5.3l V8 Lt Z71 Lifted Off Road Grill Guard Power Seat Bedliner Bose Tow 6cd 4x4 on 2040-cars

Auto blog

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck

It's possible to go 111 miles on electricity in the new Chevy Volt

Wayne Gerdes at CleanMPG put the 2016 Chevrolet Volt in Premiere trim through a few closely watched on-the-road tests over a few days. One of them was a run from full charge to EV-only exhaustion, and at the end of the trip Gerdes had traveled 111.0 indicated miles on a single charge, 111.9 according to his Garmin. What's the catch? He guessed his average speed was about 20 miles per hour, which was 15 and 20 mph around town and "a few miles" at 50 mph on the highway. The EPA says the new Volt should go 53 miles on battery power. In the 2011 Volt, rated at 38 electric miles, Gerdes got 75.5 miles on a charge. The upshot is that at urban driving at average speeds should get drivers the EPA rated 53 e-mpg without fuss. He wasn't so impressed with performance in Charge Sustaining Mode, though. During one run that covered 101.2 actual miles in CSM, using 1.691 gallons, the Volt got 59.8 mpg. Speaking of driving in CSM only, Gerdes said it's less efficient here than in competitors from Toyota, Honda, and Hyundai, but that's one of the few performance-related complaints he had. Elsewhere around the PHEV, Gerdes liked improvements to the eight-inch display and rear-view camera, build and design quality, the much quieter ride, and the switch to regular fuel. The six-foot Gerdes found the cabin space still cozy, especially in the back where ingress and egress could be a challenge for people of a certain stature. He lamented the fact that he couldn't find instantaneous fuel and energy consumption or among the many readouts, and would prefer the sedan kicked into glide mode sooner. In spite of that, he declares the Volt II "a full blown electric car." Head over to CleanMPG for the rest of his assessment.

With only 246 Volts sold in Australia, Holden not getting next-gen model

The Chevrolet Volt has not been the resounding success General Motors hoped for here in the United States. But it's fortunes in Chevy's home country are nothing compared to how poorly it's done down under. Only 246 Volts have been sold in Australia, where the car is branded as a Holden, since its debut in 2012. That's not just a bad showing – it's an absolute disaster. According to Motoring.com.au, it was the Volt's astonishing $60,000 price tag, combined with a lack of interest from Aussie drivers, that killed the car's chances. What's fascinating about this development, though, is that it doesn't necessarily seem to be Holden that's pulling the plug. Instead, it's the Volt's Hamtramck, MI factory, which is preparing to shift into production of the second-generation model that seems to be taking the blame. According to Motoring, the plant confirmed that it will only build the Gen 2 plug-in in left-hand-drive form, basically ruling out a model for Australia. "Electric and hybrid vehicles haven't taken off in Australia," Holden's director of communications, Sean Poppitt, told Motoring. "Considering the lack of infrastructure, the lack of government incentives, the large distances between cities, it's a tough sell." The death of the right-hand drive Volt won't be the only loss of business in Hamtramck. Opel has already confirmed that it will drop the plug-in's European fraternal twin, the Ampera, while the next-gen Chevy won't make the trip across the pond either. Related Video: