1981 Chevrolet Malibu Base Coupe 2-door 5.7l on 2040-cars

Auto blog

GM opens official investigation into C8 Corvette transmission leaks

In March 2020, a month after Chevrolet began customer deliveries of the 2020 C8 Corvette, a GM dealer technician created a Reddit thread about a leaking gearbox in a Corvette with 32 miles. That car hadn't even been sold yet. Since then, as a search of "C8 Corvette transmission leak" shows, it's been tales of woe for some owners. Something in the Tremec TR-9080 transaxle in the back of the mid-engined Corvette doesn't work as it should, the fault able to cause codes that the transmission needs service, or that the driver needs to shift to park. In some cases, the battery would die because of follow-on issues after the initial transmission code, that code preventing the car from powering down. As Autoevolution reports, GM filed paperwork with the National Highway Traffic Safety Administration in August to look into what's going on. Between forum threads and GM's investigation document, there are several issues mentioned. The most common appears to be the dual-clutch transmission leaking fluid due to gasket failures like the one suffered by one owner at 858 miles, and another for an owner currently enduring a second leaking transmission. The Midengined Corvette Forum reported that Chevy engineers redesigned the TR-9080 pan, fitting Corvettes with the new unit at some point in the 2021 model year. The original pan was stamped steel unit affixed to the engine with two studs and 13 bolts, plus "reinforcement plates." The updated pan is said to be a cast aluminum unit affixed with two studs and 17 bolts, omits the reinforcement plates, and gets a new machined new groove around its edge to seat the gasket seal. The GM paperwork now at the NHTSA mentions a P1789 code, and says one reason for it could be "debris on the park position sensor magnet causing an incorrect position reading to the TCM." This might be caused by another issue mentioned in forums, which is clogged transmission filters. GM gives instructions for returning transmission filters to the company, and a poster on one forum said the Corvette tech at the dealer where he bought his Corvette told him the automaker "requires every used transmission filter to be returned to GM."  Whatever's going on, the problems haven't stopped, and they go beyond the P1789 code. Over the weekend, a 2022 Corvette owner posted on Corvette Forums that he got a check engine light on his car after just 850 miles.

Callaway, Lingenfelter boost Corvette Z06 way beyond 700 hp

With 650 horsepower and just as much torque on tap, few would accuse the latest Corvette Z06 of being down on power. But for those who'll always demand more, two leading Corvette tuners have just announced new tuning packages for the Z06 to boost Chevy's flagship well beyond 700 horsepower. The more powerful of the two comes from Callaway Cars, which has added a larger supercharger, a triple-action intercooler, and more to increase output to a massive 757 horsepower and 777 pound-feet of torque. The result, according to Callaway, is a 0-60 time quoted at 2.8 seconds and a quarter-mile run in 10.5. The package also includes a reshaped hood, all manner of trim upgrades, and a three-year warranty, and will set you back nearly $17k on top of the cost of donor vehicle that currently lists for $79,000. In what could only come second relative to Callaway's kit, Lingenfelter Performance Engineering has also released a Stage 1 package for the Z06. The kit includes a new dry sump damper, upgraded supercharger pulley and drive belt, and more – all of which Lingenfelter says will boost the Vette's output up to 720 hp and 730 lb-ft. Revised performance figures weren't released, but despite the 37-horse, 47 lb-ft deficit, we doubt it'd trail Callaway's by much. But both would likely leave the stock Z06 in their dust, and you can read more about them in the press releases below. Related Video: Callaway Cars Releases Their Most Powerful Corvette - 757 bhp / 777 lb-ft - Z06-based Corvette upgrade boasts 32% larger supercharger, triple intercoolers, and consistent power - lap after lap The Numbers - Callaway Cars today announced power numbers and performance for the flagship model in their performance car lineup. Equipped with Callaway's GenThree Supercharger, the Corvette Z06 now produces 757 bhp @ 6,200 rpm and 777 lb-ft @ 4,500 rpm (SAE). A launch to 60 mph is now achieved in 2.8 seconds, and a quarter-mile in 10.5 seconds at 131 mph. Why Go Big, When You Can Go Bigger? - Size Matters. To reach that power (which is up from 650 bhp / 650 lb-ft) the supercharger itself needed to be bigger since the output of a positive displacement supercharger is proportionate to its size. The Callaway GenThree supercharger is 32% larger in displacement (2300cc vs 1740cc). Cooling - Callaway engineers recognize that a key contributor to maximizing power is reduction of inlet air temperature associated with forced induction.

A conversation with GM's Mark Reuss on MPG, aluminum and Corvettes

There was plenty to talk about when General Motors hosted its annual mid-December holiday media reception a few months ago. GM had just decided to pull its global Chevrolet brand out of major European markets, where Chevys have competed directly with GM Europe Opel and Vauxhall vehicles, and the US government had sold its last remaining shares of GM stock. But most important was the company's just-reshuffled leadership. Post-bankruptcy CEO Dan Akerson had announced that he would step aside and that 52-year-old Mary Barra would replace him on January 15. Not only would she be the first woman to lead a major automaker, she would also be GM's first engineer CEO since Bob Stempel in the early 1990s. "I look at 2013 and 2014, as the retooling of General Motors" - Mark Reuss Replacing her as executive VP for global product development (and purchasing and supply chain) would be 49-year-old Mark Reuss, who had served a stellar four years as North American president, and elevated to corporate president (from executive VP and CFO) would be 42-year-old Dan Amman. All three are relatively young auto enthusiasts who are liked and respected inside and outside the company, and their collective talents and experience are highly complementary. I've interviewed Barra and found her smart, personable and knowledgeable, though she carefully walks the corporate line in speaking and answering questions. I met and chatted with Ammann for the first time at that holiday reception, and he made a good first impression. But I've known Reuss for some time as a genuinely good guy and a highly capable and inspiring leader, and I believe he is exactly the right person for the global product responsibility once famously held by the outspoken, oft-controversial Bob Lutz. So I jumped at an opportunity to join a group interview of Reuss (with mostly business reporters) at the Detroit Auto Show in January. It was an interesting session of mostly good questions, which he answered with refreshing candor and humor. "I look at 2013 and 2014, as the retooling of General Motors," Reuss said. "We've taken down almost every plant in North America, converted and turned it this last year, and to do that with award-winning vehicles and pretty flawless launches is key. We have to keep the train rolling on great product, because the rest won't happen without the best product, period." A reporter asked whether GM was pushing big trucks, SUVs and Corvettes again because gas is cheap. "No," Reuss said.