1999 Chevrolet Tahoe Lifted Tx Truck Solid Front Axle 4x4 on 2040-cars

Auto blog

2016 Camaro gets most revealing tease yet

Chevrolet started its long teaser campaign for the 2016 Camaro by just revealing the exhaust manifold and front frame, but as time has passed the company has slowly unveiled more. In the latest glimpse ahead of the pony car's May 16 debut, we're actually getting to see the model's profile completely undisguised. As suggested by the recent tease of the rear and hood, the 2016 Camaro wears a sharper, more angular design than the current model. This is especially the case when you look at the taut lines making up the rear. Chevy claims that the new shape underwent 350 hours of wind tunnel tests to be able to generate left lift, improve cooling and reduce wind noise in the cabin. A smooth underbody pan is among the aerodynamic tweaks, and it runs from underneath the front grille to the center of the Camaro. Chevy asserts that all of the changes at the front help reduce lift by 30 percent. Related VIdeo: 2016 Camaro is all about the Aero Total aerodynamic lift improved by 30 percent for improved stability 2015-05-11 DETROIT – After 350 hours of wind tunnel testing – often 24 hours a day – the new Camaro will slip more easily through the wind, and drivers of the Camaro SS will experience a marked improvement in reduced aerodynamic lift. These changes illustrate the lengths the aerodynamics team went to for improved performance, stability, cooling and lower wind noise intrusion "The importance of aerodynamics increases exponentially as we increase vehicle performance," said Kirk Bennion, Exterior Design manager. "As engine output increases, we need more engine cooling. As acceleration and top speeds climb, we need to reduce lift for better high-speed stability. However, we cannot make any changes at the expense of increasing drag, which can hurt fuel economy. "To balance these different aerodynamic targets, we tested literally hundreds of changes on the new Camaro, millimeters at a time." For example, the initial design called for the lower grille bars to be set at a 20-degree angle to the horizon. However, after meticulous testing, the team improved engine-cooling airflow by 1 percent by shifting the angle to 13 degrees – a change that achieved the airflow target while maintaining the original grille design. And rather than a traditional front air dam to reduce aerodynamic lift, the team developed a flush belly pan that stretches from the front grille to the center of the vehicle.

Question of the Day: Worst year of the Malaise Era?

The Malaise Era for cars in the United States spanned the 1973 through 1983 model years, and featured such abominations as a Corvette with just 205 horsepower (from the optional engine!) and MGBs with suspensions jacked way up to meet new headlight-height requirements. There were many low points throughout this gloomy period, of course. The horrifyingly low power and fuel-economy numbers for big V8s during the middle years of the Malaise Era make a strong case for 1974 or 1975— the years of Nixon's resignation and the Fall of Saigon, respectively— as the most Malaisey years. But then the GM-pummeling debacles of the Chevy Citation and Cadillac Cimarron could make an early-1980s year the low point. 1979, the year of the ignominious Chrysler bailout? You choose! Related Video:

Next-gen GMC Sierra spied with diesel power

The next generation of GM trucks is arriving soon, and we're expecting a huge leap forward over the current lineup. The Chevy Silverado and the GMC SIerra sell extremely well, but haven't done much to move the segment forward in a long time. The Ford F-150 has an all-aluminum body and turbocharged V6 power. The Ram 1500 gained a diesel and coil spring suspension. These spy shots show that diesel may be in the cards for GM. Some quick shots and copious use of flash show what is most likely a tank for diesel exhaust fluid and a diesel particulate filter, both necessary equipment for any modern diesel. It's unclear what form factor that engine will come in, though GM has a number of engines to choose from, including the 2.8-liter inline four that's found in the Colorado and Canyon, though that may be a little light duty for the Silverado and Sierra. Other rumors surrounding the trucks suggest a move to an aluminum cab while retaining a steel bed. That seems like a reasonable move for GM, even if the company was attempting to shame Ford for its move to aluminum a few years ago. Look for more news as early as the Detroit Auto Show in January. Related Video: Featured Gallery 2019 GMC Sierra spy shots View 21 Photos Image Credit: Spied Bilde Spy Photos Chevrolet GMC Truck