2003 Chevy Tahoe Lt 5.3l 7 Pass Leather Dvd Bose 91k Mi Texas Direct Auto on 2040-cars

Auto blog

Did the Chevy Corvette Z06 break 7 minutes at the Ring? Not likely

"Just because it's on the internet doesn't make it true." That's rule number one, two and arguably, three, of surfing the world wide web. In today's example of this rule, we have the following. The website HorsepowerKings is claiming that a 2015 Chevrolet Corvette Z06, with the eight-speed automatic and Z07 package, managed to lap the Nurburgring Nordschleife in under seven minutes. To put that in perspective, that super-quick time would put the 650-horsepower, $97,000 (the price of a 2LZ with the Z07/8AT combo) Z06 a mere two seconds slower around the world's most challenging race track than the $929,000, 887-horsepower Porsche 918 Spyder Weissach. It's about eight seconds quicker than Nissan's own test of the GT-R Nismo Track Pack and 13 seconds faster than a Dodge Viper ACR. Unfortunately, Chevy says there isn't anything to it. We reached out to the Bowtie's Monte Doran, who confirmed that HK's claims are "not accurate." "Any one – a manufacturer, a journalist, a guy standing on the fence of the Ring – can claim a lap time. As such, we think the in-car video is essential to proving a time is real and credible, and Chevrolet will not release a lap until we have a video to substantiate the claim," Doran told Autoblog. "Chevrolet accumulated nearly 1,000 miles of testing on the Nurburgring with the Z06. During that time, we only had two opportunities to run a lap on video – and both were rained out. If we get a lap on video, we will post an official time." Doran finished by referencing the "only official lap time" for the Z06 – a 2:41 around the Virginia International Raceway. Frankly, we aren't terribly surprised by Chevy's position. One would imagine if the Z06 were matching million-dollar hypercars around the 'Ring, the company would literally be screaming about it from Renaissance Center's rooftop. As this is quite the opposite of that, though, we're betting that the real Z06 lap time - while still likely very, very fast – won't be quite quick enough to frighten the brightest and best of today's hypercars.

Man spent $75 on a truck that lasted 38 years

Absurd as it is, some buyers today are worried about getting their car to last throughout the term of their seven-year car loan. Minnesota resident Bob Sportel has the opposite issue: his Chevrolet truck seemingly won't die. Sportel needed a cheap ride to get to work when he took a job at a farmer's co-op 38 years ago, so he bought a rusty 1957 Chevy pickup for $75 from a farmer; at the time, the 20-year-old truck was almost as old as Bob was. After nearly four decades of daily driving and an estimated 300,000 miles, Sportel is still driving the truck today. Bolts secure a fender, Bondo secures the lights, what looks like a whole roll of duct tape keeps him sitting on the bench seat instead of in it. For a 58-year-old pickup that's never seen a garage or a new coat of paint – but did get its oil changed four times a year – that's not bad; Sportel thinks his repair bill hasn't got above $1,000 for the entire time he's owned the truck. He still has no plans to get rid of it, saying, "It just becomes a part of you." You can watch his story in the video above. News Source: KARE11.com Chevrolet Truck Classics Videos

GM recalls 8,500 Chevrolet Malibu models for rear suspension glitch

According to a letter from General Motors to the National Highway Traffic Safety Administration, flaws in the build process of the 2013 Chevrolet Malibu have led to the recall of 8,519 cars. Units built between December 6, 2011 and January 15, 2013 may have been assembled with rear suspension cradles that had insufficient torque applied to certain bolts. That out-of-spec assembly could lead to issues ranging from slight noises to a loss of vehicle control.
The problem was first noticed in December of last year by a GM test fleet driver and eventually tracked back to the improperly torqued bolts on the suspension cradle assembled through July 2012 by a supplier located not too far from the Malibu's Detroit/Hamtramck Assembly Plant. Since an official NHTSA recall notice has not been issued yet, it isn't clear whether or not Detroit-built Malibus were the only ones affected (the 2013 Malibu is also built at GM's Fairfax Assembly Plant in Kansas City, Kansas). Dealers will fix the problem by inspecting vehicles for proper torque specs, retightening if not within specs and, in some cases, perform a rear-wheel alignment.