Fwd Lt W/1lt Suv 3.6l 3rd Row Seat 8 Passenger Seating Premium Cloth Seat Trim on 2040-cars

Auto blog

GM recalls select Tahoes, Yukons, Escalades for rear driveshaft issue

GM is recalling a number of its full-size SUVs due to an issue with the rear driveshaft assembly that could ultimately result in driveshaft failure. The actual number of total vehicles involved in the recall is small at just 1,789, but it’s spread out across the entire 2021 model year full-size GM vehicle lineup. That means a small number of every model is being recalled, including the Chevrolet Tahoe, Suburban, GMC Yukon, Yukon XL and the Cadillac Escalade and Escalade ESV. GM traced the issue back to certain driveshaft assemblies with ball bearings that were not properly heat treated. If theyÂ’re not properly heat treated, GM says that the balls may deform over time, causing noise and vibration. Continue to drive in this condition, and GM says the affected joint in the driveshaft assembly could seize, causing loss of drive power. However, the problem wonÂ’t present itself all at once, as GM says there will be a gradual increase of noises and vibrations before total failure. For those few owners with affected vehicles, GM says that it will replace the left and right rear driveshaft assemblies with properly-built units. Per usual with recalls, this will be done at your local dealership at no cost to the owner. If you have one of the recalled SUVs, expect to be notified mid-March. Related video:

Chevy finishes restoration of damaged 1 millionth Corvette

When a sinkhole at the National Corvette Museum devoured eight, rare examples of the iconic American sports car last year, some of the victims emerged better than others. While damaged, the 2009 Corvette ZR1 Blue Devil was able to drive out under its own power, making for a fairly straightforward restoration. Meanwhile, the one-millionth 'Vette came out looking like a pancake. Bringing the convertible back to perfection has taken four months and 1,200 man-hours, but the milestone car is finally on display again. After being a brief exhibit at the National Corvette Museum, the millionth 'Vette was moved to the General Motors Design Center. There, a 30-person team started on the difficult restoration. "When we disassembled it, we found that each employee involved in building it had signed a part of the car, which was fantastic and moving to see," said GM executive Mark Reuss. Therefore, the team tried to retain as many original parts as possible. The damage was extensive, and repairs included straightening the front sub-frame damage, patching the seats, and carefully restoring the dashboard pad to maintain the signatures below. The hood, front fascia, and side sills were replaced with parts from a donor vehicle. To keep the 'Vette perfect, the team scanned the names and put them on the new components. In one case, they even went back to an original employee to sign a replacement part. Surprisingly, the engine and transmission were fine. With the work done, the National Corvette's Museum's revived exhibit is nearly complete. Five of the other cars aren't being restored, and the museum is bringing the 1962 Corvette back to life. <p>Your browser does not support iframes.</p> Chevrolet Fulfills 1 Millionth Corvette Restoration Pledge Sinkhole-damaged milestone returns to National Corvette Museum 2015-09-03 BOWLING GREEN, Ky. – After more than four months and 1,200 man-hours of painstaking craftsmanship, restoration of the milestone 1 millionth Corvette – a white 1992 convertible – is complete. It was unveiled today at the National Corvette Museum, where it returns as part of the permanent exhibit. The car was damaged on Feb. 12, 2014, when it and seven other rare Corvettes tumbled into a sinkhole that opened beneath the museum's Skydome area. Chevrolet pledged to restore it.

2013 Chevy COPO Camaro announced with two new engines and manual option

Chevrolet is following up the 2012 COPO Camaro with another limited run of the drag-strip-ready production car for 2013. Ditching the superchargers, the 2013 COPO Camaro can only be equipped with one of three naturally aspirated V8 engines, and other new features include the option of a manual transmission, new front springs, some minor styling changes and a lower starting price of $86,000. All cars are designed to abide by the rules of the NHRA's Stock Eliminator or Super Stock classifications, depending on in which series buyers wish to enter their Chevrolet Camaro.
Returning for 2013 is the 427-cubic-inch V8 producing 425 horsepower, but the new engines include a 325-hp 350-CID V8 and a 375-hp 396-CID V8. Buyers can select to purchase all three engines, and each will be matched with the sequence number of that car; the track-only COPO cars will not have vehicle identification numbers and can't be registered for street use.
Chevrolet is also offering unique enthusiast-specific options such as a COPO Build Book and the opportunity for owners to help assemble their car's engine at the Chevrolet Performance Build Center in Wixom, MI.