1998 Chevy S10 Ls on 2040-cars

Auto blog

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck

GM puts 3 million miles on hydrogen fuel cell test fleet

Have General Motors' hydrogen fuel-cell vehicles emitted enough water vapor over the past six-plus years to equal the steam coming out of Old Faithful? Not exactly, but GM has released a few figures related to the Project Driveway initiative it began in 2007. The numbers are impressive, if not quite of the geyser-spouting variety. In all, the General converted 119 Chevrolet Equinox SUVs to run on hydrogen, and those vehicles have just collectively surpassed the 3 million mile mark. And if you were waiting for us to tell you that the distance equals a half-dozen round trips between the earth and the moon, well, there you go. The better news is that the SUVs have combined to save almost 158,000 gallons worth of gas, and some of the vehicles have more than 120,000 miles on them. More than 5,000 drivers have participated in the project. GM reached that landmark about 10 months after it announced that it was working with Honda to accelerate the development of hydrogen fuel-cell powertrain technology. The two companies estimated last summer that it may have something to sell to the public as soon as 2020. For now, you can check out General Motors' press release below. GM Fuel Cell Fleet Tops 3 Million Miles Chevrolet Equinox fuel cell vehicles driven in real world reach milestone DETROIT – General Motors' fleet of fuel cell vehicles recently passed 3 million miles of hydrogen-powered, real-world driving. Some individual vehicles have accumulated more than 120,000 miles. By GM's estimate, using hydrogen to power these vehicles, the fleet has avoided 157,894 gallons of gasoline consumption. This specially equipped fleet of Chevrolet Equinox Fuel Cell vehicles are part of GM's 119-vehicle Project Driveway program, which launched in 2007. Since then, more than 5,000 drivers have provided feedback on the functionality and drivability of fuel cell technology. "Hydrogen fuel cell technology is an important part of GM's advanced propulsion portfolio and we continue to make substantial progress in furthering this technology," said Charlie Freese, executive director of GM's global fuel cell engineering activities. "These vehicles have operated through seven full winters and a wide range of environmental conditions, proving that fuel cells can meet the demands of real-world drivers." Last year, GM announced two fuel cell-related collaborations.

Corvette Z06 and Viper TA square off at the strip

There are many long-standing grudge matches among automobiles: 911 vs GT-R, Mustang vs Camaro, Ferrari vs Lamborghini... but as far as high-end American metal goes, it doesn't get much more legendary than Viper vs 'Vette. So after Chevy released the new Corvette Z06, we knew it was only a matter of time before it would have to square off against the Viper TA. And what better place to pit these two parallel pillars of American performance than on the drag strip? Fortunately that's just what we have here. In one corner, the 2014 Dodge Viper TA, with its 8.4-liter V10 pumping out 640 horsepower and 600 pound-feet of torque. In the other, the 2015 Chevrolet Corvette Z06, the supercharger on its 6.2-liter V8 more than making up for the discrepancy in displacement and cylinder count to produce 650 hp and just as much torque. But numbers don't tell the whole story, so watch the video clip to see which reaches the end of the quarter-mile first. News Source: To the Floor via YouTubeTip: James Chevrolet Dodge Videos drag race chevy corvette z06 quarter mile drag strip srt viper ta