1935 Chevrolet Standard 206.8 Ci I6, 3-spd, Black Exterior, 6 Volt, Steel Body on 2040-cars
Newfield, New Jersey, United States
Vehicle Title:Clean
Engine:206.8 cu I6
For Sale By:Dealer
VIN (Vehicle Identification Number): M5438309
Mileage: 39999
Make: Chevrolet
Model: Standard
Doors: 2
Exterior Color: Black
Interior Color: Tan
VIN: M5438309 Cylinders: 6-Cyl.
Trim: 206.8 ci I6, 3-Spd, Black Exterior, 6 Volt, Steel Body
Auto Services in New Jersey
Young Volkswagen Mazda ★★★★★
Wrenchtech Auto ★★★★★
Ultimate Collision Inc ★★★★★
Tang`s Auto Parts ★★★★★
Superior Care Auto Center ★★★★★
Sunoco ★★★★★
Auto blog
GM Ultium tech can scavenge heat from everywhere, even you
Mon, Apr 25 2022GM likes to give us tidbits about its Ultium platform from time to time, and today it’s telling us about the platformÂ’s ability to capture waste heat from the propulsion system. In addition to capturing from the propulsion system, it can also capture humidity from both inside and outside the vehicle and even from passengersÂ’ body heat. Yes, you, your family and/or your friends are a usable heat source as far as GM EVs are concerned. It then deploys the heat in an advantageous way. If at this point, youÂ’re screaming, "Heat pump!" youÂ’d be right. WeÂ’re talking about an elaborate heat pump system that GM is using for its Ultium-based vehicles. Every Ultium-based GM vehicle gets this system that is covered by 11 patents and four publications. The waste heat it collects is used in a number of ways, but its primary use is to heat the cabin quickly and efficiently. GM claims it can heat the cabin of its Ultium-based vehicles quicker than vehicles with traditional internal combustion engines. Plus, when put to use, GM claims that using the heat pump provides its EVs with up to 10% more range than theyÂ’d have without. Beyond heating the cabin, the heat pump is capable of putting waste heat to use by preheating the battery prior to charging so that you can charge quicker. The system can even cool the propulsion system in preparation for Watts to Freedom (WTF) launch control starts. GM says this was vital in helping the Hummer EV achieve its bonkers 0-60 mph time of about 3 seconds. “Having a ground-up EV architecture gives us the freedom to build in standard features like UltiumÂ’s energy recovery capabilities,” said Doug Parks, GM executive VP of global product development, purchasing and supply chain. “This helps us squeeze more efficiency, performance and overall customer benefit out of our EVs.” GM says itÂ’s been developing heat pump technology since the EV1 and its heat pump. This is the modern evolution of that technology, and GM says itÂ’s going to be implemented in every Ultium-based vehicle as a standard feature. Related video: Green Cadillac Chevrolet GM GMC Technology Electric Future Vehicles
Driving Granatelli's turbine-powered 1978 Chevy Corvette [w/video]
Thu, Jan 8 2015With its curvy snout and feminine haunches, the third-gen Chevrolet Corvette looks like a dreamy – if dated – exemplar of Sports Car Fantasy 101 when viewed through modern eyes. This particular specimen circa '78, clad in silver and black paint with red pinstripes, appears to be a well-preserved example from the era. Apart from its low-profile Pirellis, slightly raised and slotted hood, spacious stance and a certain hand-painted descriptor alongside its crossed flag logos, you'd never guess there's a Space-Age propulsion unit powering this Coke bottle-bodied ride. Climb inside, and you're presented with aircraft gauges and big, colorful square buttons in the center panel. It takes a push of the "Ignitor" button, a tap of the starter button, and a slide of a T-handle for this nearly 40-year-old sports car to start sounding like Gulfstream G650 ready for takeoff. Yep, you're sitting in an 880-horsepower, turbine-powered Corvette, the only one of its kind in the world. Welcome to the whoosh. What The...? Built by Vince Granatelli, son of Indy 500 guru Andy Granatelli, this curious Corvette came into being by cramming a Pratt & Whitney ST6N-74 gas turbine engine into the donor car's lengthy front end. The same type of Jet A-burning mill powered Granatelli Senior's STP-sponsored racecar at the 1967 Indianapolis 500, where it famously led most of the 198 of 200 laps until a $6 transmission bearing failed, knocking it out of the race. The idea of turbine power usurping internal combustion was so threatening that Indy's governing body restricted turbine performance into obsolescence thereafter. A turbine-powered Corvette sounds excessive because it is. But there are also things about this 880-horsepower, 1,161-pound-feet monster that might surprise you. While it smacks of futurist exoticism and cost a then-dizzying $37,000 in 1967, the Canadian-built powerplant uses 80 percent fewer parts than an internal combustion V8 and will run on virtually anything combustible – whiskey, diesel, even Chanel No. 5. Though it's triple the length of a V8, the Pratt & Whitney beast weighs only 285 pounds. It's also one hell of a robust workhorse, typically serving as an auxiliary power unit for commercial aircraft or a generator in oil fields, where it can run for tens of thousands of consecutive hours before needing an overhaul. To adapt the Chevrolet for jet duty, the nose section was gutted and a sub-frame was built to compensate for the loosey-goosey front end.
U.S. new-vehicle sales in 2018 rise slightly to 17.27 million [UPDATE]
Thu, Jan 3 2019DETROIT — Sales of new vehicles in the U.S. rose slightly in 2018, defying predictions and highlighting a strong economy. Automakers reported an increase of 0.3 percent over a year ago to 17.27 million vehicles. The increase came despite rising interest rates, a volatile stock market, and rising car and truck prices that pushed some buyers out of the new-vehicle market. Industry analysts and automakers said strong economic fundamentals pushed up sales and should keep them near historic highs in 2019. "Economic conditions in the U.S. are favorable and should continue to be supportive of vehicle sales at or around their current run rate," Ford Chief Economist Emily Kolinski Morris said after the company and other automakers announced their sales numbers Thursday. That auto sales remain near the 2016 record of 17.55 million is a testimonial to the strength of the economy, said Mark Zandi, chief economist at Moody's Analytics. The job market, he said, has created new employment, and wage growth has accelerated. "That's fundamental to selling anything," he said. "If there are lots of jobs and people are getting bigger paychecks, they will buy more." The unemployment rate is 3.7 percent, a 49-year low. The economy is thought to have grown close to 3 percent last year, its best performance in more than a decade. Consumers, the main driver of the economy, are spending freely. The Federal Reserve raised its key interest rate four times in 2018 but is only expected to raise it twice this year. Auto sales also were helped by low gasoline prices and rising home values, Zandi said. It all means that people are likely to keep buying new vehicles this year even as they grow more expensive. The Edmunds.com auto-pricing site estimates that the average new vehicle price hit a record $35,957 in December, about 2 percent higher than the previous year. It will be harder for automakers to keep the sales pace above 17 million because they have been enticing buyers for several years now with low-interest financing and other incentives, Zandi said. He predicts more deals in the coming year as job growth slows and credit tightens for higher-risk buyers. Edmunds, which provides content, including automotive tips and reviews, for distribution by The Associated Press, predicts that sales will drop this year to 16.9 million.























