overseas.

Dodge Charger and Challenger will live on, but a new Viper is unlikely

BALOCCO, Italy — As FCA's latest five-year plan was presented last week, most of the day was focused on four brands — Jeep, Ram, Maserati and Alfa Romeo. That left a lot of people wondering about the future of the Chrysler, Fiat and Dodge nameplates. At the last five-year event, Dodge was one of the main features. We heard plans for an expanded lineup that included refreshed versions of the Viper, Challenger and Charger, the last two riding on the Alfa Romeo Giorgio platform. Times sure have changed. Dodge isn't going away, but the brand will be narrowed and focused. Performance is the name of the game, but don't look for a new Viper anytime soon. FCA CEO Sergio Marchionne simply said it's "not in the plan." Marchionne thought it was a great idea but that it couldn't live on as a standalone product. If it does eventually return, expect it to share parts with other FCA products, possibly with one of the upcoming Maseratis. On the other hand, Marchionne confirmed that both the Dodge Challenger and Charger will continue to live on. In the last five-year plan, FCA said that the pair would share underpinnings with future Alfa Romeos. That was promising news for those hoping for smaller, lighter versions of each model that would be better suited to fight models like the Ford Mustang and Chevy Camaro. It seems the Alfa Romeo platform is off the table. Marchionne said the current LX platform would indeed live on, though it would be "unrecognizable" compared to what we have today. The LX architecture is ancient, and, although it's been continuously updated, its basic bones date back to the DaimlerChrysler days. Marchionne said that the Alfa platform just doesn't have the character American shoppers are looking for in those vehicles. It's unclear when the next iteration of the Charger and Challenger will arrive, but expect another refresh sometime before 2022. Look for an updated version of the tried-and-true Hemi V8. Rumors continue to swirl about a larger and more powerful 7.0-liter variant dubbed the Banshee, but we'll have to wait and see how that pans out. Related Video: This content is hosted by a third party. To view it, please update your privacy preferences. Manage Settings.