Find or Sell Used Cars, Trucks, and SUVs in USA

1957 Chevy Pickup on 2040-cars

Year:1957 Mileage:0 Color: Red /
 1988 plymouth sundance seats
Location:

Meridian, Idaho, United States

Meridian, Idaho, United States
Advertising:
Transmission:Process manual trans from an early 80's Chevy PU
Body Type:6.5' bed
Engine:edelbrock 4 barrel car
Vehicle Title:Clear
For Sale By:Private Seller
VIN: 3A57L113495 Year: 1957
Exterior Color: Red
Make: Chevrolet
Interior Color: 1988 plymouth sundance seats
Model: Other Pickups
Trim: 2-door
Drive Type: Std
Mileage: 0
Condition: UsedA vehicle is considered used if it has been registered and issued a title. Used vehicles have had at least one previous owner. The condition of the exterior, interior and engine can vary depending on the vehicle's history. See the seller's listing for full details and description of any imperfections.Seller Notes:"It has a new 350 chevy crate motor from Scoggins-Dickey, with new 4 barrel Edelbrock carb and K&N air filter from Summit Racing. Alternator and distributer from a late 1980's Impala. Bought and had a professional teardown and reassembly of a 4 speed (OD) New Process (New Venture Gear) manual floor shift trany (from a 1983+/- chevy PU), installed with a new clutch. Replaced brakes, wheel cilinders and master cylinder. Rebuilt stock radiator.Since 1998, the truck has been in storage and only driven one or twice a year to make sure it runs and for fresh gas.The engine starts well and runs OK but a little rough (needs a tune-up). Engine only has a few hundred miles since it was installed new. The glass is all great. Windows roll down. The body looks pretty good. It needs a new hood since it has a large gouge in it. There is also a dent above the driver headlight. I can send more detailed photos of any of the dents if you'd like. Just please forward your email to me."

Mileage is unknown. The new engine has a few hundred miles.


Located in Boise, ID. Winning bidder must pick-up or arrange for shipping.

Purchased in Nampa, ID in 1988. All the work on the engine and transmission was done the year or so after purchase.

It has been in storage since then. Still starts up perfectly.



Auto Services in Idaho

Spokane Sunscreen Window Tntng ★★★★★

Auto Repair & Service, Window Tinting, Glass Coating & Tinting
Address: 11421 E Sprague Ave, Hauser
Phone: (509) 928-2414

Silverlake Tire & Auto ★★★★★

Auto Repair & Service, New Car Dealers, Automobile Parts & Supplies
Address: 274 W Hanley Ave, Post-Falls
Phone: (208) 772-6081

Robinson Auto Glass Experts ★★★★★

Auto Repair & Service, Automobile Parts & Supplies, Windshield Repair
Address: 495 1st St, Shelley
Phone: (208) 534-9974

Recovery Masters Towing ★★★★★

Auto Repair & Service, Towing, Construction & Building Equipment
Address: 55 N Cedar St, Worley
Phone: (208) 777-9848

Jordan Wholesale ★★★★★

Used Car Dealers, Tractor Dealers, Farm Equipment
Address: 3200 W Seltice Way, Rathdrum
Phone: (208) 777-0234

Bonanza Motors Inc ★★★★★

Auto Repair & Service, New Car Dealers, Used Car Dealers
Address: 325 Overland Ave, Paul
Phone: (208) 678-1234

Auto blog

Fernando Alonso sputters in his Indy test

Thu, Apr 25 2019

INDIANAPOLIS — Helio Castroneves and Fernando Alonso kept waiting around Wednesday. Now both international stars have some unfinished business to take care before qualifying for this year's Indianapolis 500. After enduring a rain delay of more than four hours then watching IndyCar regulars turn laps at Indianapolis Motor Speedway for two more hours, Castroneves and Alonso finally made it onto the track — but couldn't quite complete their refresher course. "Happy to be back here because this place is great," Alonso said after posting a fast lap of 218.690 mph — the slowest of the nine-driver evening session. "We were slow because the weather and some of the decisions people made on running time and things like that." He faced a bevy of problems in his first trip back to Indy since an impressive rookie performance in 2017. The rain delay forced organizers into rescheduling the one-day test, moving the rookie and refresher driver time from midday to the evening, cutting a significant amount of practice time for Alonso and the others. And when the green flag finally waved, Alonso's No. 66 car stalled in the warmup lane forcing the two-time Formula One champion from Spain to be towed back to pit lane where his crew worked feverishly to fix an electrical problem while sat in the cockpit. Eventually, he did get out and passed the first of two refresher phases. He'll have to wait until opening practice of the 500 on May 14 to pass the second. "It was frustrating for everyone because it was a brand new chassis and a brand new car, so we expected to run a lot," said Alonso, who drives for McLaren Racing. "If we could have had this at midday, you could work on your issues in the afternoon and then go out again." To put his day in perspective, Takuma Sato, the 2017 Indy winner from Japan, posted the fastest lap of the day at 226.993 mph and Colton Herta was the fastest rookie at 226.108. Castroneves, as usual, was good right from the start and posted a fast lap of 225.565. The three-time Indianapolis 500 winner looked smooth and fast on his favorite track and wasted no time passing the first phase. That much should have been expected from the popular Brazilian, who has recorded seven top-three finishes in 18 Indy starts and will make his season debut May 11 in the IndyCar Grand Prix. The weather and yellow flags prevented four of the five veterans — Castroneves, Alonso, Oriol Servia and JR Hildebrand — from passing phase two. Only Indy native Conor Daly made it.

2016 Camaro gets most revealing tease yet

Mon, May 11 2015

Chevrolet started its long teaser campaign for the 2016 Camaro by just revealing the exhaust manifold and front frame, but as time has passed the company has slowly unveiled more. In the latest glimpse ahead of the pony car's May 16 debut, we're actually getting to see the model's profile completely undisguised. As suggested by the recent tease of the rear and hood, the 2016 Camaro wears a sharper, more angular design than the current model. This is especially the case when you look at the taut lines making up the rear. Chevy claims that the new shape underwent 350 hours of wind tunnel tests to be able to generate left lift, improve cooling and reduce wind noise in the cabin. A smooth underbody pan is among the aerodynamic tweaks, and it runs from underneath the front grille to the center of the Camaro. Chevy asserts that all of the changes at the front help reduce lift by 30 percent. Related VIdeo: 2016 Camaro is all about the Aero Total aerodynamic lift improved by 30 percent for improved stability 2015-05-11 DETROIT – After 350 hours of wind tunnel testing – often 24 hours a day – the new Camaro will slip more easily through the wind, and drivers of the Camaro SS will experience a marked improvement in reduced aerodynamic lift. These changes illustrate the lengths the aerodynamics team went to for improved performance, stability, cooling and lower wind noise intrusion "The importance of aerodynamics increases exponentially as we increase vehicle performance," said Kirk Bennion, Exterior Design manager. "As engine output increases, we need more engine cooling. As acceleration and top speeds climb, we need to reduce lift for better high-speed stability. However, we cannot make any changes at the expense of increasing drag, which can hurt fuel economy. "To balance these different aerodynamic targets, we tested literally hundreds of changes on the new Camaro, millimeters at a time." For example, the initial design called for the lower grille bars to be set at a 20-degree angle to the horizon. However, after meticulous testing, the team improved engine-cooling airflow by 1 percent by shifting the angle to 13 degrees – a change that achieved the airflow target while maintaining the original grille design. And rather than a traditional front air dam to reduce aerodynamic lift, the team developed a flush belly pan that stretches from the front grille to the center of the vehicle.

Read This: Auto Extremist advocates for Corvette as brand with multiple models [w/poll]

Fri, 25 Jan 2013

The 2014 Chevrolet Corvette really grinds Peter De Lorenzo's gears. Or, more accurately, the self-anointed Auto Extremist has an issue with what he sees as mismanagement of the legendary sports car by General Motors executives. In a new editorial on his website, De Lorenzo argues it's time to split Corvette off from Chevrolet to create an all-new brand, complete with a model range with at least three new takes on the sports car. Capable of fully leveraging the successes of the Corvette Racing program and brandishing the full might of GM's technical prowess, the Corvette brand would theoretically give Porsche something to sweat over.
Sure, that sounds like a party, but given GM's troubled track record when it comes to launching (let alone managing) brands, we say that's slippery slope that could just as easily end with the whole Corvette franchise in the scrap bin. Either way, the notion is certainly an interesting one. Head over to Auto Extremist to take in the full editorial, and then let us know what you think in Comments. Should GM split off its most storied nameplate?
View Poll