We Finance New White Automatic V6 3rd Row Bluetooth Sunroof 2wd Minivan Lrack on 2040-cars

Auto blog

Chrysler set to make $266M-investment into 8-speed transmission production

Chrysler will shortly make a significant $266-million investment into its Kokomo, IN transmission factory in a bid to expand production of its eight-speed automatic transmissions. The gearboxes, which are built under license from Germany's ZF Friedrichshafen, have been well received by customers and critics, and according to an SEC filing obtained by Automotive News, the transmissions will eventually find their way to all of Chrysler's rear-drive offerings (Viper and heavy-duty Ram models, aside). According to AN, a Chrysler spokesman says the investment has not been confirmed, but once it is, it'll mark the company's latest in a growing line of investments at the facility. Chrysler has poured $1.5 billion into Kokomo since 2009.

Some Jeep Cherokees and Chrysler 200s to get standard stop-start in 2015

Automakers the world over are striving to find ways to make their models more efficient, and Chrysler has a solution for some versions of the 2015 Chrysler 200 and 2015 Jeep Cherokee (2014 model shown). The Tigershark 2.4-liter four-cylinder in the 200 and the 3.2-liter Pentastar V6 in the Cherokee are getting a slight boost later this year thanks to the addition of Chrysler's Engine Stop-Start system as standard equipment. The company predicts modest gains - a three-percent improvement in fuel economy and a three percent reduction in CO2 emissions with the new tech compared to without it. While it's not much, those who sit in traffic a lot may see a difference.
Chrysler's stop/start system uses a high-speed starter motor to restart the vehicle in a claimed a third of a second. It works by detecting when the vehicle comes to a stop and turning off the engine. A more powerful battery maintains all of the model's accessories while it sits. When the driver lets off the brake, the car starts up again to drive away. There is even a button in the cabin to turn the ESS off, if desired.
The Jeep will be the first to receive ESS in the third quarter of this year to coincide with the start of production of the 2015 model-year version. The 200 will follow in the fourth quarter as a rolling change in production.

Chrysler says its 8-speed transmissions will save 700 million gallons

Chrysler Group's TorqueFlite eight-speed transmission could be earning some serious green bragging rights if the company's projections are correct. The recently widely proliferated automatic gearbox, which is now in more than a million vehicles around the world, is poised to save drivers an estimated 700+ million gallons of fuel over the vehicles' lifetimes (an expected cost savings of $2.5 billion). In addition, Chrysler expects a reduction in CO2 emissions by more than six million metric tons. According to Chrysler, and depending on the vehicle, the TorqueFlite can improve fuel economy. The TorqueFlite autobox features particularly close ratios from fifth to eighth gear (see the press release below for the specific numbers), and uses low-viscosity fluid that doesn't need to be replaced. Transmission software adapts to the driving situation to optimize efficiency based on driver behavior, temperature, grade, stability control, and longitudinal and lateral acceleration. The TorqueFlite is capable of handling a variety of duties. As evidenced by the wide range of vehicles Chrysler Group has seen fit to equip with the eight-speed transmission, the TorqueFlite is capable of handling a variety of duties. Since its 2012 introduction, the TorqueFlite has gone from performing cog-swapping duties in Dodge Charger and Chrysler 300 models equipped with the 3.6-liter Pentastar V6 to changing gears in vehicles such as the Pentastar- and Hemi-powered Dodge Durango, Jeep Grand Cherokee and even the Ram 1500 EcoDiesel. For the 2015 model year, the eight-speed is finding its way into even more vehicles with the addition of a third version. In addition to the American-made TorqueFlite 845RE and 8HP70, the new 8HP90 will be manufactured in Saarbrucken, Germany. The 8HP90 is designed for higher torque loads, making it ideal for high-performance vehicles like the 2015 Dodge Challenger SRT Hellcat. The already-in-use 8HP70 will expand its duties to be used in 2015 Hemi models such as the Dodge Charger, Challenger, and Challenger SRT8. You can see the list of those benchmarks in Chrysler's press release below.