2004 Limited Used 2.7l V6 24v Automatic Convertible on 2040-cars

Auto blog

2015 Chrysler 200

For the last seven years, the Chrysler Sebring/200 has been a car that few people have managed to say anything good about. When you saw one on the road, it was probably silver and you probably assumed it was rented - especially if it was a convertible. In fact, this writer has never been in one. Ever. I've only watched them go by, trailed always by a roiling wake of invective and vituperation, a lone defender or two asserting meekly and in vain, "It's actually not that bad..."
With roughly 2.3-million units sold every year in the midsize sedan segment where the 200 lives, even tallying 125,476 sales in 2012 (when the 200 was the best-selling car in the Chrysler Group) was never going to be enough. This is the brand's volume offering and the entry point for new-car buyers before they move up to something like a full-size or a crossover. Chrysler's 2011 facelift and rebranding program was a pretty valiant attempt at putting lipstick on a Sebring, but the automaker needed to do a lot better, in every way to command more consideration, sales, respect and resale value - and everyone at The Pentastar knew it.
Enter the 2015 Chrysler 200. This is the sedan that "charts a new course for the Chrysler brand," from its hovering wing badge on the grille to the one billion dollars invested in the company's suburban Detroit Sterling Heights Assembly Plant, including more than doubling the number of quality control inspectors in the new quality assurance center.

Worker crushed to death at FCA's Jefferson North Assembly Plant [UPDATE]

Tragedy has struck a Fiat Chrysler factory. According to emerging reports, a worker was killed at the Jefferson North Assembly Plant early this morning in Detroit. The incident reportedly occurred in the waste water treatment facility at the plant, just after 7 a.m. this morning. The 53-year-old worker, whose name has not yet been released, is said to have been crushed in a press and was pronounced dead at the scene. The incident is currently under investigation to determine the exact circumstances. Jefferson North is where FCA assembles the Jeep Grand Cherokee and Dodge Durango. The plant is located on Conner Street near East Jefferson Avenue in Detroit. We've reached out to FCA US for the official statement, and will update you as soon as more details are available. Our condolences go out to the late worker's family and friends. UPDATE: Official statement from FCA added below. FCA US has had a tragic accident at its Jefferson North Assembly Plant during the first shift this morning. A plant employee died at the waste water treatment plant. The Company is currently working with local officials to investigate the incident. The name of the employee is not being released at this time. All of the FCA family extends its deepest sympathies to the employee's family during this difficult time.

Chrysler says its 8-speed transmissions will save 700 million gallons

Chrysler Group's TorqueFlite eight-speed transmission could be earning some serious green bragging rights if the company's projections are correct. The recently widely proliferated automatic gearbox, which is now in more than a million vehicles around the world, is poised to save drivers an estimated 700+ million gallons of fuel over the vehicles' lifetimes (an expected cost savings of $2.5 billion). In addition, Chrysler expects a reduction in CO2 emissions by more than six million metric tons. According to Chrysler, and depending on the vehicle, the TorqueFlite can improve fuel economy. The TorqueFlite autobox features particularly close ratios from fifth to eighth gear (see the press release below for the specific numbers), and uses low-viscosity fluid that doesn't need to be replaced. Transmission software adapts to the driving situation to optimize efficiency based on driver behavior, temperature, grade, stability control, and longitudinal and lateral acceleration. The TorqueFlite is capable of handling a variety of duties. As evidenced by the wide range of vehicles Chrysler Group has seen fit to equip with the eight-speed transmission, the TorqueFlite is capable of handling a variety of duties. Since its 2012 introduction, the TorqueFlite has gone from performing cog-swapping duties in Dodge Charger and Chrysler 300 models equipped with the 3.6-liter Pentastar V6 to changing gears in vehicles such as the Pentastar- and Hemi-powered Dodge Durango, Jeep Grand Cherokee and even the Ram 1500 EcoDiesel. For the 2015 model year, the eight-speed is finding its way into even more vehicles with the addition of a third version. In addition to the American-made TorqueFlite 845RE and 8HP70, the new 8HP90 will be manufactured in Saarbrucken, Germany. The 8HP90 is designed for higher torque loads, making it ideal for high-performance vehicles like the 2015 Dodge Challenger SRT Hellcat. The already-in-use 8HP70 will expand its duties to be used in 2015 Hemi models such as the Dodge Charger, Challenger, and Challenger SRT8. You can see the list of those benchmarks in Chrysler's press release below.