2014 Chevrolet Malibu 1lt on 2040-cars

Auto blog

AMC Trans Am Javelin SST, an ultra-rare underdog, is up for auction

Among the rarest of the American muscle cars that went racing in the early Seventies — cars including the Camaro Z/28 and the Boss 302 Mustang — the 1970 AMC Trans Am Javelin SST may be the most hard to find, and among the most valuable. Only 100 units of this unique Javelin were produced, and one of them is up for auction at the Mecum event in Dallas on September 20. The Trans Am Javelin was fashioned in a patriotic livery of tricolor paint — red, white and blue — and arrived after the American Motors Corporation had decided in 1968 to compete in the Trans Am racing series against Ford and General Motors. The company's chief driver, Mark Donohue, would dominate the 1971 season, taking seven wins in his Javelin AMX and that yearÂ’s SCCA Trans-Am Championship. AMC took the trophy with 82 points, well ahead of Ford's 61, Chevrolet's 17 and Pontiac's paltry 7. The example listed for auction came equipped with a 390-cubic-inch V-8 engine with 325 horsepower at 5,000 rpm and 420 pound-feet of torque, power steering and brakes, dual exhaust, BorgWarner four-speed manual transmission and Hurst competition shifter. Its “ram induction system” sealed a chamber around the air filter so that cool air from the functional hood scoop would be funneled into the intake. This JavÂ’s factory price was $3,995 — a mere $32,000 or so in today's money, though it was expensive by the standards of the time. The 100 Trans Ams were among 19,714 Javelin units built in 1970, so they started out rare, and today the surviving examples are highly collectible, if and when they come up for sale. No bid estimate is available yet. Related Video: Motorsports Chevrolet Ford Pontiac Auctions Automotive History Racing Vehicles Classics

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck

1970 Chevy Camaro gets 650-hp crate engine for SEMA

The latest edition of the Chevrolet Performance catalog arrives at the 2015 SEMA Show, and to demonstrate the insane creations that are possible with it, the company has a seriously powerful machine in tow. This custom 1970 Camaro RS boasts the new LT4 crate engine that makes a staggering 650 horsepower and 650 pound-feet of torque. The offering gives hot rod builders the ability to put the Corvette Z06's 6.2-liter supercharged V8 into any project where they can make the mill fit. This Hyper Blue Metallic Camaro should offer neck-snapping performance with its massively powerful engine and a T-56 Super Magnum six-speed manual gearbox. Chevy's show car is about more than just packing copious horsepower into a classic shape, though. The builders also overhaul the suspension with coilovers at the front and rear, in addition to a four-link setup at the back. Behind the 19-inch aluminum wheels, the coupe has Z06-based brakes at both ends. For better visibility, it wears LED headlights and taillights. Plus, the interior gets custom gauges and a six-point roll cage. With pieces like titanium intake valves and forged aluminum pistons, the LT4 crate engine comes ready to offer serious performance, but Chevy also gives builders a few options to fit their application. The mill is available with either wet- or dry-sump lubrication. Depending on the version, there are kits to fit front-end accessories, air conditioning, and power steering, as well. The new Chevy Performance catalog features other high-performance components like Z06-based parts for the standard Stingray and an array of performance upgrades for the 2016 Camaro, including suspension lowering kits, brake upgrades, and more. We look forward to seeing this vast collection of goodies at SEMA this year. Related Video: Classic 1970 Camaro Shows Supercharged LT4 Heart Contemporized muscle car highlights new Corvette Z06-based crate engine LAS VEGAS – Chevrolet Performance is showing off the new LT4 crate engine in the most attractive way possible – under the hood of a classic 1970 Camaro RS. The concept vehicle was introduced today at the SEMA Show, in Las Vegas. As the supercharged 6.2L heart of the Corvette Z06, the LT4 is rated at 650 horsepower and 650 lb-ft of torque, making it the most powerful production-vehicle engine ever from General Motors. The new crate engine – offered in dry-sump and wet-sump versions – allows builders to use the high-tech performance engine in their hot rod projects.