1989 Chrysler Lebaron Gt Convertible 2-door 2.5l on 2040-cars

Auto blog

NHTSA investigating power modules on Chrysler Group SUVs and minivans

The Center for Auto Safety is officially petitioning the National Highway Traffic Safety Administration to begin scrutinizing alleged problems with the totally integrated power module (TIPM) on about 24 Chrysler Group SUVs and minivans. The advocacy group claims that the part's failure can cause affected vehicles to stall or not start at all. NHTSA is still looking into the accusations and deciding whether a full investigation is actually warranted.
The CAS petition claims at least 70 TIPM failures, but according to NHTSA, six of the complaints are for models that don't have the modules. In 34 of the reported cases, the vehicles refused to start, and in 17 of them the engine stalled. There were also two allegations of smoke and one of a fire. However, none of these affected airbag deployment or resulted in a crash.
This petition isn't the first TIPM-related problem for Chrysler Group. A recent report in the New York Times alleged that it found 240 complaints potentially related to the issue on NHTSA's website alone. In September, the automaker also recalled 230,760 examples worldwide (188,723 in the US) of the 2011 Jeep Grand Cherokee and Dodge Durango replace the fuel pump relay circuit inside of the TIPM-7 with one external to the unit. The original part could allegedly cause the models to stall without warning. Even earlier, the company also recalled about 80,000 examples of the Jeep Wrangler and Dodge Nitro in 2007 to have the module reprogrammed.

Analysts wary over FCA lawsuit but say emissions not as bad as VW

MILAN - Any potential fines Fiat Chrysler (FCA) may need to pay to settle a US civil lawsuit over diesel emissions will unlikely top $1 billion, analysts said, adding the case appeared less serious than at larger rival Volkswagen. The US government filed a civil lawsuit on Tuesday accusing FCA of illegally using software to bypass emission controls in 104,000 vehicles sold since 2014, which it said led to higher than allowable levels of nitrogen oxide (NOx) that are blamed for respiratory illnesses. FCA's shares dropped 16 percent in January when the U.S. Environmental Protection Agency (EPA) first raised the accusations, adding the carmaker could face a maximum fine of about $4.6 billion. The stock has been under pressure since. Volkswagen agreed to spend up to $25 billion in the United States to address claims from owners, environmental regulators, U.S. states and dealers. FCA, which sits on net debt of 5.1 billion euros ($5.70 billion), lacks VW's cash pile but analysts said its case looked much less severe. While VW admitted to intentionally cheating, Fiat Chrysler denies any wrongdoing. Authorities will have to prove that FCA's software constitutes a so-called "defeat device" and that it was fitted in the vehicles purposefully to bypass emission controls. Even if found guilty, the number of FCA vehicles targeted by the lawsuit is less than a fifth of those in the VW case. Applying calculations used in the German settlement, analysts estimate potential civil and criminal charges for Fiat Chrysler of around $800 million at most. Barclays has already cut its target price on the stock to take such a figure into account. Analysts also noted that FCA's vehicles are equipped with selective catalytic reduction (SCR) systems for cutting NOx emissions, so it is likely that any problem could be fixed through a software update. "Should this be the case, we estimate a total cost per vehicle of not more than around $100, i.e. around $10 million in aggregate," Evercore ISI analyst George Galliers said in a note. The estimates exclude any additional investments FCA may be asked to make in zero emissions vehicles infrastructure and awareness as was the case with VW. FCA said last week it would update the software in the vehicles in question, hoping it would alleviate the regulators' concern, but analysts said it may have been too little too late. The carmaker is also facing accusations over its diesel emissions in Europe.

Michigan Gov. Gretchen Whitmer says manufacturing can reopen May 11

Michigan Governor Gretchen Whitmer on Thursday said the state's factories can reopen next Monday, May 11, removing one of the last major obstacles to North American automakers bringing thousands of laid-off employees back to work amid the coronavirus pandemic. While reopening the manufacturing sector, Whitmer also extended her state's stay-at-home order by about two weeks to May 28, citing a desire to avoid a second wave of COVID-19, the respiratory illness caused by the novel coronavirus. “WeÂ’re not out of the woods yet, but this is an important step forward," Whitmer said in a statement. "As we continue to phase in sectors of our economy, I will keep working around the clock to ensure our businesses adopt best practices to protect workers." This week, General Motors and Fiat Chrysler Automobiles said they were targeting resuming vehicle production in North America on May 18, but suppliers would need time to prepare ahead for that date. Ford has not said what date it is targeting. The governor previously extended the state's coronavirus stay-at-home order through May 15, but had lifted restrictions for some businesses. Neighboring Ohio had allowed manufacturing to resume this past Monday, putting pressure on Whitmer to follow suit. Michigan's shutdown had stymied efforts by the Detroit Three and rival automakers to restart vehicle assembly anywhere in the United States, because so many critical parts suppliers are based in the state. Automakers and their suppliers already have begun gearing up for a possible resumption of work at their U.S. plants, but needed the official go-ahead from Whitmer. Industry officials had been pressing Whitmer to allow suppliers to reopen starting May 11 so the automakers could resume operations on their target date. They also wanted the green light so they can press Mexico to open its auto sector as suppliers there are also critical for the industry restart. The automakers' plans were tacitly approved on Tuesday by the United Auto Workers union, which represents the Detroit automakers' hourly U.S. plant workers. The union had previously said early May was "too soon and too risky" to restart manufacturing. Under Whitmer's new order, factories must adopt measures to protect workers, including daily entry screening, no-touch temperature screening as soon as possible and use of protective gear like face masks. Automakers have already rolled out such policies.