2007 White Se! 2013 Handicap Wheelchair Mobility Van on 2040-cars

Auto blog

Chrysler recalling over 200k vehicles across its brands

With more than 200,000 units across six separate recalls and almost all of its brands, it appears that Chrysler has officially jumped headfirst into the recall pool this month. The National Highway Traffic Safety Administration has issued three official recalls for the automaker, and The Detroit News is reporting that the automaker itself has announced three more.
The biggest of the recalls applies to about 120,000 Dodge Charger, Dodge Challenger and Chrysler 300 models for 2011 and 2012 due to faulty wiring harnesses for the seat-mounted side airbags, which could lead to these airbags not deploying in the event of a crash. A little more than 60,000 two-wheel-drive versions of the 2007-2008 Dodge Nitro and 2008 Jeep Liberty SUVs are being recalled due to a heat shield that could cause the driveshaft to break, which if that isn't bad on its own, could then hit underneath where the airbag sensor is mounted, causing the airbags to deploy. Wrapping up NHTSA's recall notices, about 20,000 Jeep Patriot and Jeep Compass models for 2012 are also being recalled due to a problem with the fuel tank transfer tube that could lead to the vehicle stalling. The LX car recall campaign is going into effect this month, while the other two will start next month - all three notices are posted below.
In addition to the official NHTSA recalls, The Detroit News is also reporting that Chrysler is recalling more than 16,000 Ram trucks and a small number of Dodge Dart sedans. Around 6,500 2013 Ram 1500 trucks will be recalled due to an improper adjustment of the parking brake cable from the factory, while 7,000 Cummins-powered 2013 Ram Heavy Duty trucks are being recalled due to an engine cover that does not have as much heat resistance as it is supposed to. Finally, a total of 46 Dodge Dart sedans are being recalled due to a problem with the brake calipers and/or parking brake.

2020 Dodge Challenger SRT Super Stock is as close as you can get to a new Demon

Although the Dodge Demon was an exclusive, one-year-only muscle car, Dodge has found ways of getting bits of that car to more people. First there was the Hellcat Redeye, that got a detuned version of the Demon engine, down from 840 horsepower to 797. Now there's the 2020 Dodge Challenger SRT Super Stock. It starts with the Hellcat Redeye, but adds a bit of horsepower, and drag race-specific tires and suspension tuning to get one step closer to the monster Demon. The engine is basically the same supercharged 6.2-liter Hemi V8 as the Redeye, but with a new engine calibration that bumps up horsepower by 10 to 807, though torque stays the same at 707 pound-feet. It's coupled to the same eight-speed automatic as the Hellcat Redeye, but it has also been retuned to shift 100 rpm later at 6,400 rather than 6,300 to squeeze as much out of each gear as possible. The rear differential is a limited-slip unit and comes standard with a 3.09:1 gear ratio, which is optional on regular Hellcat Redeyes. The Super Stock also gets revised chassis components. Instead of the regular Hellcat Brembo six-piston brakes up front, it gets lighter four-piston Brembo calipers with slightly smaller rotors, all in the name of going faster at the drag strip. The suspension has been retuned to shift weight to the rear wheels and improve traction at launch. In Track mode, the suspension switches to fully firm rebound and compression at the rear, and firm compression and soft rebound at the front to help facilitate the weight transfer. It stays in this mode as long as full throttle is applied, and reverts to the standard Track settings when lifting off the throttle. The final piece of the drag racing puzzle are the wheels and tires. The regular Redeye's huge wheels and low profile tires are gone in favor of wheels that are just 18 inches in diameter. They're fitted with Nitto NT05R drag radials, the same make and model as on the Demon, at each corner for maximum traction at the strip. These are also the only indicators that you have a Super Stock. All the other badging is the same as the Hellcat Redeye, so only those in the know will recognize a Super Stock model. The final results of these drag-racing enhancements are impressive. Dodge claims a 0-60 time of 3.25 seconds, and a quarter-mile time of 10.5 seconds. Apparently it will finish three car lengths ahead of a regular Redeye at the drag strip. Top speed is less formidable at 168 mph, but that's a limit of the drag tires.

Mopar highlights wild SEMA creations, AWD Challenger Concept

Thanks to 15,345 square feet of display area, FCA US' Mopar division certainly has ample space to display its parts and accessories at the SEMA Show. To lure attendees to check out all of those cars and components, the company is now revealing ten tuned vehicles for this year's aftermarket event. This isn't even the brand's whole fleet for the show, but it includes some major highlights for Dodge and Ram fans. A lack of traction traditionally makes rear-wheel-drive muscle cars dismal to drive when the weather gets slippery, but the Dodge Challenger GT AWD Concept (above) solves that age-old problem at SEMA. In addition to powering all four wheels through an eight-speed automatic, it boasts an angry-looking, wide-body kit with aggressively flared wheel arches. The asymmetrical stripe with Header Orange accents also adds some extra panache to the Destroyer Grey and Matte Black color scheme. The coupe can back up the macho look thanks to the Scat Pack 3 Performance Kit that adds 75 horsepower and 44 pound-feet of torque to the 5.7-liter V8. However, before you get too excited about driving one this winter, FCA US spokesperson Ariel Gavilan tells Autoblog: "It is only a concept." Mopar isn't done tuning Dodges for SEMA. The Charger Deep Stage 3 shows what's possible with the company's catalog by packing the Scat Pack 3, strut tower braces, coilover suspension kit, and bigger brakes. Meanwhile, the blacked-out Dart GLH Concept tries to harken back to the style of the famous Omni GLH by fitting a red-accented body kit, including a Mopar Performance aluminum hood. If the standard Ram 1500 Rebel is somehow too subdued, check out the Rebel X (right) in a vibrant shade called Copper. To be ready for anything offroad, it wears some muscular flares to fit 17-inch beadlock wheels and 35-inch Toyo tires. A concept, two-piece front skid plate protects the front. Drivers should also be comfortable no matter where they drive thanks to prototype Katzkin leather seats and a concept air-ride suspension. Chrysler enjoys some mods, as well. The 300 Super S has suave style with Matte Cerulean paint, concept 22-inch wheels, and a grille with little Mopar Ms dotted around it. Performance also sees a boost with a tuned engine, bigger brakes, and coilover kit. The gray 200 S Mopar is similarly stylish with a complete body kit, including a conceptual, dual-vented hood. Fiat and Ram's commercial models aren't left out of the SEMA fun, either.