2014 Chrysler Town & Country Touring-l on 2040-cars

Auto blog

Chrysler highlights Mopar lineup for SEMA

SEMA is all about aftermarket parts, and in Auburn Hills that all comes down to one name: Mopar. After having previewed its lineup for this year's Vegas tuner expo earlier this month, Chrysler has now revealed what may not quite be its full dossier of modified show cars, but a good portion of them.
All told Mopar is preparing 20 vehicles for display at SEMA this year. Among them you'll find the Ram Sun Chaser, a 1500 Quad Cab show truck kitted out in two-tone orange and black paint, a roof rack for surfboards, onboard shower and convertible tailgate. The white Fiat 500L is called the Adventurer and is modified for a more rugged look that could hint at the upcoming crossover version. The Jeep Cherokee Trail Carver upgrades on the Trailhawk package with everything from roof basket to rock rails. To counterbalance the off-roaders, there's also a modified Chrysler 300S with a deep black paint job, special grille, Varvatos-edition wheels and more.
All four concepts details so far have Katzkin interiors as well, and there's also an unspecified Dodge Durango with a storm-trooper look in the gallery above. But for more details on what Mopar has installed on the Ram, 500L, Cherokee and 300, you'll want to delve into the press release below.

500+ hp Stellantis 'Hurricane' I6 previews a world without Hemis

After years of rumored development, Stellantis has revealed its new six-cylinder engine family. The 3.0-liter, twin-turbocharged "Hurricane" I6 will offer V8 power, forced induction torque and six-cylinder efficiency in a package designed to fit into any of the company's North American rear-wheel-drive platforms.  What is "V8 power," exactly? Well, in standard output guise, the new I6 cranks out more than 400 horsepower (the specific figure will vary by application) and 450 pound-feet of torque, while the high-output variant is good for more than 500 horses and 475 lb-ft. The final figures will be dependent on the application. We'll save you a little legwork: In current Ram, Jeep and Dodge products, the 5.7-liter Hemi tops out at about 395 hp and 410 lb-ft, give or take, and the 6.4-liter around 485 hp and 475 lb-ft.    This is a clean-sheet design that is only related to the company's turbocharged four-cylinder by some common measurements. The I6 is exclusively direct-injection (no hybrid/port-injection here) and the two I6 variants share 96 common parts, including the block and oil pan design. The differences are found in their internals, intake plumbing, valvetrain components and the turbochargers themselves. Stellantis is not yet ready to share specs or supplier info for the turbos but says announcements will come from its partners soon.  The standard-output I6 has a compression ratio of 10.4:1 and revs to 5,800 rpm. It will run on regular fuel, albeit with reduced performance; 91 octane is recommended for maximum output. The high-output variant has a compression ratio of 9.4:1 and will rev to 6,100 rpm. That one will require premium. The new I6's advantages go beyond basic power output. Every Hemi family engine currently in production is based on an iron block design, so they're heavy. The aluminum-block I6 shaves weight off the total engine package, even if some of that gets added back thanks to the turbos and their associated plumbing. The standard-output I6 weighs 430 pounds, Stellantis engineers told us; the high-output adds just another 11. Fully dressed 5.7-liter V8s are in the 550-560-pound ballpark, and 6.4-liters close in on 600 pounds.  You may be wondering, "Why a clean-sheet gasoline engine now, when the industry is moving toward battery-electrics?" A valid inquiry, and one Stellantis was prepared to address. While the company will be pivoting to electrification over the next decade, it won't be instantaneous.

Autoblog Minute: FCA unveils 4x4 all-weather drive cell

It's winter time any time at the FCA Tech Center as FCA unveils an all-weather 4x4 drive cell. Autoblog's Mylencia Gillenwaters and Eddie Sabatini report on this edition of Autoblog Minute. Show full video transcript text [00:00:00] It's winter time any time at the Chrysler Technical Center as FCA unveils a new all-weather 4x4 test site. I'm Mylencia Gillenwaters and this is your Autoblog Minute. FCA calls it their first 4x4 in drive dyno cell, with rain and snow testing capabilities. We sent Autoblog's Eddie Sabatini to Auburn Hills for a closer look at the $2.5-million investment: [00:00:30] [EDDIE SABATINI INTERVIEW] This 4x4 dyno adds to the FCA's already impressive 5.4-million square-foot research and development center. The Tech Center features some 14,000 employees, an aerodynamic test facility, and [00:01:00] hundreds of test sites that run 24/7. Truly making it an auto engineer's dream. For Autoblog, I'm Mylencia Gillenwaters. Autoblog Minute is a short-form video news series reporting on all things automotive. Each segment offers a quick and clear picture of what's happening in the automotive industry from the perspective of Autoblog's expert editorial staff, auto executives, and industry professionals. Chrysler Technology Autoblog Minute Videos Original Video engineering 4x4 research and development