2010 Dodge Challenger R/t Coupe 2-door 5.7l on 2040-cars

Auto blog

2015 Dodge Viper getting small increase in power

The Viper is used to being the most powerful car in the Dodge and SRT stables, but the arrival of the 2015 Dodge Challenger SRT Hellcat means that's no longer the case. The serpentine supercar is, however, reportedly getting a small boost in output for 2015, amounting to all of five horsepower.
The increase was uncovered by Road & Track courtesy of the SAE J1349 certification process to which Detroit's Big Three automakers submit themselves and which reports the Viper's output at 645 hp instead of the 640 it was rated at until now. There are a hundred factors that could have contributed to the relatively mild boost in output (best guess? nothing at all changed...), but we doubt anyone's going to complain about some extra horses under the hood.
The five-horsepower boost brings the Viper that much closer to the 650-hp Chevy Corvette Z06, not to mention the 707-hp Hellcat, but the Viper's impressive power-to-weight ratio ought to mean it'll have little problem keeping up in a straight line - which is just one of the reasons why Chrysler won't shoe-horn the Hellcat into the Viper: as R&T points out, the supercharged engine is too heavy and the blower makes it too tall to fit in the Viper's engine bay.

Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut

Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.

2015 Dodge Challenger Drag Pak previewed

Dodge and Mopar have never strayed far from success in drag racing, be it on run-what-you-brung nights at the local strip or at the highest levels of the sport. Hoping to both add to that heritage and capitalize on some of the media spotlight that's shown so brightly on the brand of late, Dodge has given us our first look at the 2015 Mopar Challenger Drag Pak test car.
Though this first iteration doesn't make use of the 707-horsepower Hellcat engine, it seems to be a pretty formidable racing package. Starting with a stock '15 Challenger, Mopar adds a full roll cage built to National Hot Rod Association specs. Rubber front and back is drag racing-ready as well, with 28x4.5-inch tires in the front, and fat 30x9-inch tires out back - all from Hoosier.
Powering the beast is a massive 426-cubic-inch (7.0-liter) Hemi Race V8, with output levels that are still unspecified. A Chrysler 727 automatic transmission connects up to a racing style shift lever, with integral line lock.