Auto blog

2015 Chrysler 200 snags EPA ratings of 18 mpg city and 29 highway

While Chrysler hasn't officially announced fuel economy figures for its new 200 sedan, the information for one model has just leaked out thanks to the US Department of Energy's FuelEconomy.gov website. It certified the 200 with the 295-horsepower and 262-pound-feet 3.6-liter Pentastar V6, nine-speed automatic and all-wheel drive as getting 18-miles-per-gallon city, 29-mpg highway and 22-mpg combined.
Last year's front-wheel drive 200 with a less-powerful version of the Pentastar was rated at 19-mpg city, 29-mpg highway and 22-mpg combined. That means that buyers are getting more power and all-wheel drive traction at almost no loss in economy. However, compared to current, all-wheel drive sedan competitors, the Chrysler comes in the middle. The Ford Fusion with all-wheel drive with the 2.0-liter EcoBoost four-cylinder has 240 hp and 270 lb-ft of torque is somewhat down on power but bests it in economy at 22-mpg city, 31-mpg highway and 25-mpg combined. The current Subaru Legacy 3.6R loses in both metrics with 256 hp and 247 lb-ft and a rating of 18-mpg city, 25-mpg highway and 20-mpg combined. However, Subaru claims the next generation with the same engine will boast 20-mpg city, 28-mpg highway and 23-mpg combined. But these numbers are just estimates from the automaker at the moment, and they haven't yet been certified by the EPA yet.
The numbers for the four-cylinder and front-wheel drive 200 drivetrains are not yet available, but Chrysler has been promising the sedan gets an estimated 35-mpg highway with the 184-hp and 173-lb-ft Tigershark 2.4-liter four-cylinder engine. We won't know for sure until it's certified, but we'll keep you posted.

Chrysler recalling 278,222 trucks and SUVs over bad rear axles

Chrysler has issued a recall of 278,222 light trucks and sport utility vehicles here in the United States. The reason: bad rear axles. Specifically, according to the National Highway Traffic Safety Administration, the rear axle pinion nut may lack a necessary adhesive patch, which could cause the nut to loosen. If this happens, the axle can lock up, which could cause all sorts of havoc on the road.
This is an expansion of the rear axle recall announced in October of last year, where 44,300 Ram 1500 and Dodge Dakota models were being called in. At that time, 12 accidents had been reported due to the faulty axle pinion nut.
Affected vehicles include Ram 1500 trucks from the 2009 to 2012 model years, Dodge Dakota models from the 2009 to 2011 model years, and both the Chrysler Aspen and Dodge Durango SUV twins, both from the 2009 model year only.

Fiat ups Chrysler stake by 3.3%, inches closer to full control

Fiat is one step closer to completing a merger with Chrysler after exercising an option to acquire an additional 3.3 percent of the Auburn Hills-based automaker today. Automotive News reports that Fiat now controls 68.49-percent of Chrysler, which is up almost 10 percent since we last heard news of this deal back in February when Fiat talking to various banks to raise more capital in order to complete the acquisition.
The article says that Fiat is still able to increase its stake in Chrysler up to 75 percent over the next 12 months, but it sounds like CEO Sergio Marchinonne would rather purchase the remaining shares from VEBA - the retiree benefits trust - sooner rather than later. Unfortunately, the two sides still seem far from an agreement on a fair price for the rest of Chrysler, as Fiat has them valued at $4.2 billion compared to the $10.3 billion estimate from the unions that currently own the remaining stake in Chrysler.