2004 Chrysler Sebring Limted Coupe 3.0 Sohc 6g72 V6 on 2040-cars

Auto blog

Detroit 3 and UAW set for showdown over tiered wages

This week, thousands of United Auto Workers will converge on Cobo Center in Detroit for the Special Convention on Collective Bargaining, an every-four-year event that lets members tell UAW leaders what the negotiating priorities should be during contract negotiations. This is where a lot of sand and a lot of lines start coming together in preparation for contract negotiations between the UAW and the Detroit 3 automakers, which will happen later this year. Number one on the UAW agenda is the end of the two-tier wage system created in 2007 to help the automakers get through bankruptcy; veteran workers are paid the Tier 1 rate of around $29.00 per hour, new hires are paid the Tier 2 rate of between $15 and $20 and get about half the benefits of Tier 1. Tier 2 hiring has been an undoubted success for the automakers, allowing them to keep factories in the US and hire more workers. By agreement, it is capped at a certain percentage of each automaker's workforce, and while the union's ultimate position is to get rid of the dual-scale system entirely; one leader said Ford could easily afford the $335 million it would take to convert all its workers to Tier 1 out of its $6.9 billion in 2014 North American profit, and General Motors could do the same out of the $5 billion it is handing to investors through the (admittedly forced) share buyback. Other delegates say that at the very least they'd be happy with enforcement of the current caps in the new contract. The automakers, conversely, would welcome expansion of the Tier 2 ranks. Including benefits, import automakers pay workers "in the high $40 range" per hour, according to an analyst, while Ford and GM pay about $59 in wages and benefits per hour. More Tier 2 workers on the rolls would let those two companies get labor cost parity with the competition. Fiat-Chrysler pays wages closer to the imports because of special exceptions in its UAW contract that allow unlimited Tier 2 hiring; those exceptions will end on September 14 and bring FCA into line with the other domestics, unless the new contract maintains them. FCA CEO Sergio Marchionne is opposed to the two-tier system, having called it "almost offensive." One analyst says the UAW might win a sizable pay raise for Tier 2 and a small increase for Tier 1, but the keystone issue will be how the hiring matrix can help the automakers keep overall wages in line with the imports.

Chrysler says its 8-speed transmissions will save 700 million gallons

Chrysler Group's TorqueFlite eight-speed transmission could be earning some serious green bragging rights if the company's projections are correct. The recently widely proliferated automatic gearbox, which is now in more than a million vehicles around the world, is poised to save drivers an estimated 700+ million gallons of fuel over the vehicles' lifetimes (an expected cost savings of $2.5 billion). In addition, Chrysler expects a reduction in CO2 emissions by more than six million metric tons. According to Chrysler, and depending on the vehicle, the TorqueFlite can improve fuel economy. The TorqueFlite autobox features particularly close ratios from fifth to eighth gear (see the press release below for the specific numbers), and uses low-viscosity fluid that doesn't need to be replaced. Transmission software adapts to the driving situation to optimize efficiency based on driver behavior, temperature, grade, stability control, and longitudinal and lateral acceleration. The TorqueFlite is capable of handling a variety of duties. As evidenced by the wide range of vehicles Chrysler Group has seen fit to equip with the eight-speed transmission, the TorqueFlite is capable of handling a variety of duties. Since its 2012 introduction, the TorqueFlite has gone from performing cog-swapping duties in Dodge Charger and Chrysler 300 models equipped with the 3.6-liter Pentastar V6 to changing gears in vehicles such as the Pentastar- and Hemi-powered Dodge Durango, Jeep Grand Cherokee and even the Ram 1500 EcoDiesel. For the 2015 model year, the eight-speed is finding its way into even more vehicles with the addition of a third version. In addition to the American-made TorqueFlite 845RE and 8HP70, the new 8HP90 will be manufactured in Saarbrucken, Germany. The 8HP90 is designed for higher torque loads, making it ideal for high-performance vehicles like the 2015 Dodge Challenger SRT Hellcat. The already-in-use 8HP70 will expand its duties to be used in 2015 Hemi models such as the Dodge Charger, Challenger, and Challenger SRT8. You can see the list of those benchmarks in Chrysler's press release below.

Fiat-Chrysler shows its SEMA lineup

Fiat Chrysler Automobiles already previewed its 2014 SEMA show lineup with some slick renders. Now, the automaker has finally showed us the actual cars, and among the group there are definitely some that stand out more than others.
Dodge is really showing off its muscle at this year's show with four concepts that all pump up the power of the brand's models. Perhaps most interesting among them is the Challenger T/A Concept (pictured above) in striking Sublime Green and matte black. It's meant to resemble the classic Trans Am racer from the '70s. Under the hood is a 6.4-liter V8, and to fit the vintage style there's a pistol-grip gearshift inside.
The Charger R/T also gets some attention with the Mopar concept that shows off what FCA's aftermarket performance arm can do. Mods include an updated body kit, cold-air intake for the 5.7-liter V8 and a coil-over suspension kit. Beyond that, the Dart R/T Concept looks a lot meaner with a black hood with duct work that leads straight to the air intake. The rest of the compact sedan is dolled up in O-So-Orange paint and is fitted with upgrades to improve handling like a coil-over suspension and big brake kit from the Mopar catalog.