2007 Chevrolet Trailblazer Ss on 2040-cars

Auto blog

Driving Granatelli's turbine-powered 1978 Chevy Corvette [w/video]

With its curvy snout and feminine haunches, the third-gen Chevrolet Corvette looks like a dreamy – if dated – exemplar of Sports Car Fantasy 101 when viewed through modern eyes. This particular specimen circa '78, clad in silver and black paint with red pinstripes, appears to be a well-preserved example from the era. Apart from its low-profile Pirellis, slightly raised and slotted hood, spacious stance and a certain hand-painted descriptor alongside its crossed flag logos, you'd never guess there's a Space-Age propulsion unit powering this Coke bottle-bodied ride. Climb inside, and you're presented with aircraft gauges and big, colorful square buttons in the center panel. It takes a push of the "Ignitor" button, a tap of the starter button, and a slide of a T-handle for this nearly 40-year-old sports car to start sounding like Gulfstream G650 ready for takeoff. Yep, you're sitting in an 880-horsepower, turbine-powered Corvette, the only one of its kind in the world. Welcome to the whoosh. What The...? Built by Vince Granatelli, son of Indy 500 guru Andy Granatelli, this curious Corvette came into being by cramming a Pratt & Whitney ST6N-74 gas turbine engine into the donor car's lengthy front end. The same type of Jet A-burning mill powered Granatelli Senior's STP-sponsored racecar at the 1967 Indianapolis 500, where it famously led most of the 198 of 200 laps until a $6 transmission bearing failed, knocking it out of the race. The idea of turbine power usurping internal combustion was so threatening that Indy's governing body restricted turbine performance into obsolescence thereafter. A turbine-powered Corvette sounds excessive because it is. But there are also things about this 880-horsepower, 1,161-pound-feet monster that might surprise you. While it smacks of futurist exoticism and cost a then-dizzying $37,000 in 1967, the Canadian-built powerplant uses 80 percent fewer parts than an internal combustion V8 and will run on virtually anything combustible – whiskey, diesel, even Chanel No. 5. Though it's triple the length of a V8, the Pratt & Whitney beast weighs only 285 pounds. It's also one hell of a robust workhorse, typically serving as an auxiliary power unit for commercial aircraft or a generator in oil fields, where it can run for tens of thousands of consecutive hours before needing an overhaul. To adapt the Chevrolet for jet duty, the nose section was gutted and a sub-frame was built to compensate for the loosey-goosey front end.

2016 Chevy Volt powertrain technical details

The last time General Motors launched a Chevy Volt, it was operating without really knowing how people would use the plug-in hybrid. Sure, it had experience with the EV1, but the Volt was a new kind of car, and you can see in the archives just how much time GM spent explaining this fresh, new powertrain to potential customers. Then, once the vehicle was released, the company collected voluntary data from a large number of owners to learn about their driving and charging habits. The company also asked them what they wanted most in the new version. There's got to be an algorithm buried somewhere in GM headquarters that was used to take all of the numbers GM collected and spat out the headline figures for the 2016 Volt: 50 miles of EV range and 41 miles per gallon. Another important number – price – is something GM isn't talking about yet (expect it in April or May), but the company is sharing some powertrain details about the upcoming car. At a preview lunch in Detroit last week for the SAE 2015 Hybrid & Electric Vehicles Technologies Symposium that's happening now in California, GM engineers Peter Savagian (who is presenting a paper on the new inverter used in the updated Volt) and Tim Grewe (talking about the entire second-generation powertrain) sat down with AutoblogGreen to tell us about the Volt's all-new propulsion system: The overall gist is that the new Voltec 5ET50 drive unit is lighter, smaller and more powerful thanks to a redesigned two-motor traction drive. As previously reported, the new engine is a 1.5-liter DOHC four-cylinder that offers 101-horsepower (at 5,600 RPM). Grewe said it's "great for range extension." The electric motor side of the powertrain offers 149 motoring horsepower from a two-motor, continuously variable transaxle. Initially, the new engine will be made in Mexico. GM will move production to Flint, MI during the first year it makes the 2016 Volt. The battery is slightly bigger in the new Volt – 18.4 kWh compared to 16.5 in the current-gen – and will have less range variation in the cold. GM is also using more of the overall capacity in the pack in the 2016 Volt than in previous versions, but is not saying how much more. GM is not ready to publish acceleration times just yet, but the 2016 Volt has improved numbers, especially when going from 30-60 miles per hour. Most everything on the new powertrain has become more efficient compared to the first-gen Volt.

GM takes 2020 full-size pickup sales crown

It's no secret that 2020 was an unconventional year for auto sales. Extenuating circumstances or not, it was a year of upheaval even for ever-resilient (and ever-profitable) pickups, with General Motors taking the crown from Ford in the full-size segment.  The Ford F-Series still outsold every other full-size pickup nameplate in the country by a significant margin. It's only when you combine GM's Chevrolet Silverado and GMC Sierra variants that you get a number that exceeds Ford's. This isn't really a new phenomenon, either. In fact, it was only somewhat recently that Ford took the overall full-size crown away from GM, and not only did Ford widen the gap in recent years, but Ram has once again become a legitimate challenger, even managing to outsell the Silverado by a healthy margin in 2019, but never coming close to the F-Series in terms of total volume.  But, 2020 being 2020, things got weird yet again. Ram remains relevant, of course, but Ford got caught with its pants down thanks to the one-two punch of COVID and the generational changeover of the core F-150 model, which resulted in a production interruption as the company's assembly facilities transitioned from building the old 2020 model to the new-for-2021. This perfect storm, as it turns out, was sufficient for GM to walk away with the full-size crown. See for yourself: Full-size 2020 pickup sales: GM total: 847,110 F-Series: 787,422 Silverado: 594,094 Ram: 563,676 Sierra: 253,016 Tundra: 109,203 Titan: 26,439 As you can see, Ram slipped back behind Silverado, slotting comfortably into third place. The Silverado 1500 had a flat year, but the heavy- and medium-duty variants bucked the trend and contributed to a slight uptick in sales for the nameplate, while F-Series tumbled more than 12% (nearly 110,000 units), opening the door for GM to steam ahead.  There were similarly significant shakeups in the midsize truck segment. First, 2020 was the first full year of retail sales for the Gladiator pickup, which surged to fourth place behind the stalwart Tacoma, Ranger and Colorado. GM's combined sales of the Colorado and Canyon are good enough for second place by manufacturer, but nowhere close to what it would take to dethrone Toyota.