1967 Nova Pro Street on 2040-cars

Auto blog

Driving Granatelli's turbine-powered 1978 Chevy Corvette [w/video]

With its curvy snout and feminine haunches, the third-gen Chevrolet Corvette looks like a dreamy – if dated – exemplar of Sports Car Fantasy 101 when viewed through modern eyes. This particular specimen circa '78, clad in silver and black paint with red pinstripes, appears to be a well-preserved example from the era. Apart from its low-profile Pirellis, slightly raised and slotted hood, spacious stance and a certain hand-painted descriptor alongside its crossed flag logos, you'd never guess there's a Space-Age propulsion unit powering this Coke bottle-bodied ride. Climb inside, and you're presented with aircraft gauges and big, colorful square buttons in the center panel. It takes a push of the "Ignitor" button, a tap of the starter button, and a slide of a T-handle for this nearly 40-year-old sports car to start sounding like Gulfstream G650 ready for takeoff. Yep, you're sitting in an 880-horsepower, turbine-powered Corvette, the only one of its kind in the world. Welcome to the whoosh. What The...? Built by Vince Granatelli, son of Indy 500 guru Andy Granatelli, this curious Corvette came into being by cramming a Pratt & Whitney ST6N-74 gas turbine engine into the donor car's lengthy front end. The same type of Jet A-burning mill powered Granatelli Senior's STP-sponsored racecar at the 1967 Indianapolis 500, where it famously led most of the 198 of 200 laps until a $6 transmission bearing failed, knocking it out of the race. The idea of turbine power usurping internal combustion was so threatening that Indy's governing body restricted turbine performance into obsolescence thereafter. A turbine-powered Corvette sounds excessive because it is. But there are also things about this 880-horsepower, 1,161-pound-feet monster that might surprise you. While it smacks of futurist exoticism and cost a then-dizzying $37,000 in 1967, the Canadian-built powerplant uses 80 percent fewer parts than an internal combustion V8 and will run on virtually anything combustible – whiskey, diesel, even Chanel No. 5. Though it's triple the length of a V8, the Pratt & Whitney beast weighs only 285 pounds. It's also one hell of a robust workhorse, typically serving as an auxiliary power unit for commercial aircraft or a generator in oil fields, where it can run for tens of thousands of consecutive hours before needing an overhaul. To adapt the Chevrolet for jet duty, the nose section was gutted and a sub-frame was built to compensate for the loosey-goosey front end.

Reuss says GM diesel plans are still on pace

General Motors is not going to let Volkswagen's diesel emissions scandal ruin its plans for a new line of efficient, torquey oil-burners, the company's Executive Vice President Mark Reuss said at a recent press event. "No way," Reuss responded when asked about cancelling the upcoming diesel-powered Chevrolet Cruze and other vehicles. "The Cruze Diesel is too good not to do it." Slated for 2017, the compact is just the latest member of a diesel offensive that initially kicked off with the first Cruze Diesel and most recently saw the introduction of the oil-burning Chevy Colorado and GMC Canyon. Reuss also reassured those in attendance that there was "no delay" in development of Cadillac's diesel lineup. Cadillac is working on a line of four- and six-cylinder turbodiesels for Europe. They'd make their way into the US market, too, eventually. "It's a question of timing," Reuss said, according to Car and Driver. Volkswagen's diesel emissions scandal has caused automakers across the globe to at least reanalyze their diesel strategy. Jaguar Land Rover, which is preparing several diesel-powered models for the US market, went on record late last month to reaffirm its commitment to diesel. Related Video: Featured Gallery 2014 Chevrolet Cruze Turbo Diesel: Quick Spin View 14 Photos News Source: Car and DriverImage Credit: Copyright 2015 Seyth Miersma / AOL Green Cadillac Chevrolet GM Diesel Vehicles

Chevy ramps up development of Bolt EV

The Bolt is on the move, and Chevy confirmed Wednesday it is testing more than 50 prototypes as it prepares to launch the electric vehicle in 2017. We've already seen the photographic evidence in these spy shots, but Chevy released its own images and the above video as further proof that the EV remains on track toward production. Chevy revealed the Bolt as a concept in January at the Detroit Auto Show, promising a range of 200 miles on electricity with a price tag of about $30,000 after possible incentives. The prototypes are being hand-built and tested at the General Motors Proving Grounds in Milford, MI, and other global locations. "Effectively these are the bones of the car that's going to be the production Chevy Bolt," said Josh Tavel, the car's chief engineer. Chevy is testing the Bolt in all areas of vehicle competence, including ride and handling dynamics, cabin comfort, quietness, charging capability, and energy efficiency. More than 1,000 engineers are working on the program. "We really wanted to convey the notion that this is running fast. It's happening," said Pam Fletcher, GM's executive chief engineer of electrified vehicles. The Bolt will be built at GM's Orion Assembly plant north of Detroit and sold in all 50 states. It's part of the automaker's electric car blitz that includes the plugin hybrid Volt, the traditional (non-plugin) Malibu hybrid, and confirmation of plans to expand sales of the Spark EV to Canada and Maryland. Related Video: