1970 Chevrolet Nova Ii Coupe on 2040-cars

Auto blog

Driving Granatelli's turbine-powered 1978 Chevy Corvette [w/video]

With its curvy snout and feminine haunches, the third-gen Chevrolet Corvette looks like a dreamy – if dated – exemplar of Sports Car Fantasy 101 when viewed through modern eyes. This particular specimen circa '78, clad in silver and black paint with red pinstripes, appears to be a well-preserved example from the era. Apart from its low-profile Pirellis, slightly raised and slotted hood, spacious stance and a certain hand-painted descriptor alongside its crossed flag logos, you'd never guess there's a Space-Age propulsion unit powering this Coke bottle-bodied ride. Climb inside, and you're presented with aircraft gauges and big, colorful square buttons in the center panel. It takes a push of the "Ignitor" button, a tap of the starter button, and a slide of a T-handle for this nearly 40-year-old sports car to start sounding like Gulfstream G650 ready for takeoff. Yep, you're sitting in an 880-horsepower, turbine-powered Corvette, the only one of its kind in the world. Welcome to the whoosh. What The...? Built by Vince Granatelli, son of Indy 500 guru Andy Granatelli, this curious Corvette came into being by cramming a Pratt & Whitney ST6N-74 gas turbine engine into the donor car's lengthy front end. The same type of Jet A-burning mill powered Granatelli Senior's STP-sponsored racecar at the 1967 Indianapolis 500, where it famously led most of the 198 of 200 laps until a $6 transmission bearing failed, knocking it out of the race. The idea of turbine power usurping internal combustion was so threatening that Indy's governing body restricted turbine performance into obsolescence thereafter. A turbine-powered Corvette sounds excessive because it is. But there are also things about this 880-horsepower, 1,161-pound-feet monster that might surprise you. While it smacks of futurist exoticism and cost a then-dizzying $37,000 in 1967, the Canadian-built powerplant uses 80 percent fewer parts than an internal combustion V8 and will run on virtually anything combustible – whiskey, diesel, even Chanel No. 5. Though it's triple the length of a V8, the Pratt & Whitney beast weighs only 285 pounds. It's also one hell of a robust workhorse, typically serving as an auxiliary power unit for commercial aircraft or a generator in oil fields, where it can run for tens of thousands of consecutive hours before needing an overhaul. To adapt the Chevrolet for jet duty, the nose section was gutted and a sub-frame was built to compensate for the loosey-goosey front end.

Cadillac could base its entry-level sedan on the Chevy Cruze [UPDATE]

UPDATE: Cadillac spokesperson Donny Nordlicht tells Autoblog , "The post speculating on a future Cadillac model derived from the Chevrolet Cruze is completely false." Premium automakers Mercedes-Benz and Audi have seen plenty of success with new small front-drive-based sedans. The CLA-Class had its best January ever this year, while Audi moved more of its new A3 in 2015 than its predecessor sold in 2005 through 2010 combined. The fact that Cadillac wants a piece of that pie is no surprise, then. There's a new rumor that GM's luxury brand could launch its own compact – possibly called CT2 – to battle the Germans. Cadillac, a brand that's pushed hard to rebuild its rear-drive reputation, could develop a new entry-level model based on the front-wheel-drive 2016 Chevrolet Cruze's D2XX platform. Go ahead and make your Cimarron jokes. Sources are telling GM Inside News that a Cadillac built on the Delta platform would ditch the Cruze's turbocharged 1.4-liter four-cylinder for a 1.5-liter turbo in base models. General Motors' well received 2.0-liter turbo four would serve in higher-end models. According to GMIN, the Delta-based Cadillac would likely command a $6,000 to $9,000 premium over the Cruze, so figure $23,000 to $26,000 on the low end to $30,000 to $33,000 for something at the top of the range. As much as we dislike the kind of badge engineering that brought us the Cavalier-based Cadillac Cimarron in the '80s, the company has done an admirable job of distinguishing vehicles on shared platforms lately. A Delta-platform Cadillac would at least have a good basis – the new Cruze is surprisingly comfy. That said, we question GM's rationale if this rumor is indeed true. Put simply, Cadillac needs another sedan like I need another student loan payment. The company has four sedans, three of which overlap two segments, and none of which are selling very well. That's not because they're bad, but because customers want crossovers, of which Caddy has but one – the new XT5. Spending the time and money to add a fifth sedan to the mix when the company desperately needs to flesh out its CUV range would be a tremendous mistake. As much as we hate to say it, if Cadillac really wants to add a small, entry-level car to its range, it'd better be a crossover. Related Video:

"Turbo" Chevrolet Camaro is a 700-HP fantasy car come to life [w/video]

For a concept car built to promote an animated movie about a snail that wants to go racing, this thing ain't half bad. The outsized monster you see before you started life as a Chevrolet Camaro ZL1, and then went through a big-time Hollywood makeover before being positioned on the Chevrolet stand here in Chicago.
This 2013 "Turbo" Camaro Coupe is getting the promotion machine ratcheted up for a new DreamWorks tale by the name of, you guessed it, Turbo. Coming this summer, the movie will follow one snail's quest to become a race driver worthy of making the cut at the Indy 500. Like many DreamWorks vehicles before it, we're guessing that the petrolhead snail will star in a movie that adults (especially racing fans) with have no trouble watching with their kids. Check out the trailer below to see if you agree.
As for the car, we're told that it is "instrumental" in transforming Turbo from snail into racer. Helping the beastly pony car in this mighty task, is an ankle-cracking front splitter matched by a ungodly huge rear wing out back, a COPO hood and a supercharged (yes, supercharged) V8 engine making more than 700 horsepower. 24-inch wheels all the way around - 10-inches wide in front and 15-inches wide in back - should allow the "Turbo" Camaro to hook up with ease, as well.