2013 Chevy Volt Premium Leather, Bose Audio, Safety Package, Loaded on 2040-cars

Auto blog

GM recalling 70k Chevy Malibus, Pontiac G6s over steering issue

A problem with the power steering system in the Chevy Malibu and Pontiac G6 has prompted General Motors and the National Highway Traffic Safety Administration to issue a recall for an estimated 69,633 vehicles. The issue revolves around the electric power steering assist, which could suddenly fail and increase the risk of a crash, especially at low speeds where the power steering is most helpful. The recall affects 2006-2007 Chevy Malibu sedans and Malibu Maxx wagons (specifically those manufactured between April 1, 2006, and June 30, 2006), as well as the Pontiac G6 (which was offered as a sedan, coupe or convertible) from the same model years and manufactured from April 18, 2006, to June 30, 2006. Owners of the affected units can expect to hear from the manufacturer with instructions to bring in their vehicles to their local dealers to have the torque sensors in the power steering system replaced. RECALL Subject : Sudden Loss of Electric Power Steering , 1 INVESTIGATION(S) Report Receipt Date: FEB 04, 2015 NHTSA Campaign Number: 15V064000 Component(s): STEERING Potential Number of Units Affected: 69,633 Manufacturer: General Motors LLC SUMMARY: General Motors LLC (GM) is recalling certain model year 2006-2007 Chevrolet Malibu and Malibu Maxx vehicles manufactured April 1, 2006, to June 30, 2006, and 2006-2007 Pontiac G6 vehicles manufactured April 18, 2006, to June 30, 2006. In the affected vehicles, there may be a sudden loss of electric power steering (EPS) assist that could occur at any time while driving. CONSEQUENCE: If power steering assist is lost, greater driver effort would be required to steer the vehicle at low speeds, increasing the risk of a crash. REMEDY: GM will notify owners, and dealers will replace the torque sensor assembly, free of charge. The manufacturer has not yet provided a notification schedule. Owners may contact Chevrolet customer service at 1-800-222-1020 or Pontiac customer service at 1-800-762-2737. GM's number for this recall is 14772. Note: This is an expansion of recall 14V-153 to cover additional vehicles built between April 1, 2006 and June 30, 2006. NOTES: Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov.

Diesel details: Comparing Ram 1500 EcoDiesel, Chevy Silverado Duramax, Ford F-150 Powerstroke

With specifications for the 2019 Ford F-150 Power Stroke diesel already out, and the details on the 2020 Ram 1500 EcoDiesel and Chevy Silverado Duramax (and its GMC Sierra twin) trickling out, we felt it was a good time to start comparing the full-size trucks' light-duty diesels. Bear in mind, we've only driven one of these new diesel trucks, so we'll be sticking to numbers for now. Some numbers haven't been announced yet, either, but stay tuned, because we'll be updating this post with additional specifications as they become available. And if you want to compare any other versions of these trucks with other vehicles, be sure to check out our comparison tool. Now let's start comparing, starting with our big chart of numbers below. As we can plainly see, these trucks are quite closely matched. Each one has six cylinders, a displacement of 3.0 liters and a turbocharger to boost it. The output of each is somewhat close, too. The Ram 1500 EcoDiesel is the torque king at 480 pound-feet, 20 more than the GM trucks and 40 more than the Ford. The GM trucks win on power, though, with 277 ponies, 17 more than the Ram, and 27 more than the Ford. GM does report that you get their trucks' peak 460 pound-feet of torque from 1,500 rpm to 3,000 rpm, whereas the others only report peak torque at a particular point in the rev band, but all of these trucks should have wide, flat torque curves as you would expect from modern turbodiesels. 2020 Ram 1500 EcoDiesel View 8 Photos Engine output is only one part of the truck performance equation. We also have towing and payload capacity, as well as fuel economy. With towing, the Ram 1500 is the current leader with a maximum capacity of 12,560 pounds. That tops the Ford F-150's 11,400-pound tow rating by well over 1,000 pounds. The F-150 can carry 2,020 pounds in its bed, but we don't know yet whether that's better or worse than the Ram or the GM trucks. We also don't have numbers for the GM trucks' towing capacities. View 9 Photos As for fuel economy, the Ford F-150 manages a thoroughly impressive 22 mpg in the city and 30 on the highway with two-wheel drive. Choosing four-wheel drive drops those numbers to 20 and 25 respectively. The fuel economy numbers for the Ram, Chevy and GMC haven't been revealed yet, but for some comparison, we can look at the old Ram EcoDiesel. That truck's best fuel economy was 20 in the city and 27 on the highway with two-wheel drive.

Our favorite mid-engine Corvette theories and rumors

The mid-engine Corvette! We just saw blurry photos through the foliage, and are hearts are all aflutter because it means that this car is real. And it's the most " never before" Corvette since 1984. Which leads us to all kinds of wacky theories and speculation. Everybody knows something or heard from a guy. None of those guys (or gals) from GM are talking to Autoblog, to be clear. But that won't stop us from stirring the pot. Let's go over a few point-by-point. The pushrod engine will be replaced by an overhead-cam V8 Car and Driver has repeatedly reported that an overhead-cam engine will come after the mid-engine Corvette's debut with an old-school pushrod. We've heard the same thing firsthand, albeit from a source with no connection to the development of the Corvette or powertrain. "At some point two valves can't pass future emissions regulations," said the guy we know. While the pushrod engine is compact, the design makes it difficult - if not impossible - for sophisticated variable valve timing (and lift) systems that control combustion with more precision. Hasty conclusion: The pushrod engine has a finite life in front of it. This one's a lock, it's a just a matter of when. Bowling Green's new paint shop is really the mid-engine assembly line Credit to Reddit for this one. Like we said, everybody knows a guy. But let's look deeper. The new paint facility costs $439 million dollars and adds 450,000 square feet, almost half the size of the existing plant. Plus GM announced another $290 million in upgrades at Bowling Green Assembly. That sure sounds like a lot of money, but you can actually spend that much on a paint booth. Porsche spent 500 million Euros (about $561 million dollars) to add the Macan assembly to its Leipzig, Germany plant in 2014. Chrysler shelled out $850 million for a paint shop in Sterling Heights, Michigan. GM spent $600 million for a new paint shop at the Fairfax (Kansas City) plant. Honda, on the other hand, is working on a thrifty $210 million project in Marysville, Ohio that includes a 300,000 square foot expansion, and the low-volume Acura NSX facility only cost $70 million. Hasty conclusion: The square footage and cost could easily mean a new assembly line instead of (or in addition to) a paint line. And if the NSX plant was really that cheap, GM could have hidden a similar sum in its existing announcements.