2011 Dodge Grand Caravan - 4-door - 4x2 - 6-cylinder Gas - Cloth Interior - 80k on 2040-cars

Auto blog

Watch these Dodge Demons explode on a Texas drag strip

The Dodge Challenger SRT Demon is extremely quick. It can hit 60 mph from a dead stop in less time than it takes to read this sentence thanks to its supercharged 6.2-liter V8. That engine makes up to 840 horsepower and 770 pound-feet of torque, depending on what octane is running through the fuel lines. That's a ton of power going solely to the rear wheels. So much so that Dodge developed a number of features and a new set of tires specifically for the car. In our time with the Demon, the car took abuse run after run on a drag strip without skipping a beat, but it seems some actual owners aren't quite so lucky. Just take a look at what happened to a few of these cars. You can see the whole car shake and jitter right as the whole rear explodes in front of the tree. It seems the initial shock from the launch — the most taxing bit of any drag run — is what kills the differentials. Catastrophic failure is rarely pretty, but it is neat to see the whole thing occur in slow motion. Three more cars — four stock and one modified in total — suffered similar fates. Not a great look for Dodge or SRT. According to The Drive, a private drag event in Texas drew a number of Demon owners all trying to beat NHRA NHRA Top Fuel racer Leah Pritchett's time in her personal Dodge Demon — 42 stock Demons attended along with five modified cars. While no one managed to match her 9.65-second quarter-mile run, a few owners did dip below 10 seconds. Now, there are a few of caveats we must address. First, with any modified car, you run the risk of breaking something, even with a car that's set up from stock specifically for drag strips. Even a set of tires like the Mickey Thompsons shown in the video above can have an effect on driveline components. Horsepower may be king, but it's torque that's the rear killer. All that torque sends a shock through the car. Adding even more with aftermarket parts increases the risk of something failing. The modified car was apparently pushing out about 1,000 horsepower. That said, four of the five vehicles were stock, so any extra power or torque should theoretically be a non-factor. The drag strip's surface was maintained by a company called Mass Traction. FCA used Mass Traction during the Demon's development, so that too should be a non-factor in the part's failure. It's unclear what exactly caused the failures, though The Drive reports that FCA officials are investigating the matter. Related Video: This content is hosted by a third party.

Junkyard Gem: 1986 Dodge Ram 50

After years of selling the Isuzu Faster with Chevrolet LUV badges here, GM replaced it with the S-10 in 1982. Ford sold Mazda Proceeds with Courier badges for even more years, but ditched the Courier once the Ranger became available as a 1983 model. Chrysler was able to put truck beds on Omnirizons at that time, but didn't have the deep pockets to develop its own rear-wheel-drive small pickup; for this reason, Dodge-badged Mitsubishi Forte pickups continued to be available in the United States all the way through the 1994 model year. Here's one of those trucks, found in a Colorado car graveyard. The first Chrysler-imported Mitsubishi Fortes showed up in the United States as 1979 models. The Dodge-badged version was known as the D-50, while Plymouth dealers got theirs with Arrow badges. The Dodge D-50 became the Ram 50 for the 1981 model year, while the final Plymouth Arrow trucks were sold as 1982 models. Just to make things more interesting, Mitsubishi started selling its own vehicles in the United States beginning with the 1983 model year. That meant that the Ram 50 had to compete for sales with a near-identical twin sporting Mitsubishi badges. Things in the Chrysler-Mitsubishi universe got even more exciting a bit later, when there were four marques selling essentially the same car here simultaneously: the Mitsubishi Mirage, Plymouth Colt, Dodge Colt and Eagle Summit. All of the Dodge D-50s and Ram 50s came with Mitsubishi power under their hoods. This one has a 2.0-liter SOHC straight-four rated at 88 horsepower and 108 pound-feet. For a while, a 2.3-liter Mitsubishi diesel was available in the Ram 50. It had been discontinued by 1986, however. This one has the base five-speed manual transmission. It appears that this truck was being used for long-term storage of many, many boxes of random household stuff when it was banished to this place. Much of the stuff was scattered on the ground nearby. Perhaps it was parked at a rent-a-storage facility and got evicted for lack of rent payments. Much of the contents consisted of stacks of newspapers and magazines from the 1960s and 1970s. Here's an Art Buchwald column about then-Vice President Spiro Agnew from February 23, 1971. Here's a Beetle Bailey strip from the same year. There's plenty of history in the junkyard, if you know where to look. There must have been a half-ton of paper in this truck when it arrived here. Sadly, some family's photo albums were here as well.

NC dealer creates the convertible Challenger that Dodge won't build

Dodge still hasn't turned the Challenger into a convertible, and the odds of seeing a factory-built drop-top muscle car appear in showrooms are decreasing annually. Tired of waiting, a dealership in North Carolina teamed up with a Florida-based body shop to create a topless alternative to the Ford Mustang and the Chevrolet Camaro. It's the real thing, and it's for sale. Keffer Dodge, Chrysler, Ram and Jeep shipped three 2019 Challengers to a shop named Convertible Builders, according to Motor Authority. After losing their lid, they gained a cloth soft top that opens and closes at the push of a button. There's no word on what effect the conversion has on handling, or what Convertible Builders did to offset the loss of structural rigidity. The build didn't include mechanical modifications. Two of the convertibles are R/T Scat Pack models equipped with a 6.4-liter Hemi V8 engine that serves 485 horsepower and 475 pound-feet of torque. It's not a supercharged Hellcat V8, but it's potent enough to spin the rear wheels in third gear. The third, R/T-based model features a 375-horsepower, 5.7-liter V8. While our dream build would use a six-speed manual transmission, all three come with an eight-speed automatic that sends the engine's power to the rear wheels. Keffer's website lists the gray, white, and red cars at $64,000, $60,000, and $56,300, respectively. The regular R/T Scat Pack Widebody model starts at $46,245, and the eight-speed automatic adds another $1,595, so the convertible conversion adds about $16,000. It's your only option, unless you're brave enough to chop the top yourself, or patient enough to wait until the early 2020s. Dodge has already started developing the next-generation Challenger, so the current car is unlikely to spawn a convertible before it retires. Its replacement due out in 2021 or 2022 will allegedly ride on a wider, longer evolution of the Giorgio platform found under the Alfa Romeo Giulia, among other models, and unverified rumors claim it's being designed with a topless variant in mind from the get-go. It might resurrect the Barracuda nameplate originally assigned to Plymouth when it makes its debut. Auto News Dodge Convertible Performance