2010 Dodge Challenger Srt-8, Low Miles, Fully Loaded, Clean Inside And Out on 2040-cars

Auto blog

Watch these Dodge Demons explode on a Texas drag strip

The Dodge Challenger SRT Demon is extremely quick. It can hit 60 mph from a dead stop in less time than it takes to read this sentence thanks to its supercharged 6.2-liter V8. That engine makes up to 840 horsepower and 770 pound-feet of torque, depending on what octane is running through the fuel lines. That's a ton of power going solely to the rear wheels. So much so that Dodge developed a number of features and a new set of tires specifically for the car. In our time with the Demon, the car took abuse run after run on a drag strip without skipping a beat, but it seems some actual owners aren't quite so lucky. Just take a look at what happened to a few of these cars. You can see the whole car shake and jitter right as the whole rear explodes in front of the tree. It seems the initial shock from the launch — the most taxing bit of any drag run — is what kills the differentials. Catastrophic failure is rarely pretty, but it is neat to see the whole thing occur in slow motion. Three more cars — four stock and one modified in total — suffered similar fates. Not a great look for Dodge or SRT. According to The Drive, a private drag event in Texas drew a number of Demon owners all trying to beat NHRA NHRA Top Fuel racer Leah Pritchett's time in her personal Dodge Demon — 42 stock Demons attended along with five modified cars. While no one managed to match her 9.65-second quarter-mile run, a few owners did dip below 10 seconds. Now, there are a few of caveats we must address. First, with any modified car, you run the risk of breaking something, even with a car that's set up from stock specifically for drag strips. Even a set of tires like the Mickey Thompsons shown in the video above can have an effect on driveline components. Horsepower may be king, but it's torque that's the rear killer. All that torque sends a shock through the car. Adding even more with aftermarket parts increases the risk of something failing. The modified car was apparently pushing out about 1,000 horsepower. That said, four of the five vehicles were stock, so any extra power or torque should theoretically be a non-factor. The drag strip's surface was maintained by a company called Mass Traction. FCA used Mass Traction during the Demon's development, so that too should be a non-factor in the part's failure. It's unclear what exactly caused the failures, though The Drive reports that FCA officials are investigating the matter. Related Video: This content is hosted by a third party.

No wing, no Hemi. This Dodge Charger Daytona is two-tone and tufted

In between the Dodge Charger Daytona's 1969 debut as a wild, winged NASCAR warrior and the current 2020 Charger SRT Hellcat Widebody Daytona 50th Anniversary Edition with its monster 717-hp Hemi V8, the nameplate had some ... less-glorious years. The nameplate first resurfaced in 1975, when the Charger moved into the "personal luxury" space as a riff on the Chrysler Cordoba. This 1975 Charger Daytona might not be the model's heyday, but damn if this clean machine, surfaced by Barnfinds.com, isn't striking in its own Me Decade kind of way. And this low-miles example is on offer right now on eBay motors. Outside, this dynamic Dodge sports two-tone silver and blue paint, alloy wheels with white-letter tires, and a power sunroof. Inside, we find high-backed split-bench seats with button-tufted vinyl (no "rich Corinthian leather" here). Raising the miles-long hood reveals a 400-cubic-inch, 4-bbl V8, which for 1975 packed 190 horsepower. A far cry from today's 717 horses, perhaps, but still an upgrade over the Charger's standard 360-cubic-inch V8. It may not be the car that pops immediately to mind when someone says, "Charger Daytona," but with less than 12,000 miles showing, this mid-Seventies example is a time warp to a lesser-known era for the marque.   Featured Gallery 1975 Dodge Charger Daytona Dodge Coupe Classics

Cars.com runs 11-second quarter with Dodge Charger Hellcat

The Dodge Charger SRT Hellcat and its Challenger sibling are two of the heroes of the modern performance world. With a headline-grabbing 707 horsepower from a supercharged 6.2-liter V8, their output even shames many supercars. But how quick can one really cover a quarter mile? Cars.com recently decided to find out by taking a Charger Hellcat to the drag strip to see if the sedan lived up to Dodge's 11-second claims. The results were quite impressive. After 13 quarter-mile runs of adjusting variables like the tire pressures and the car's various electronic aids, the Charger Hellcat managed a pass in 11.03 seconds at 126.61 mph – the pinnacle result of the day. This car was mechanically stock and wore the optional Pirelli P Zero tires. According to Cars.com, other quick sprints reached 11.09 seconds and 11.1 seconds, which even beat the site's 11.41-second best from a Challenger Hellcat last year. Getting the Hellcat's prodigious power down without losing traction was a challenge, even on the summer tires. Cars.com thought it had a run that could have dropped below 11 seconds, but then the wheels spun. Using the factory-recommended pressures, the Charger Hellcat was no still slouch with an 11.27-second time recorded, but taking things down to 25 psi proved the quickest at the strip. We already knew that the Charger Hellcat was a wonderful vehicle for eating up huge gulps of asphalt at high speeds and could verify its 204-mile-per-hour top speed (quite a bit faster, incidentally, than the Ferrari California T's 196 mph top-speed). Apparently, the 11-second quarter-mile claim is just as accurate. Also, for any curious owners, the Cars.com story divulges many of the tweaks required to reach this seriously quick time. Related Video: