2014 Dodge Avenger Sxt on 2040-cars

Auto blog

FCA recalls 570,000 SUVs from Jeep and Dodge over fire woes

Fiat Chrysler US has issued two recalls covering a total of about 570,000 Jeep and Dodge models. The first concerns vanity mirror wiring in the Jeep Grand Cherokee from the 2011 and 2012 model years, and in Dodge Durango units built before September 12, 2012. The automaker recalled almost 900,000 units last year to repair the issue, then faced more issues this year when the fires continued in repaired vehicles. This new recall seeks to resolve the issue, FCA saying that the post-recall fires happened in a tiny percentage of vehicles equipped with a specific wiring package. This recall is for 352,831 total units in the US, another 26,478 in Canada, 13,037 in Mexico, and 84,330 internationally. No injuries or deaths have been reported. FCA says it will inform customers as to when they can schedule a service visit to remedy the issue. The second recall takes aim at 60,107 examples of the Jeep Compass and Patriot from the 2015 model year in the US, plus 5,755 in Canada, 3,351 in Mexico, and 23,995 in other markets. Those models could suffer from an out-of-position clamp on the power steering fluid line. The error could allow fluid to leak, increasing the risk of a fire if the fluid ends up on a hot surface. In the case of a complete loss of fluid, drivers will need to use a lot more effort to steer. The automaker reports no injuries or accidents, and will advise customers when to head to the dealer for service. Related Video: Jeep Grand Cherokee and Dodge DurangoStatement: Vanity-Mirror WiringDecember 24, 2015 , Auburn Hills, Mich. - FCA US LLC is recalling an estimated 352,831 SUVs in the U.S. to help ensure vanity-mirror wiring may be serviced more consistently.Overheating conditions were reported among a small percentage of vehicles (<0.02%) serviced in connection with a related recall, conducted previously.** An FCA US LLC investigation discovered the service procedure, if not followed precisely, may leave vehicles susceptible to a short-circuit, creating a potential fire hazard.The Company is unaware of any related injuries or accidents. Post-service overheating conditions were observed only in vehicles equipped with a certain wiring package. These vehicles were produced before Sept. 2, 2012.Affected are model-year 2011-2012 Jeep Grand Cherokee and Dodge Durango SUVs produced before Sept. 2, 2012. Wiring in the headliners of these vehicles will be secured with a new adhesive.

Dodge Demon makes so much torque, it needs stronger driveline parts

Torque is a lovely thing, a sweet and wonderful force that twists and pulls and can help propel a two-ton metal box forward at comical speeds. Torque is also fickle and will bend and break those same metal parts without a second thought, which is why the new Dodge Demon is compensating for its increased torque with some new re-engineered and reinforced parts. And there's software intended to combat wheel hop, which one of the most dramatic ways torque can break stuff. Week 8's video, "Race-hardened Parts," gives a hint towards what all these new parts can do. While we still don't know how much torque the Demon will throw out, we do know it's enough to warrant an upgraded prop shaft, half shafts, and a differential housing. The Challenger Hellcat, which is the basis for the Demon, makes 650 pound-feet of torque already. The new parts will go a long way toward making sure the work from the Demon's engine is properly translated into motion by those Nitto drag radials. The new prop shaft uses high-strength steel, heat-treated stub-shafts, and increases the tube thickness by 20 percent for a 15 percent increase in torque capacity. Additionally, Dodge says the upgraded differential housing allows for a 30 percent increase in torque capacity by using heat-treated A383 aluminum alloy and a higher strength shot-peened gear set. The 41-spline half shafts that deliver 20 percent increased torque capacity through the use of high-strength low alloy steel and 8-ball joints. In addition to the hardware, the Launch Assist software has been tuned to help alleviate wheel hop. Dodge says the Demon is the first factory production car that uses wheel speed sensors to detect hop and momentarily cut torque to compensate. This means a driver can keep their foot planted on the floor while the computer sorts out the traction. Previously, the best solution was to back off the throttle to manually cut the load. Finally, the Dodge Demon will offer a four-point harness mounting bar as an optional accessory. The part will be supplied by Speedlogix and fits in place of the deleted rear seat. Customers can install the bar without having to hack apart their cars to find a proper mounting point. Look for more teasers and info on ifyouknowyouknow.com in the lead-up to the Demon's debut at the 2017 New York Auto Show. Related Video: Image Credit: FCA Dodge Performance dodge demon dodge hellcat

FCA issuing software update for 1.4M vehicles to prevent hacking

In the wake of a Jeep Cherokee being hacked remotely while on the road through its Uconnect infotainment system, FCA US is now issuing a software update for 1.4 million vehicles in the United States. Affected customers will receive a USB stick in the mail with the improved version; owners can check this website to see if their cars are affected. A large variety of models with FCA's 8.4-inch touchscreen infotainment system are affected. They include the 2015 Chrysler 200, 2015 Chrysler 300, 2015 Dodge Charger, and 2015 Dodge Challenger; 2013-2015 Dodge Viper; 2013-2015 Ram 1500, 2500, and 3500; 2013-2015 Ram 3500, 4500, and 5500 chassis cab; 2014-2015 Jeep Grand Cherokee and Cherokee; and 2014-2015 Dodge Durango. According to FCA in its announcement, the new software "insulates connected vehicles from remote manipulation." As of July 23, the company also "fully tested and implemented within the cellular network" additional security to prevent access to many of a vehicle's systems. FCA US says that it's conducting this campaign out of an abundance of caution and disputes the notion that there's a defect with these vehicles. Beyond the demonstration of the hack in the Cherokee, the automaker says that it's unaware of any other reports of these attacks actually happening. Related Video: Statement: Software Update July 24, 2015 , Auburn Hills, Mich. - FCA US LLC is conducting a voluntary safety recall to update software in approximately 1,400,000 U.S. vehicles equipped with certain radios. The recall aligns with an ongoing software distribution that insulates connected vehicles from remote manipulation, which, if unauthorized, constitutes criminal action. Further, FCA US has applied network-level security measures to prevent the type of remote manipulation demonstrated in a recent media report. These measures – which required no customer or dealer actions – block remote access to certain vehicle systems and were fully tested and implemented within the cellular network on July 23, 2015. The Company is unaware of any injuries related to software exploitation, nor is it aware of any related complaints, warranty claims or accidents – independent of the media demonstration.