2008 Dodge Challenger 2dr Cpe Srt8 on 2040-cars

Auto blog

500+ hp Stellantis 'Hurricane' I6 previews a world without Hemis

After years of rumored development, Stellantis has revealed its new six-cylinder engine family. The 3.0-liter, twin-turbocharged "Hurricane" I6 will offer V8 power, forced induction torque and six-cylinder efficiency in a package designed to fit into any of the company's North American rear-wheel-drive platforms.  What is "V8 power," exactly? Well, in standard output guise, the new I6 cranks out more than 400 horsepower (the specific figure will vary by application) and 450 pound-feet of torque, while the high-output variant is good for more than 500 horses and 475 lb-ft. The final figures will be dependent on the application. We'll save you a little legwork: In current Ram, Jeep and Dodge products, the 5.7-liter Hemi tops out at about 395 hp and 410 lb-ft, give or take, and the 6.4-liter around 485 hp and 475 lb-ft.    This is a clean-sheet design that is only related to the company's turbocharged four-cylinder by some common measurements. The I6 is exclusively direct-injection (no hybrid/port-injection here) and the two I6 variants share 96 common parts, including the block and oil pan design. The differences are found in their internals, intake plumbing, valvetrain components and the turbochargers themselves. Stellantis is not yet ready to share specs or supplier info for the turbos but says announcements will come from its partners soon.  The standard-output I6 has a compression ratio of 10.4:1 and revs to 5,800 rpm. It will run on regular fuel, albeit with reduced performance; 91 octane is recommended for maximum output. The high-output variant has a compression ratio of 9.4:1 and will rev to 6,100 rpm. That one will require premium. The new I6's advantages go beyond basic power output. Every Hemi family engine currently in production is based on an iron block design, so they're heavy. The aluminum-block I6 shaves weight off the total engine package, even if some of that gets added back thanks to the turbos and their associated plumbing. The standard-output I6 weighs 430 pounds, Stellantis engineers told us; the high-output adds just another 11. Fully dressed 5.7-liter V8s are in the 550-560-pound ballpark, and 6.4-liters close in on 600 pounds.  You may be wondering, "Why a clean-sheet gasoline engine now, when the industry is moving toward battery-electrics?" A valid inquiry, and one Stellantis was prepared to address. While the company will be pivoting to electrification over the next decade, it won't be instantaneous.

Mopar teases four of 'nearly 20' SEMA Show concepts

Yesterday it was Chevrolet. Today, Mopar has dropped some SEMA knowledge, releasing a quartet of teaser images that give us some indication of what kind of cars, trucks, and crossovers Fiat, Chrysler, Dodge, Jeep, and Ram will be showing in Las Vegas. Like Chevy, Mopar's concepts utilize both production and concept accessories, although Fiat Chrysler has gone a bit more indepth on at least one of its concepts. Immediately, the most tantalizing teaser is the one shown above. Yes, that's the back of a Challenger, and aside from the bright orange accents on the gray body, you should take notice of the badge mounted on the spoiler – yes, that says "GT AWD." To be honest, such a vehicle wouldn't be a huge shock, as both the Challenger's LX platform-mates, the Dodge Charger and Chrysler 300, are offered with all-wheel-drive options. Still, adding such a vehicle to the production cycle would give Dodge a leg up on the rear-drive only Ford Mustang and Chevrolet Camaro. Aside from that concept, FCA has also released teasers of a Ram-based concept, a 300-based concept, and what we're guessing is a Fiat 500X. We can't wait to see what the actual Fiat concept has to do with kiteboarding. As for the 300 and Ram, there's not a lot of hints on what sort of styling details they'll contain. The Chrysler has additional LED accents and what we're guessing is matte blue paint, while the Ram is based on a Hemi-powered 1500 with Rebel styling cues. This is just a very tiny sample of Mopar's final SEMA roster, which include "hundreds" of parts. There should also be a total of 20 vehicles covering all four former Chrysler Group brands, as well as Fiat. Naturally, we'll have plenty to report on each vehicle once the SEMA show kicks off in the next couple weeks.

2013 Dodge Durango R/T

Not too long ago, Chevrolet got itself into some trouble by throwing the SS badge on just about everything it produced, so I've always been a little hesitant about the seemingly excessive use of the R/T nameplate on Dodge vehicles. For the 2013 model year, every model in Dodge's lineup has an R/T trim level from Dart all the way up to the Durango. Although the R/T name used to signified models made for road and track, I doubt anyone would be delusional enough to assume the Durango - and some of the other models wearing this badge - are suited for any sort of track duty.
Still, when this 2013 Dodge Durango R/T rolled up for me to drive for the week, I couldn't help but take in its big, mean and imposing stance. Sure, if I had my choice of buying any of the Dodge R/T products, the Charger and Challenger would be my top picks for sure, but it's easy to say that the Durango would be a close third - far above the R/T versions of the Avenger, Journey and Grand Caravan.
Driving Notes