12 Srt8 392 Hemi 6-spd Manual Leather Suede Interior Navigation 17k Aluminum Rim on 2040-cars

Auto blog

Dodge Dart Mopar '13 special edition recalled over airbag woes

Dodge is only building 500 examples of the black-and-blue Mopar '13 Dart, but the majority of them are now being recalled. Part of the Mopar upgrade included replacing the stock seat skins in the Dart with black and blue Katzkin leather, but the seat-mounted side airbags were reinstalled improperly during the upfitting process, which could affect the performance of the front seat side airbags.
According to the official National Highway Traffic Safety Administration bulletin, a total of 374 Mopar '13 cars are being recalled due to side airbags that might not deploy in a side-impact collision. There have been no reports of the airbags not going off, but Chrysler will still need to reinstall the bags to ensure proper deployment. The recall notice is posted below, which gives information for Mopar '13 owners to contact Chrysler and NHTSA.

Watch these Dodge Demons explode on a Texas drag strip

The Dodge Challenger SRT Demon is extremely quick. It can hit 60 mph from a dead stop in less time than it takes to read this sentence thanks to its supercharged 6.2-liter V8. That engine makes up to 840 horsepower and 770 pound-feet of torque, depending on what octane is running through the fuel lines. That's a ton of power going solely to the rear wheels. So much so that Dodge developed a number of features and a new set of tires specifically for the car. In our time with the Demon, the car took abuse run after run on a drag strip without skipping a beat, but it seems some actual owners aren't quite so lucky. Just take a look at what happened to a few of these cars. You can see the whole car shake and jitter right as the whole rear explodes in front of the tree. It seems the initial shock from the launch — the most taxing bit of any drag run — is what kills the differentials. Catastrophic failure is rarely pretty, but it is neat to see the whole thing occur in slow motion. Three more cars — four stock and one modified in total — suffered similar fates. Not a great look for Dodge or SRT. According to The Drive, a private drag event in Texas drew a number of Demon owners all trying to beat NHRA NHRA Top Fuel racer Leah Pritchett's time in her personal Dodge Demon — 42 stock Demons attended along with five modified cars. While no one managed to match her 9.65-second quarter-mile run, a few owners did dip below 10 seconds. Now, there are a few of caveats we must address. First, with any modified car, you run the risk of breaking something, even with a car that's set up from stock specifically for drag strips. Even a set of tires like the Mickey Thompsons shown in the video above can have an effect on driveline components. Horsepower may be king, but it's torque that's the rear killer. All that torque sends a shock through the car. Adding even more with aftermarket parts increases the risk of something failing. The modified car was apparently pushing out about 1,000 horsepower. That said, four of the five vehicles were stock, so any extra power or torque should theoretically be a non-factor. The drag strip's surface was maintained by a company called Mass Traction. FCA used Mass Traction during the Demon's development, so that too should be a non-factor in the part's failure. It's unclear what exactly caused the failures, though The Drive reports that FCA officials are investigating the matter. Related Video: This content is hosted by a third party.

Dodge Viper returning to Le Mans this year?

If you were among the fans disappointed by Chrysler's recent decision to end the Dodge Viper's racing program, we may have some good news for you, as the racing outfit behind the campaign is reportedly working to bring the American supercars back to Le Mans this year. That racing outfit is Riley Technologies, a constructor perhaps best known for its Daytona Prototypes, but it has also prepared its share of GT racers, too. Chrysler charged Riley with leading its racing program for the new Viper GTS-R, campaigned it in the United SportsCar Championship and the 24 Hours of Le Mans. Auburn Hills made the unfortunate decision back in March to pull its Vipers out of Le Mans, and then in October to withdraw from the US series, as well, thereby effectively ending the program altogether. Disappointed though it surely was, Riley remains defiant. The North Carolina-based company is planning on taking the existing Vipers back to Le Mans on its own, with or without factory support. The Viper has, after all, proven a capable machine, having taken both the drivers' and teams' titles in the United SportsCar Championship this past season. "With Le Mans, every driver and every manufacturer needs to have their first trip there, and it isn't always what you want it to be, but we did show reliability and did have some pace," Bill Riley told Racer.com. "Since then, we've worked hard on the cars, they're now strong, front-running cars in the US, and we're working with the ACO on the BoP to make sure the cars are strong at Le Mans. They're super-reliable and fast, and we'd expect to be right in the mix with the other cars." Riley has kept the existing support staff in place, and once it secures its driver lineup and sponsors, chances look good that it could represent America well at Le Mans this year in either the GTE Pro or GTE Am class. Its predecessor did, after all, complete a three-year winning streak that saw it dominate the GTS class right up until its withdrawal in 2000. News Source: Racer.comImage Credit: FCA Motorsports Dodge Coupe Racing Vehicles