2006(06)monte Carlo Lt We Finance Bad Credit! Buy Here Pay Here Low Down $1199 on 2040-cars

Auto blog

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck

AEV-upgraded GMC Canyon AT4X, Chevy Colorado ZR2 appear in spy photos

As with the previous generation, it appears the 2023 Chevy Colorado ZR2 will be getting a special AEV version. Not only that, but its twin, the GMC Canyon AT4X will get one, too. And as these spy photos show, they'll have some additional off-road accessories included, as well as bigger tires. We'll start with the GMC Canyon. The first example of the truck without any camouflage is not quite fully upgraded like the camouflage vehicles. But it has one part not seen on the others: the AEV snorkel. 2023 Chevy Colorado ZR2 AEV Bison prototype View 13 Photos The two appear to be riding on larger Goodyear Wrangler Terrain MT tires. These look like 35-inch examples -- 2 inches larger than the biggest tires available on the ZR2 and AT4X. They're also mounted on beadlock capable wheels. Besides the bigger tires, both trucks also feature a new bed-mounted spare tire. It's a full-size spare, and unlike past bed-mounts, this one places the tire flush against the cab. The benefit of moving the spare to the bed is departure angle. And while this position looks a little less like how trophy trucks carry their spares, it should provide better cargo space. Rear visibility probably isn't great, though. Generalizing based on what we know about the current ZR2 Bison, the new AEV trucks will probably get unique grilles, steel bumpers, fender flares, a suspension lift and possibly even axle ratio changes. Additional options such as a winch could be offered, too. We expect the trucks will be revealed within the next year, since the base trucks have already been shown, and these are just upgraded versions of those trucks. Related Video: 2023 Chevrolet Colorado walkaround

GM won't really kill off the Chevy Volt and Cadillac CT6, will it?

General Motors is apparently considering killing off six slow-selling models by 2020, according to Reuters. But is that really likely? The news is mentioned in a story where UAW president Dennis Williams notes that slumping US car sales could threaten jobs at low-volume factories. Still, we're skeptical that GM is really serious about killing those cars. Reuters specifically calls out the Buick LaCrosse, Cadillac CT6, Cadillac XTS, Chevrolet Impala, Chevrolet Sonic, and the Chevrolet Volt. Most of these have been redesigned or refreshed within the past few model years. Four - the LaCrosse, Impala, CT6, and Volt - are built in the Hamtramck factory in Detroit. That plant has made only 35,000 cars this year - down 32 percent from 2016. A typical GM plant builds 200,000-300,000 vehicles a year. Of all the cars Williams listed, killing the XTS, Impala, and Sonic make the most sense. They're older and don't sell particularly well. On the other hand, axing the other three seems like an odd move. It would leave Buick and Cadillac without flagship sedans, at least until the rumored Cadillac CT8 arrives. The CT6 was a big investment for GM and backing out after just a few years would be a huge loss. It also uses GM's latest and best materials and technology, making us even more skeptical. The Volt is a hugely important car for Chevrolet, and supplementing it with a crossover makes more sense than replacing it with one. Offering one model with a range of powertrain variants like the Hyundai Ioniq and Toyota Prius might be another route GM could take. All six of these vehicles are sedans, Yes, crossover sales are booming, but there's still a huge market for cars. Backing away from these would be essentially giving up sales to competitors from around the globe. The UAW might simply be publicly pushing GM to move crossover production to Hamtramck to avoid closing the plant and laying off workers. Sales of passenger cars are down across both GM and the industry. Consolidating production in other plants and closing Hamtramck rather than having a single facility focus on sedans might make more sense from a business perspective. GM is also trying to reduce its unsold inventory, meaning current production may be slowed or halted while current cars move into customer hands. There's a lot of politics that goes into building a car. GM wants to do what makes the most sense from a business perspective, while the UAW doesn't workers to lose their jobs when a factory closes.