4dr Sdn R/t Dodge Avenger 4dr Sedan R/t Low Miles Automatic Gasoline 3.6l Vvt Fl on 2040-cars

Auto blog

Watch these Dodge Demons explode on a Texas drag strip

The Dodge Challenger SRT Demon is extremely quick. It can hit 60 mph from a dead stop in less time than it takes to read this sentence thanks to its supercharged 6.2-liter V8. That engine makes up to 840 horsepower and 770 pound-feet of torque, depending on what octane is running through the fuel lines. That's a ton of power going solely to the rear wheels. So much so that Dodge developed a number of features and a new set of tires specifically for the car. In our time with the Demon, the car took abuse run after run on a drag strip without skipping a beat, but it seems some actual owners aren't quite so lucky. Just take a look at what happened to a few of these cars. You can see the whole car shake and jitter right as the whole rear explodes in front of the tree. It seems the initial shock from the launch — the most taxing bit of any drag run — is what kills the differentials. Catastrophic failure is rarely pretty, but it is neat to see the whole thing occur in slow motion. Three more cars — four stock and one modified in total — suffered similar fates. Not a great look for Dodge or SRT. According to The Drive, a private drag event in Texas drew a number of Demon owners all trying to beat NHRA NHRA Top Fuel racer Leah Pritchett's time in her personal Dodge Demon — 42 stock Demons attended along with five modified cars. While no one managed to match her 9.65-second quarter-mile run, a few owners did dip below 10 seconds. Now, there are a few of caveats we must address. First, with any modified car, you run the risk of breaking something, even with a car that's set up from stock specifically for drag strips. Even a set of tires like the Mickey Thompsons shown in the video above can have an effect on driveline components. Horsepower may be king, but it's torque that's the rear killer. All that torque sends a shock through the car. Adding even more with aftermarket parts increases the risk of something failing. The modified car was apparently pushing out about 1,000 horsepower. That said, four of the five vehicles were stock, so any extra power or torque should theoretically be a non-factor. The drag strip's surface was maintained by a company called Mass Traction. FCA used Mass Traction during the Demon's development, so that too should be a non-factor in the part's failure. It's unclear what exactly caused the failures, though The Drive reports that FCA officials are investigating the matter. Related Video: This content is hosted by a third party.

Ford, Stellantis workers join those at GM in ratifying contract that ended UAW strikes

DETROIT — The United Auto Workers union overwhelmingly ratified new contracts with Ford and Stellantis, that along with a similar deal with General Motors will raise pay across the industry, force automakers to absorb higher costs and help reshape the auto business as it shifts away from gasoline-fueled vehicles. Workers at Stellantis, the maker of Jeep, Dodge and Ram vehicles, voted 68.8% in favor of the deal. Their approval brought to a close a contentious labor dispute that included name-calling and a series of punishing strikes that imposed high costs on the companies and led to significant gains in pay and benefits for UAW workers. The deal at Stellantis passed by a roughly 10,000 vote margin, with ballot counts ending Saturday afternoon. Workers at Ford voted 69.3% in favor of the pact, which passed with nearly a 15,000-vote margin in balloting that ended early Saturday. Earlier this week, GM workers narrowly approved a similar contract. The agreements, which run through April 2028, will end contentious talks that began last summer and led to six-week-long strikes at all three automakers. Shawn Fain, the pugnacious new UAW leader, had branded the companies enemies of the UAW who were led by overpaid CEOs, declaring the days of union cooperation with the automakers were over. After summerlong negotiations failed to produce a deal, Fain kicked off strikes on Sept. 15 at one assembly plant at each company. The union later extended the strike to parts warehouses and other factories to try to intensify pressure on the automakers until tentative agreements were reached late in October. The new contract agreements were widely seen as a victory for the UAW. The companies agreed to dramatically raise pay for top-scale assembly plant workers, with increases and cost-of-living adjustments that would translate into 33% wage gains. Top assembly plant workers are to receive immediate 11% raises and will earn roughly $42 an hour when the contracts expire in April of 2028. Under the agreements, the automakers also ended many of the multiple tiers of wages they had used to pay different workers. They also agreed in principle to bring new electric-vehicle battery plants into the national union contract. This provision will give the UAW an opportunity to unionize the EV battery plants plants, which will represent a rising share of industry jobs in the years ahead.

NHTSA probing Ram recall pace, communication

The National Highway Traffic Safety Administration has announced that it's looking into Chrysler Group's handling of a pair of recalls affecting roughly one million Ram pickup trucks. Reuters is reporting that the regulatory agency is focusing on the availability (or lack thereof) of parts and "poor communications" from the automaker in its investigation.
"Customers have been advised in accordance with the regulations governing recalls," Chrysler spokesman Eric Mayne told Reuters via email. "We are continually replenishing our supply of replacement parts. Chrysler Group regrets any inconvenience our customers may have experienced."
NHTSA disagrees, arguing that the recalls, which affect 972,000 trucks from 2003 to 2012, are being delayed by the lack of parts.